Case study: Roots of equation (use any method under finding roots of equation) Problem: Mechanical engineers, as well as most other engineers, use thermodynamics extensively in their work. The following polynomial can be used to relate the zero-pressure specific heat of dry air, cp kJ/(kg K), to temperature (K): -0.99403 + 1.671 × 10 4T + 9.7215 × 10 *7² -9.5838 × 10 "T³ + 1.9520 × 10-4pt Determine the temperature that corresponds to a specific heat of 1.2 kJ/(kg K).

Case study: Roots of equation (use any method under finding roots of equation) Problem: Mechanical engineers, as well as most other engineers, use thermodynamics extensively in their work. The following polynomial can be used to relate the zero-pressure specific heat of dry air, cp kJ/(kg K), to temperature (K): -0.99403 + 1.671 × 10 4T + 9.7215 × 10 *7² -9.5838 × 10 "T³ + 1.9520 × 10-4pt Determine the temperature that corresponds to a specific heat of 1.2 kJ/(kg K).

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

MECHANICAL ENGINEERING UPVOTE WILL BE GIVEN. PLEASE WRITE THE COMPLETE SOLUTIONS LEGIBLY. SHOW THE STEP-BY-STEP PROCESS WITH SHORT COMMENT/EXPLANATION. ANSWER IN 4 DECIMAL PLACES. Two gaseous streams containing the same fluid enters a mixing chamber and leaves as a single stream. For the first gas the entrance conditions are A1=500 cm², v1=230 m/s, p1=1.60 kg/m³. For the second gas the entrance conditions are A2= 300 cm³, m2=8.84 kg/s, v2=0.502 m³/kg. The exit stream conditions is v3=130 m/s and v3=0.437 m3/kg. Determine the following: (a) the total mass flow leaving the chamber (kg/sec) (b) the velocity of the gas at 2. (m/sec)
THERMODYNAMICS (ALREADY ANSWERED IN BARTLEBY. PLEASE CHECK IF THEIR ANSWER IS CORRECT) UPVOTE WILL BE GIVEN. PLEASE WRITE THE COMPLETE SOLUTIONS/DIAGRAMS LEGIBLY. NO LONG EXPLANATION NEEDED. USE 3 DECIMAL PLACES. BOX THE FINAL ANSWER. A pump discharges into a semi spherical tank at the bottom and cylindrical on top with a radius of 2 meters, and a total tank height of 8 meters. The flow rate is 80 gallons per minute and fluid specific gravity= 1.1. Determine the following: A) flow rate in kg/sec and time it takes to fill the tank in hours. B) the weight in tons of the liquid if full tank local gravity is 32.1 ft/sec squared. C) volume of the tank in metric gallons. D.) how many drums will be needed to transfer all of the tank contents (tank being full) to the drums?
Heat Transfer (Multiple Choice) 1.) The quantity which determines the direction of heat flow. a.)Heat Flux b.)Temperature Difference c.)Velocity of flow d.)Prandtl Number 2.) Forced Convection formulas hold true only for values of a.) Re < 4000 b.)Diam. D>6m c.) Pr>1 d.)Nu<4000 3.) The analogy between Ohms Law and Fouriers Law is that voltage corresponds to a.)Conduction b.)Heat Rate c.)Temperature Difference d.)Heat Flux 4.)An expression for resistance in parallel is a.)R=1/Ra+1/Rb+1/Rc b.)R=RbRc+RaRc+RaRb/Ra+Rb+Rc c.)R=Ra+Rb+Rc/RbRc+RaRc+RaRb d.)R=RaRbRc/RbRc+RaRc+RaRb
Differantial Equations
THERMODYNAMICS UPVOTE WILL BE GIVEN. PLEASE WRITE THE COMPLETE SOLUTIONS/DIAGRAMS LEGIBLY. NO LONG EXPLANATION NEEDED. USE 3 DECIMAL PLACES. BOX THE FINAL ANSWER. A pump discharges into a semi spherical tank at the bottom and cylindrical on top with a radius of 2 meters, and a total tank height of 8 meters. The flow rate is 80 gallons per minute and fluid specific gravity= 1.1. Determine the following: A) flow rate in kg/sec and time it takes to fill the tank in hours. B) the weight in tons of the liquid if full tank local gravity is 32.1 ft/sec squared. C) volume of the tank in metric gallons. D.) how many drums will be needed to transfer all of the tank contents (tank being full) to the drums?
Differential equation THE LAPLACE METHOD CANNOT BE USED. When two springs in series, with constants k1 and k2 respectively,support a mass, the effective spring constant is calculated as:k = k1*k2 / k1+k2 A 420 g object stretches a spring 7 cm, and that same object stretches 2.8 cmanother spring. Both springs are attached to a common rigid support and then toa metal plate, as shown in the figure of springs in series. Then the object joins thecenter of the plate (figure of springs in series). Determine: (a) the effective spring constant.(b) the position of the object at any time t, if the object is initially releasedfrom a point 60 cm below the position ofequilibrium and with an upward velocity of 1.2 m / s.Consider the acceleration of gravity as 9.8 m / s2.
What would be the weight of one 3-kg mass on planet where the acceleration due to gravity is 10 m/s2? Select the correct response 3 kN 29.43 N 30N 13 KN An open tank contains 5.7 m of water covered with 2.8 m of kerosene. Find the pressure at the interface of the two liquids. Specific weight of kerosene is 8.0 kN/m^3. Select the correct response 22.400 55.917 44.000 33.240
Write the simplified ENERGY BALANCE equation for each process based on the givenconditions. Start from the general energy balance form, and arrive at the correct balance byexplaining any addition, deduction, or change in the equation.Use the following as subscripts in your answer: 1 = initial system state; 2 = final system state; i = inletstate, e = exit state.a. A rigid tank transferring heat to its surroundings. b. The seal of an insulated system with a high energy substance is broken, causing the contents tobe evacuated until only 20% of the initial internal energy remained. No heat transfer was detectedin the system’s boundaries. c. Consider a hydroelectric power plant operating in steady conditions, wherein the system consistsof two water reservoirs with a height difference Δz, with a Francis water turbine placed betweenthe stream connecting both.
A hot water leak in one of the faucets of your apartment can be very wasteful. A continuous leak of one quart per hour (a “slow” leak) at 155◦F causes a loss of 1.75 million Btu per year. Suppose your water is heated with electricity. Solve, a. How many pounds of coal delivered to your electric utility does this leak equate to if one pound of coal contains 12,000 Btu and the boiler combustion process and water distribution system have an overall efficiency of 30%? b). If a pound of coal produces 1.83 pounds of CO2 during the combustion process, how much extra carbon dioxide does the leaky faucet produce in a year?
1. The 1st Law of Thermodynamics gives any information on the feasibility of the change of stateor process. The Second Law of Thermodynamics provides the basis as to the probability ofdifferent processes.A. Both statements are correct.B. Both statements are incorrect.C. Statement 1 is correct while Statement 2 is incorrect.D. Statement 1 is incorrect while Statement 2 is correct 2. The ratio of Cp/R is dependent on the unit of the universal gas constant. Its parameters areindependent of temperature and depends on the value of the constant pressure.A. Both statements are correct.B. Both statements are incorrect.C. Statement 1 is correct while Statement 2 is incorrect.D. Statement 1 is incorrect while Statement 2 is correct. 3. A reconstruction has resisted the combined efforts of the government’s militaryestablishments. It can at best be accomplished by a hen fed with the remains of the original. Thisanalogy best represents the concept of ___________.A. Spontaneous ProcessB.…
APPLICATIONS OF FIRST ORDER DIFFERENTIAL EQUATIONS Newton’s Law of Cooling and Joint Proportions At 4:00pm, a thermometer reading of 28 deg C is taken outside where the ambient temperature is –11 deg C. At 4:05 pm, the thermometer reads 8 deg above zero. After a while, the thermometer is returned to the room maintained at 28 deg C. At 4:12pm, the thermometer reads 15 deg C. When was the thermometer returned to the room?
A physics lab consists of a large ball attached to a wire. Students hold on to one end of the wire, then whirl the ball around in circles and count the number of rotations per second. One group finds these numbers: ball mass= 320 gram, wire length= 1.3m, number of rotations/sec=2.5. The wire is made of steel with a diameter of 1mm and a Young's modulus of 20x10^10 N/m^2.How much does the wire stretch due to the tension on it? Should the students correct their data for the wire stretching?