A circuit is constructed with a 6.00 V battery connected across a 2500.0 2 resistor.Determine the number of electrons that flow through the circuit per second.electrons per second:Determine the number of moles of electrons that would flow through the resistor if the circuit is operated for 44.58 min.moles of electrons:Determine the number of joules produced if the circuit is operated for 44.58 min.joules produced:Determine the number of watts that would be produced from this circuit if the 6.00 V battery were replaced with a 828 Vbattery.watts produced:mcV

Voltage of the circuit , V = 6 V Resistance of circuit ,R = 2500 ohm We know from Ohm's Law V = I R…

circuit is constructed with a 6.00 V battery connected across a 2500.0 2 resistor. etermine the number of electrons that flow through the circuit per second. ectrons per second: etermine the number of moles of electrons that would flow through the resistor if the circuit is operated for 44.58 min. oles of electrons: etermine the number of joules produced if the circuit is operated for 44.58 min. e m

circuit is constructed with a 6.00 V battery connected across a 2500.0 2 resistor. etermine the number of electrons that flow through the circuit per second. ectrons per second: etermine the number of moles of electrons that would flow through the resistor if the circuit is operated for 44.58 min. oles of electrons: etermine the number of joules produced if the circuit is operated for 44.58 min. e m

Physics for Scientists and Engineers with Modern Physics

10th Edition

ISBN:9781337553292

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter26: Current And Resistance

Section: Chapter Questions

Problem 38AP

See similar textbooks

Similar questions

A close analogy exists between the flow of energy by heat because of a temperature difference (see Section 19.6) and the flow of electric charge because of a potential difference. In a metal, energy dQ and electrical charge dq are both transported by free electrons. Consequently, a good electrical conductor is usually a good thermal conductor as well. Consider a thin conducting slab of thickness dx, area A, and electrical conductivity , with a potential difference dV between opposite faces. (a) Show that the current I = dq/dt is given by the equation on the left: ChargeconductionThermalconductiondqdt=A|dVdx|dQdt=kA|dTdx| In the analogous thermal conduction equation on the right (Eq. 19.17), the rate dQ/dt of energy flow by heat (in SI units of joules per second) is due to a temperature gradient dT/dx in a material of thermal conductivity k. (b) State analogous rules relating the direction of the electric current to the change in potential and relating the direction of energy flow to the change in temperature.
Review. A rechargeable battery of mass 15.0 g delivers an average current of 18.0 in A to a portable DVD player at 1.60 V for 2.40 h before the battery must be recharged. The recharger maintains a potential difference of 2.30 V across the battery and delivers a charging current of 13.5 mA for 4.20 h. (a) What is the efficiency of the battery as an energy storage device? (b) How much internal energy is produced in the battery during one charge-discharge cycle? (c) If the battery is surrounded by ideal thermal insulation and has an effective specific heat of 975 J/kg C, by how much will its temperature increase during the cycle?
If electrical energy costs 0.12 per kilowatt-hour, how much does it cost to (a) burn a 100-W lightbulb for 24 h? (b) Operate an electric oven for 5.0 h if it carries a current of 20.0 A at 220 V?
Check Your Understanding Handheld calculators often use small solar cells to supply the energy required to complete the calculations needed to complete your next physics exam. The current needed to run your calculator can be as small as 0.30 mA. How long would it take for 1.00 C of charge to flow from the solar cells? Can solar cells be used, instead of batteries, to stall traditional internal combustion engines presently used in most cars and trucks?
Q1. How many electrons per second are necessary to produce 1.0 nA of current? (e = 1.60 × 10-19 C) Q3. A +7.5 nC point charge is 5.0 cm from a -9.4 µC point charge in your laboratory in California. How much work would you have to do if you left the +7.5-nC charge in the lab but took the -9.4 µC charge to New York City? If you then released the +7.5, how much KE would it have once it returned to Cali? 3 parallel + 1 in series – Find Req Q5. How would you reduce Req of a circuit by adding a resistor – numerical piece to follow.
How many electrons move through a headlight each second? When a 12.0 V car battery runs a single 30. 0 W headlight, how many electrons pass through it each second? Discussion.
A typical lightning bolt may last for 0.200 s and transfer 1.00 x1020 electrons. Calculate the average current in the lightningbolt.
A 18.0 V car battery runs a single 50.0 W headlight, how many electrons pass through it each second?
1. If electricity costs 15 Bz per kilowatt-hour, how much does it cost to operate a 220 V water heater that draws 5 A of current for 3 hours per day for a month of thirty days? The Total Electrical energy consumed for a month = kwh and the Total cost of electricity consumption = riyal 2. If current of I = 3.00 A flows through a wire, How many number of electrons flow through a point in a wire in 3.00 s ? Number of electrons flow through a point in wire in 3.00 s = electrons
1. Calculate the number of free electrons in a copper conductor having a diameter of 0.064in and a length of 1000ft. 2. A current of 5A exist in a 10ohms resistance for 4 minutes. A) How many coulombs B) How many electrons pass through any section of the resistor in this time? Charge of e= 1.6x10^-19. 3. The electric charge that moves through a conductor varies in accordance with the equation q=800t, where q and t are given in coulombs and milliseconds, respectively. Calculate the current in Ampere. 4. Determine the total charge entering a terminal between t=2s, if the current passing the terminal is I= (3t^2-t)A
A 220. V potential difference is applied to a space heater that dissipates 440. W during operation.(a) What is resistance during operation?(b) At what rate do electrons flow through any cross-section of the heater element? (c) The space heater has a resistance of 27.5 Ω at 25.0 °C and the temperature coefficient of resistivity is α = 4.50x10^-3 °C^-1. What is the temperature of the space heater internal elements?
A heart defibrillator passes 12.5 A through a patient's torso for 5.00 ms in an attempt to restore normal beating. How much charge passed through the torso? charge: C What voltage was applied if 535 J of energy was dissipated by the current in the patient's body? voltage: V What was the effective resistance of the patient's torso? effective resistance: Ω Find the average resulting temperature increase of the 7.25 kg of affected tissue. Assume that the human body has a specific heat of about 3.50×103 J/(kg·∘C) . average resulting temperature increase: