Coiling a rope A 60-m-long, 9.4-mm-diameter rope hangs freefrom a ledge. The density of the rope is 55 g/m. How much workis needed to pull the entire rope to the ledge?

The given data are listed below with appropriate variables. Here, L denotes the length, d denotes…

Answered: Coiling a rope A 60-m-long,…

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter15: Fluids

Section: Chapter Questions

Problem 9PQ

See similar textbooks

Similar questions

Review. A mixing beater consists of three thin rods, each 10.0 cm long. The rods diverge from a central hub, separated from each other by 120, and all turn in the same plane. A ball is attached to the end of each rod. Each ball has cross-sectional area 4.00 cm2 and is so shaped that it has a drag coefficient of 0.600. Calculate the power input required to spin the beater at 1 000 rev/min (a) in air and (b) in water.
A non-homogeneous bar is 50 cm long and its linear density is given by the function λ(x)=32 + 25x² , where x is the position of the bar from one end, where λ is given g/m (grams per meter). a) Draw a sketch of the bar and mark where on the bar its center of mass is locatedb) Calculate the total mass of the rod.
I’m stuck here I need to learn how to work on it please I need si know how the point goin
A 3.0-m-tall, 50-cm-diameter concrete column supports a 200,000 kg load. By how much is the column compressed?
A lightweight rope is wrapped around a 1780-N drum, passes over a frictionless pulley, and is attached to a weight W (see figure). The coefficient of friction between the drum and the surfaces is 0.50. Determine the maximum amount of weight that can be supported by this arrangement.
Windmills slow the air and cause it to fill a larger channel as it passes through the blades. Consider a circular windmill with a 7-m-diameter rotor in a 8 m/s wind on a day when the atmospheric pressure is 100 kPa and the temperature is 20°C. The wind speed behind the windmill is measured at 6.5 m/s. Determine the diameter of the wind channel downstream from the rotor and the power produced by this windmill, presuming that the air is incompressible.
Your biceps muscle is attached to your elbow by the distal biceps tendon. An average adults tendon has a 6 mm by 3 mm rectangular cross-section and is 63 mm in length. A tendon has a Young’s modulus of 1.5x10^9 N/m^2. How much work must be done to stretch the length of the distal biceps tendon by 10%? Assume that the tendon is a linearly elastic material and that stretching does not alter it’s cross-section.
Consider a Hot Wheels™ car with a mass of 121 g, that is pushed by a student along a track so that it is moving at 5 m/s. It hits a spring (k = 92.5 N/m) at the end of the track, causing it to compress. How far did the spring compress to bring the car to a stop? Calculate the answer in cm and make sure to include the unit. Report your final answer with three significant figures.
Steel ball with radius of 0.03 m lays on a bottom of the lake 5 m deep. What work is needed to lift the ball to the surface of the lake? Density of steel is 7860kg/m3. The volume of a sphere is Use g = 9.8 m/s2 Calculate answer to two decimals.
The Achilles tendon connects the muscles in your calf to the back of your foot. When you are sprinting, your Achilles tendon alternately stretches, as you bring your weight down onto your forward foot, and contracts to push you off the ground. A 70 kg runner has an Achilles tendon that is 15 cm long with a typical 1.1 x 10-4 m2 area.a. By how much will the runner’s Achilles tendon stretch if the maximum force on it is 8.0 times his weight, a typical value while running?b. What fraction of the tendon’s length does this correspond to?
A high jumper, falling at 4.0 m/s, lands on a foam pit and comes to rest, compressing the pit 0.40 m. If thepit is able to exert an average force of 1200 N on the high jumper in breaking the fall, what is the jumper'smass? (60 kg)
1.Four identical textbooks, each of length L, are stacked near the edge of a table, as shown in Figure 9–28. The books are stacked in such a way that the distance they overhang the edge of the table, d, is maximized. Find the maximum overhang distance d in terms of L. In particular, show that d > L; that is, the top book is completely to the right of the table edge. (In principle, the overhang distance d can be made as large as desired simply by increasing the number of books in the stack.

SEE MORE QUESTIONS

Recommended textbooks for you

Physics for Scientists and Engineers: Foundations…

Physics

ISBN:

9781133939146

Author:

Katz, Debora M.

Publisher:

Cengage Learning

Physics for Scientists and Engineers, Technology …

Physics

ISBN:

9781305116399

Author:

Raymond A. Serway, John W. Jewett

Publisher:

Cengage Learning

College Physics

Physics

ISBN:

9781938168000

Author:

Paul Peter Urone, Roger Hinrichs

Publisher:

OpenStax College

Physics for Scientists and Engineers: Foundations…

Physics

ISBN:

9781133939146

Author:

Katz, Debora M.

Publisher:

Cengage Learning

Physics for Scientists and Engineers, Technology …

Physics

ISBN:

9781305116399

Author:

Raymond A. Serway, John W. Jewett

Publisher:

Cengage Learning

College Physics

Physics

ISBN:

9781938168000

Author:

Paul Peter Urone, Roger Hinrichs

Publisher:

OpenStax College

Principles of Physics: A Calculus-Based Text

Physics

ISBN:

9781133104261

Author:

Raymond A. Serway, John W. Jewett

Publisher:

Cengage Learning

University Physics Volume 2

Physics

ISBN:

9781938168161

Author:

OpenStax

Publisher:

OpenStax

University Physics Volume 1

Physics

ISBN:

9781938168277

Author:

William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:

OpenStax - Rice University

SEE MORE TEXTBOOKS

Coiling a rope A 60-m-long, 9.4-mm-diameter rope hangs free from a ledge. The density of the rope is 55 g/m. How much work is needed to pull the entire rope to the ledge?