Colculate the average power

Q: Part 1: Computed Values For this part of the experiment, calculate the data needed in the table…

A: When frequency increases,  the inductive reatance Increases because it is directly proportional to…

Q: Which values of current and voltage will give the maximum power? O a. 79 mA, 2.0 V b. 41 mA, 2.2 V…

A: Given values of current and voltage from each options, I=79 mA, V=2 V I=41 mA, V=2.2 V I=59 mA,…

Q: Pcoil - At 60 Hz frequency, switch the SW to other pole to terminate the Rin the circuit. Measure…

A:

Q: H.W. (1): Calculate the total impedance of the circuits of Fig. 36. Express your answer in…

A:

Q: b) Use Karnaugh maps to simplify the following Boolean functions expressed in the sum of minterms. f…

A: Given Boolean function, fw,x,y,z=∑1,2,4,5,6,7,9,12,13

Q: Calculate the Capacitive Reactance (Xc) of the circuit of Figure 7 below: 100,000 a R1 240 V .1 uF…

A: Given data,

Q: Find the currents and Voltage of the circuit( V1,V2,V3,V4) ( I1, I2,I3)

A: In this question we need to find the currents and Voltage of the circuit( V1,V2,V3,V4) ( I1, I2,I3)

Q: *******: For the periodic sequence (n) shown below, determine the Fourier series coefficents wwwnn…

A:

Q: 14. A voltmeter with high internal resistance is more accurate than with low internal resistance? A)…

A:

Q: if you design differentiator to differentiate input signal varies in frequency between 1 KHz and 20…

A: The differentiator is an electronic circuit that differentiates the given input signal. The…

Q: Consider the op amp circult below. You can assume the ampliffer is Ideal. ic R Vout a) If vin = 3 V…

A: The op-amp circuit is shown below, Assuming that the operational amplifier is ideal. We can see…

Q: In step-down regulator in Figure below, calculate the output voltage if the switching frequency is…

A: Given  A step down regulator, switching frequency and discharging time.we need to determine the…

Q: Using Ohm's Law, determine the amount of current the ammeter in the circuit of Figure 1 below will…

A: Ohms law state that when a voltage source is applied across the elements which injects a current…

Q: If you have a system with a quantizer of 8V & 4 bits resolution, show the following: 1. howmany…

A:

Q: #2 - For the previous problem, if the motor turns on wher the voltage across it is 80% of the…

A:

Q: For the list of degrees below: name degree Ahmed 66 Ali 90 Mona 45 Salma 76 Karim 78 Use…

A: Given:

Q: What is the impedance of a 50uH inductor at f=10,000HZ? O jo.5 O jo.318 j2 O j3.14

A: Given, AN inductor with Inductance, f=50 μH Frequency, f=10000 Hz

Q: Root locus Control system Define following terms: - Z, P, gain margin, and phase margin

A: Here are the following terms related to the root locus diagram of any transfer function of a control…

Q: The peak-to-peak alternating potential difference across a 150 Q resistor is 339 V. The r.m.s.…

A: Given, The peak to peak A.C. voltage, Vp-p=339 V                                 Peak voltage,…

Q: H.W. (2): For the circuit of Fig. 37. a. Find the total impedance Z, in polar form. b. Draw the…

A:

Q: Control system terms: - a) Define following N, Z, P, gain margin, and phase margin

A:

Q: The voltage regulation can be equal to zero :when .The t and current is not too highO .The p.f. is…

A:

Q: Q5/ a) Define following terms: - N, Z, P, gain margin, and phase margin Control system

A: Through these definitions we are having the basic understanding of the Control system , in this…

Q: 3. Consider the causal system function H(z) = (1 – įz-1)(1+3z-1) (a) Find the step response of the…

A:

Q: a. Find the current ic for the circuit in Fig. 12. b. Sketch the Vc and ic curves and phasor…

A:

Q: A3 Two coils A and B have, initially, a mutual inductance of 250 mH, and the current in coil A is 2…

A: In this question we need to find a average value of induced voltage in coil B during 0.2 sec period

Q: rectangular values is equivalent to the polar form

A:

Q: Calculate the overall circuit current.

A:

Q: A GSM1800 cell tower antenna is transmitting 20W of power in the frequency range of 1840 to 1845MHZ.…

A: Given  Two multiple choice question on array concept. Please find the below attachment for clear…

Q: b) If ß=-0.015 and A =-5×10“, determine the closed-loop gain Ar.

A: Closed loop gain = A/(1+A*bita) Here all A and bita are given.

Q: A 3-phase 50 Hz I.M. has a rated torque = 16.7 N.M and maximum torque = 40.5 N.M. If its rated speed…

A: Induction machine is a singly excited machine in which rotating magnetic field is generated by input…

Q: 2. A DC motor with an internal resis power supply source of 12 V. The speed of the motor at +1rpm…

A: We need to find out speed

Q: What are factors which overall gain depends on ? What is integrator ? explain briefly

A: Application of op Amp Integrator circuit  Differentiator circuit Summer Current to voltage…

Q: the question points just 3 not four ( 8, 1.5, 7) and second point too is (8, 9.1, 7) so could you…

A:

Q: n source transformation theorem, what kind of sources that can be t O a. Independant and dependant…

A:

Q: Quiz The parallel- plate capacidor Shown below is quarter fitledwith of figure mica Cerz6). Find the…

A: Capacitance will be in parallel when their area and distance between plates is same Voltage across…

Q: Q1 With a constant input voltage of 17 V, the load resistance in Figure below is varied from 1 kl to…

A:

Q: 10. For the circuit in Fig. 15.129: a. Find the total impedance Z, in polar form. d. Find the…

A: As per the guidelines of bartleyby I need to answer first three subparts only so kindly repost other…

Q: b) Consider the parallel RLC circuit as shown in figure1, let R=Xk2 ,L=0.2mH and C=8µF.Calculate:…

A:

Q: 3. Consider f(r) = e", 0<x < T. (a) Find the half-range Fourier sine and Fourier cosine expansions…

A: Given  3. Consider f(x) = e^x , 0&lt;x&lt;pi   (a) Find the half-range Fourier sine and Fourier…

Q: Questions are based on this transfer function. 400 G(s) = s2 + 12s + 400

A:

Q: own opinion, What 3 characteristics/features of microprocessor that future designers should focus…

A: In these days microprocessor are extensively used in almost every electronics gadgets .And in order…

Q: Determine the value of voltage vs. 5Ω 1: 0.3 120 V Vs 10Ω RMS 612 V RMS o 418 V RMS O 324 V RMS O…

A:

Q: A 55 hp, 440 V, 400 rpm DC shunt motor draws 107 A when operating at rated conditions. The motor has…

A:

Q: An air-filled rectangular waveguide has dimensions of 6 x 4 cm. Its cut- off frequency for the TE10…

A:

Q: Q5: Use a Karnaugh map simplify the Boolean function FA.B,)-Σ m(0,1,2,3,4,5)

A: Given, Boolean function FA,B,C=∑m0,1,2,3,4,5

Q: An air-filled rectangular waveguide * has dimensions of 6 x 4 cm. Its cut- off frequency for the…

A:

Q: If the probability of a message is 4, then the information in bits is? 1 bit (a) (b) (c) (d) 2 bits…

A: Given: The probability of a message signal, P = 14

Q: Determine the power R XL factor and the true power (average power) in the shown circuit: ell 2 kfl…

A:

Q: How is installed Alvoltaimitr to measure the voltage at both ends of the resistance R3, R4 and how…

A:

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.