Computational issue: A series RC circuit contains a resistor ofR = 15kn, a capacitor of C = 0.30µFand a battery of ɛ = 9.0V.Starting at t- 0, when the battery is connected, determine thecharge Q on the capacitor and the current I in the circuitfrom t-0 to t - 10ms (in intervals of 0.1ms). Plot graphsshowing how charge Q and current I vary over time withinthis range. From the graphs, find the time when the loadreaches 63% of its final value, Cɛ, and the current drops to37% of its initial value, ɛ/R.%3D

In the question, R= 15k ohm and capacitor C= .30uF are connected to series with emf = 9V. Draw the…

Computational issue: A series RC circuit contains a resistor of R - 15ko, a capacitor of C - 0.30µFand a battery of ɛ - 9.0V. Starting at t - 0, when the battery is connected, determine the charge Q on the capacitor and the current I in the circuit from t-0 to t %3D 10ms (in intervals of 0.1ms). Plot graphs %3D showing how charge Q and current I vary over time within this range. From the graphs, find the time when the load reaches 63% of its final value, Cɛ, and the current drops to 37% of its initial value, ɛ/R.

Computational issue: A series RC circuit contains a resistor of R - 15ko, a capacitor of C - 0.30µFand a battery of ɛ - 9.0V. Starting at t - 0, when the battery is connected, determine the charge Q on the capacitor and the current I in the circuit from t-0 to t %3D 10ms (in intervals of 0.1ms). Plot graphs %3D showing how charge Q and current I vary over time within this range. From the graphs, find the time when the load reaches 63% of its final value, Cɛ, and the current drops to 37% of its initial value, ɛ/R.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A resistor (5 Ω) and capacitor (0.05 F) are joined in series with an electromotive force E(t) = 30 −t V. If there is nocharge on the capacitor at time t = 0, find the ensuing charge on the capacitor at time t. The following lineardifferential equation models the charge on the capacitor, q(t). (check the image) How do I go about solving this?
The expression for capacitor voltage in an RC circuit (assuming no initial charge) when DC voltage is applied is ??(?) =?s (1 - ?− (t ⁄??) ) Assume Vs = 10 V, C = 50 ??, and R = 100 . Calculate capacitor voltage when t = : 1*RC _____ 5*RC _______ 10*RC ______ 2. The voltage across an inductor when a DC voltage is switched on is ?? (?) ??− ( t ⁄ ?⁄? ). Assume Vs = 10 V, L = 1 mH, and R = 1 Ohm. Find the voltage across the capacitor at t = : 0 ms __________ 1 ms __________ 10 ms __________ Derivation: Consider the equation for ? : ?? = √(1⁄??) − (?⁄2?)2 Oscillation will occur only when this expression is a real number (not an imaginary number). Solving, we see that the expression is a real number when (1 ⁄??)> (?⁄ 2? )2. If C = 0.01 uF capacitance and L = 10 mH, what is the largest value of R for this condition to be true?
16. Consider a simple RC circuit which has a resistor of 2 ohm and capacitor of 3F. If the initial voltage is 12V then find the charge q(t) is expression. 17. Suppose we have a RC circuit with an alternating voltage V(t) = V_{m} * cos(5t) If the initial voltage is 4V and the resistor has a resistance of 8 ohm and the capacitor is of capacitance 2F then find the charge for the circuit ?
In an experiment to investigate the discharge of a capacitor through a resistor, the circuit shown below was setup. The battery has an EMF of 10V and negligible internal resistance. The switch was first closed, and the capacitor allowed to charge fully. The switch was then opened (at time t = 0)and the graph below shows how the millimeter reading subsequently changed with time. Using the graph below, Calculate the value of the resistance R. Estimate the charge stored on the capacitor at the start of the discharge process. Find the energy stored at the start of the discharge. Calculate the capacitance C, of the capacitor. What would be the effect on the shape of the graph if the value of R where increased.
The current, i, through a capacitor depends on time, t, and is given by where V is the voltage across the capacitor and C is the capacitance of the capacitor. Derive an integral expression, in terms of i and C, for the voltage V A capacitor of capacitance 3 x 10-2 F has a current i(t) through it where Determine the function for the voltage across the capacitor The change in current through a semiconductor diode depends on the applied voltage and is given by: where: V = applied voltage (V) I = diode current (A) Is = reverse saturation current (A) T = temperature (K) q and k are constants Given that when V = 0, I = 0 find an expression for the current with voltage. The reverse saturation current for a particular diode is 1 x 10-9 A and at 300 K 40. Write down an expression for the current and find the value of the current when V = 0.35 volts.
The equation for the voltage ?(?) across a capacitor at time ? is?(?)=1?(∫?(?)???0+?0)Where ?(?) is the current passing through the capacitor, and ?0 is the initial charge. Consider a capacitor with ?=1?? and ?0=0. If ?(?)=0.1(0.2+sin0.5?) A, find ?(?) for ?=0.5 sec.
Ex : For the circuit shown in the figure below : 1. Find the mathematical expression for the transient behaviour of the voltage across the capacitor as well as the current of the capacitor if the capacitor was initially uncharged and the switch is closed at position 1 when t - o sec . 2. Find the mathematical expression for Vc and is if the switch is moved to position 2 at t = 10msec . 3. Find the mathematical expressions for Vc and ic if the switch is moved to position 3 at t = 20msec 4. Plot the waveforms of the Vc and is obtained from the parts 1 to 3 . R ic 20 kΩ 20 E 12 V C 0.05 uF vc R , 310 ΚΩ T
2. A parallel plate capacitor with a plate area of 0.13 square meters separated by 1 mm is charged to 9 Volts by a battery, which is then disconnected. The plate separation is then increased to 40 mm.A. Using the expression for the capacitance of a parallel plate capacitor, what do you expect the new potential difference across the plates to be after the increase?B. Suppose you measure the potential difference across the plates after the separation and find it to be 30 V (this should be very different from what you found in part A). This unexpected result can be explained by the effects of “stray capacitance” with nearby objects. Assuming that the stray capacitance can be modeled as a capacitor connected in parallel with the parallel plate capacitor, find the value of this stray capacitance.
the emf source, E=3.2 V, of the circuit shown in the figure has negligible internal resistance. the resistors have resistances R1=3 ohm and R2=4.2 ohm. the capacitor has a capacitance C= 3.1uF. A) determine the time constant t , in units of microseconds for charging the capacitor. B) what is the charge Q on the capacitor in units of microcoulomb?
Consider the circuit above. The switch has been closed for a very long time before opening at t=0s. Determine the Inductor current (in amperes) right after the switch has been opened, the time constant of the circuit for ?>0 (in ms), and the Expression for the inductor current for ?≥0.
Referring to the figure shown, if E=240V, Rs=30k-ohms, Rp=50k-ohms and C=40 micro-farad:(a) To what voltage will the capacitor be charge if the switch is closed for a comparatively long time?(b) Assuming an initial capacitor voltage as in (a) what will be the instantaneous potential ec 1 second after the switch is opened?(c) Assuming the switch to be opened at the instant the capacitor potential reaches the voltage determined in (b), what will be the value of ec 0.5 second after the switch is closed
A capacitive sensor consists of two parallel plates in air. the plates being (40 mm ) square and separated by a distance of(1mm) . A sheet of dielectric material of thickness (1mm ) and (40 mm) square can slide between the plates. The dielectric constant of the materialis (9) and that for air may be assumed as (1) . Determine the capacitance of the sensor when the sheet has been displaced so that only half of itis between the capacitor plates Knowing that the permittivity of free space (8 .85 pFim).