Consider a cellular tower with Pt=10W, Gt=10 dBi, Gr=3 dBi, and L=0 dB, a. At 4000 MHz compute the diffraction loss for the problem shown above.     b. Calculate the total received power including the effects of the obstruction assuming free space propagation in the absence of the obstruction.

Q: Draw block diagram /circuit diagram of the ff. FM circuits and discuss the operation.  b. FOSTER…

A: According to the question, we need to discuss FOSTER SEELEY DISCRIMINATOR.

Q: Design a 15v full wave power supply that will deliver a 1.5A of DC current to a load of 1kohms

A: In this solution we discusses about Design of a 15v full wave power supply that will deliver a 1.5A…

Q: Ampere's creultal law -0 Air gap H- 7.06 x 10 n, 11-91- NIII Letter Capital Alpha Beta a) Find the…

A:

Q: 220Vrms, 3-Ph, Y-connected symmetrical positive sequence source is connected to 21+J24Q/Ph,…

A: In this question we need to find a average power absorbed by the load

Q: Consider a stable LTI system with input x(n) and output y(n). The zero-pole pattern of y(n) consists…

A: In this question we need to find system function and the system impulse response.

Q: what is the working principle of WDM?

A: wavelength-division duplexing(WDM): WDM is a method that multiplexes a no. of optical carrier…

Q: Draw block diagram /circuit diagram of the ff. FM circuits and discuss the operation.  1.FM…

A:

Q: Given the analog signal x(t) = sin(480πt)−3sin(720πt) that is sample at 600 times per second, what…

A:

Q: 4,1 ka 4.1 ka 20 k2 20 k2 20 ka 0.05 uF 10 k2 c0.02 µF

A:

Q: Compute for the Frequency Resonance of the Circuit

A:

Q: Three-phase transmission line 90 km long Line impedance z=(0.4+j0.88) ohm/km, Y=j5*10^- 6 S/Km,lf…

A:

Q: 10 2 -j4 2 ww o a 20/0° V js 2 4/0° A 42 b. 3. Find the Norton equivalent at terminals a-b of the…

A:

Q: If a converging lens has a focal length of 20 cm, at which object distance will an image larger than…

A: The solution is provided in the following section.

Q: *36. For the network of Fig. 4.136, determine: a. Ig. b. Ic. c. VCE- d. Vc *37. For the network of…

A:

Q: • 1. Determine the equivalent impedance and the equivalent admittance. 2n -j40 Zeq jon -jsn

A: In this question,   We need to Determine the equivalent impedance and the equivalent admittance.

Q: 1-(3coswo)z 1 1-(2coswo)z-1+9z-2 X(2) for the sequence x(n) =(3" coswon)u(n) is

A:

Q: 3 2 -1 -2 -3 0.5 1 ·10-2 (u)x (?)"x

A: We need to find out sampling rate for given signal

Q: Given the image below, if it is from 0≤t≤10 ms, what is the sampling rate? choose one a.30 Hz b.25…

A: Sampling rate must be greater than twice the signal frequency to remove the problem of aliasing.

Q: Discuss the Basic Operation of the PLC (Programmable Logic Controller)

A: PLC (Programmable Logic Controller) basic operation: Programmable Logic controls are used to…

Q: An automatic pressure control system measured the output as 8 psi. If error signal is 5 psi, such…

A: In this question we need to choose a correct option

Q: Design the circuit shown so that ve(t) =+ 1 +Aje-21 +Aze- V for t>0 Determine the values of the…

A:

Q: Transformer 1 80KVA 2,300:230 v Ze"=0.0113+j0.0207 ohm   Transformer 2 50 KVA 2,300:230 v.…

A: GivenTransformer 180 kVA2300V:230VZe''=0.0113+j0.0207 ΩTransformer 250 kVA2300:230…

Q: An op-amp circuit has a desired  closed-loop voltage gain of 10. If the input resistor to the…

A:

Q: 3.22 i (a) A flux density field is given as F1 = 5a:. Evaluate the outward flux of F1 through the…

A:

Q: 50. Find the rms value of the periodic waveform in Fig. 101 over one full cycle. I ycle 6 7 $ 9 D 11…

A: We need to find out RMS value for waveform .p

Q: (b) Determine the Z-transform and Region of Convergence (ROC) of: x[n] = {2,0, 2, 2,3, 0,0, 4}, n =…

A:

Q: Design a transistor switch that is powered by 5v Vcc, with RL of 1k ohms, using a transistor with ß…

A: A transistor is a three-terminal semiconductor device, which can be used as an amplifier , as a…

Q: (b) Two three-phase, 6.6-kV, Y-connected synchronous generators, operating in parallel, supply a…

A:

Q: 2. Determine the Thevenin's and Norton's equivalent circuits. 20V V(t + 102 ()5A ob

A: In this question,   We need to determine the Thevenin equivalent and Norton equivalent?

Q: Determine i using superposition theorem.

A:

Q: Discuss two ways of starting a single-phase induction moto

A: Single Phase Induction Motor: Single-phase induction motors are constructed in the same way as…

Q: 4,1 ka 4.1 ka 20 k2 20 k2 20 ka 0.05 uF 10 k2 c0.02 µF

A:

Q: Apply the waveforms of Figure to the inputs of the 74ALS138 DEMUX as follows: D -> AO, C-> A1, B->…

A: Given the circuit, as shown below We need to apply the waveforms to the inputs of the 74ALS138 DEMUX…

Q: Speed control of slipring Induction Motor. MCB Instruction SN Ammeter WattMeter Speed 1 2.6 2 2.9 3…

A: Induction motor- The induction motor is define as the AC operated electric motor. In which the…

Q: X(2) TOn the sequence x(n) = 2" u(-n – 1)-)" u(-n - 1) is- -1,5z (-2)(x

A:

Q: For the network function T(s) = the resonant frequency and s +2s +100 bandwidth are respectively.

A:

Q: 1-(3coswo)z1 1-(2coswo)z-1+9z-2 X(2) for the sequence x(n) =(3" coswon)u(n) is

A: It is given that: xn=3ncosωonun

Q: n a superheterodyne receiver, why is it important to convert the RF Signal to IF Signal before…

A: Superhetrodyne Receiver :It is a radio receiver which consists the frequency level which is the…

Q: For the combinational network of BJT and JFET, determine Vos 916 V IDss=6 mA Vos Vp = -6.0 V Ver…

A: We need to find out voltage for given circuit

Q: Given, r(t) = 3t^2, therefore its laplace transform is O a. 6/ s^3 O b. 6/ s^2 Oc 3/s^2 O d. 8/ s^3

A:

Q: |০ 0 । ।। uninin shwt -snwet sh wet sin wet sh wt anwt Fig1 Refer to Fig 1. The output data of a…

A: Given, Modulated signal is

Q: v(t) = 10cos(1000t + 90°) transform it to ser A 10290° B 1020° C 1000290° 100020°

A: Explanation is in step-2

Q: Solve the following problems below. Show complete solution.   1. A CFL or compact fluorescent lamp…

A:

Q: Convert the quantities (112 + j40) and (9 - j16) to polar form, multiply them and reconvert the…

A:

Q: I. An LED (Light Emitting Diode) operates a. In the reverse- bias b. in the forward bias II. A Zener…

A:

Q: transformer is reconnected as a step-down 550/440 V autotransformer. Determine (a) current in the…

A: The solution is given below

Q: Stepper motors are used to drive the two axes of a component placement machine used for electronic…

A: Stepper Motor: A stepper motor is an electric motor whose fundamental feature is that its shaft…

Q: Calculate the closed-loop voltage gain, ACL, of an inverting op-amp circuit having an input…

A:

Q: What do you think are the advantages of PLC over other control systems?

A: PLCs are more advantageous than other control system in many ways.

Q: 2. How is transformer insulation divided? Briefly indicate the insulation arrangement indicating the…

A: Transformer insulation need to withstand very high impulse voltage.

Antenna Characteristics

The antenna is an important concept in the domain of electronics and communication engineering. An antenna forms an integral part of many commonly used devices such as wireless modems, routers, game controllers, mobile phones, bluetooth devices, and so on. In simple terms, any wireless communication makes use of antennas to serve the purpose. An antenna, also known by the term 'arial', is an electrical device that converts electrical signals into electromagnetic waves or electromagnetic waves into electrical signals. An antenna contains a transmission line usually made up of co-axial cable, it then receives the signals and converts them into electromagnetic waves, which are then transmitted via space into their required destination. A communication system essentially makes use of two antennas, a transmission antenna, which converts electrical signals into electromagnetic waves, and a receiving antenna, which receives the electromagnetic waves and converts them back into electrical signals.