Consider a class C network with the subnet mask 255.255.255.41. How many network id (NID) and host id (HID) are there in the subnet mask? (A) 24, 3 (В) 24, 5 (С) 20, 6 (D) 20, 8
Q: In NAT, how does an IP gateway ensure that outgoing traffic can traverse public networks?a. It…
A: Answer: d. It replaces each outgoing packet's source address field with a public IP address.
Q: 3.1 An end device was given the IP address of 198.168.4.35/28. Consider this address and indicate:…
A: In this question, we have given an IP address and we have to find out the network ID , network…
Q: The following diagram shows a typical "Address spoofing." Answer the following questions based on…
A: IP address spoofing is the creation of Internet Protocol (IP) packets with a false source IP…
Q: This is Networking subject, Fixed length subnet mask (FLSM) Subnetting in IPv4 Network design…
A: Suppose an IPv4 network 172.30.0.0/16.Subnet Mask : 255.255.0.0 because /16 is given IP Address =…
Q: Suppose that the two-layer fully connected network pictured below is trained with a batch size of 3.…
A: Answer: Given Batch size =3 and Input(i)=3072 Hidden layer(h)=100 and output(o)=10
Q: Consider a class C network with the subnet mask 255.255.255.41. How many network and host id (HID)…
A: The answer is...
Q: Based on the information in the graph, we need to design a network addressing scheme that will…
A: Given Data : Number of subnets = 3 Host for subnet = 24 , 60 , 15.
Q: 4.03-2. Network Address Translation (b). Consider the following scenario in which host 10.0.0.1 is…
A: Answer: Given host :10.0.0.1 and IP :128:119:40:186
Q: Consider transferring an enormous file of L bytes from Host A to Host B. Assume an MSS of 536 bytes.…
A: a) The size of TCP sequence number field = 4 bytes…
Q: 4.03-2. Network Address Translation (b). Consider the following scenario in which host 10.0.0.1 is…
A: Correct answer is: At point B, Source IP Address is: 138.76.29.7 At point B, Destination IP Address…
Q: Given a Class C subnet Mask 255.255.255.192. what will be the subnet address and host number for a…
A: 192 in binary =11000000 gives 4 possible subnets of (showing 2 most significant bits): 00,01,10,11…
Q: agned by our ISP to s network. Hence, we are forced to borrow bits to create the subnet ID from the…
A: Introduction :Given , 191.254.0.32We have asked to check whether this ip address is a valid ip host…
Q: A large number of consecutive ip address are vailable starting at 172.26.0.0/16. Suppose that or…
A: 172.26.0.0/16 /16 means number of network bits is 16. Therefore number of host bits is 16 and for…
Q: Consider an IP packet with a data length of 4400 bytes. TCP header is of 40 bytes while that of IPv4…
A: Consider an IP packet with data of 4400 bytes. TCP header is 40 bytes while that of IPv4 reader is…
Q: 3. Suppose a client uses UDP to send data to a server and suppose that the length of the UDP…
A: Efficiency of UDP level = total data bytes / total size of packet.
Q: In IPV4, consider sending a 1,300 byte datagram (20 bytes of IP header) into a link that has an MTU…
A: The problem is based on transfer of data using ip addreses.
Q: 2. Suppose a large file of size F bits is to be sent from host A to host B. There are two links and…
A: Answer: I have given answered in the handwritten format in brief explanation.
Q: A large number of consecutive IP addresses are available starting at 198.16.0.0. Sup- pose that four…
A: [Note: We are authorized to answer one question at a time since you have not mentioned which…
Q: If the default mask for network was 255.255.255.0 and after subnetting had become Subnet mask…
A: Given default subnet mask is 255.255.255.0 After subnetting , mask is 255.255.255.192 We have to…
Q: Calculate and design the network of the following terms for given IP address 192.168.0.0/25,…
A: Given Solution: 1. Class of IP address: The IP address 192.168.0.0/25 belongs to Class C. 2.…
Q: Suppose you have the following network requirements, for Given an IP address and mask of 9.0.0.0/8,…
A: Given: Suppose you have the following network requirements, for Given an IP address and mask of…
Q: Three subnets have the following network prefixes: 57.6.96.0/21, 57.6.104.0/21, 57.6.112.0/21, and…
A: The given networks are: 57.6.96.0/21 57.6.104.0/21 57.6.112.0/21 57.6.120.0/21 Only the second…
Q: Consider transferring an enormous file of L bytes from host A to host B. Assume an MSS of 1460…
A: 1 Byte = 8 bit 4 byte = 4 = 32 bit. TCP: Transmission Control Protocol is a protocol for sending…
Q: This is Networking subject, Variable length subnet mask (VLSM) subnetting in IPv4. Problem: Given…
A: Given a variable length subnet masking and asked to identify the IP address range for different…
Q: Consider the network below and answer the following questions. switchA switchB server4 192.168.1.7…
A: Switch A: Ethernet Address Port 44:44:44:44:44:44 1 33:33:33:33:33:33 3
Q: Consider two hosts P and Q connected through a router R. The maximum transfer unit (MTU) value of…
A: The answer is
Q: Consider a class C network with the subnet mask 255.255.255.41. How many network id (NID) and host…
A: Subnet mask: 255.255.255.41 First of all, convert it into binary:…
Q: A) Explore specific packet number let's suppose number 4 and give its source IP and MAC addresses…
A: MAC address is a unique identifier that is assigned to a NIC (Network Interface Controller/ Card).…
Q: a) A large number of consecutive ip address are available starting at 172.26.0.0/16. Suppose tha for…
A: 172.26.0.0 /16 /16 means number of network bits is 16 and number of host bits is 16. For subnetting…
Q: If the network component of a class B subnet mask is borrowed, is it feasible to have at least 130…
A: Overview: To get 130 hosts per subnet, you will need to borrow eight bits from the Class B subnet…
Q: Network layer consists of two planes:(_________) , and(_______). QUESTION 56 What is AIMD in TCP…
A:
Q: Consider the following scenario: rdt 3.0 is operating on a link with bandwidth of 100 Mbps. The…
A: Link utilization = Transmission time/ transmission+propagation time Transmission time = packet size…
Q: How to forward to a border router? Consider the network shown below. Suppose AS1, AS2, AS3, and AS4…
A: According to the information given:- we have to find out the border router in the given network.
Q: Consider two hosts P and Q connected through a router R. The maximum transfer unit (MTU) value of…
A: Solution: MTU: A maximum transmission unit is the largest packet or frame size which specified in…
Q: Consider an IP datagram with the following characteristics: Length of IP header: 20 bytes Total…
A: The Answer is
Q: A network for a local office requires 4 LAN subnets as follows: · Subnet A - North Office with…
A: The given address is 192.168.15.0 /24 The subnet mask is /24 which means total number of network…
Q: The router's intertace on the LAN side has IP address 10.0.1.27, while the router's address on the…
A: In the given figure, there is one router and it contains 2 ports. Each port contains a separate IP…
Q: Consider sending a large file of F bits from Host A to Host B. There are three links (and two…
A:
Q: A large number of consecutive IP address are available starting at 192.16.0.0. Suppose that four…
A: 1) For 7000 addresses => 7000/256=28 hence Hence Address range is 192.16.0.0 to 192.16.27.255/19…
Q: Consider a scenario where a “Class B” network is divided into 5 subnets of fixed length. Design each…
A: I have considered class B, IP as 131.56.12.64 and for this IP we will divide it into 5 subnets of…
Q: How to forward to a border router? Consider the network shown below. Suppose AS1, AS2, AS3, and AS4…
A: In this question we have to answer as the correct statement for forwarding to border router will…
Q: If the network component of a class B subnet mask were borrowed, would it still be viable to have at…
A: According to the information given:- We have to define If the network component of a class B subnet…
Q: Under IPV6, fragmentation is implemented in end nodes only, unlike IPV4 where fragmentation can be…
A: Fragmentation is a common event on packet switched networks. This error happens when a large packet…
Q: Using packet tracer, implement a network that has the following components: 1- At least five routers…
A:
Q: Question#7: Calculate TCP and UDP efficiency while sending data of size 512 bytes? Justify the…
A: Hey there, I am writing the required solution based on the above given question. Please do find the…
Q: Consider two hosts A and B that are quite far apart. They are communicating using Selective Repeat…
A: The solution is given below:
Q: Consider a class C network with the subnet mask 255.255.255.41. How many network id (NID and host id…
A: As requested in question no explanation is been provided. The answer is given below
Q: Consider two-dimensional parity scheme: a) Choose any random packet entries such that the following…
A:
Trending now
This is a popular solution!
Step by step
Solved in 2 steps
- If the network component of a class B subnet mask is borrowed, is it feasible to have at least 130 hosts per subnet?Supposed the scenario bellow, we have 3 networks to be submitted with the ip address 192.171.0.0/16. Network 1 has 150 host, network 2 has 100 and network 3 has 7 host. VLSM Decompose the given ip address to these networks using VLSM, and write the ip adress and the subnet mask for router 1, switch 0 , switch 2 , switch 3 , PC0 , PC1 , PC2Consider the subnet address 184.84.0.0 divided into 9 subnets. If we want to maximize the number of hosts per subnet, what subnet mask should we use? What would the numbers of the first 2 and last 2 subnets be, along with their address range? Explain your answer.
- 21.) Consider the following configuration. Computer “A” IP address: 172.16.100.100 Subnet mask: 255.255.0.0 Computer “B” IP address: 172.16.200.200 Subnet mask: /16 What should be done to allow these computers to send and receive data to and from each other? A.) Nothing needs to be changed. B.) Delete the subnet mask from each computer. C.) A router must be configured and placed between the two computers. D.) Remove the hub between the two computers and replace it with a switch.Consider the following diagram: A,B,C and D are subnets, R1, R2, and R3 are routers. Default signifies theentire rest of the internet. All 4 subnets each contain the same number of hosts.Consider the following routing table at R3: CIDR Mask Link 0.0.0.0/0 L4 128.4.6.0/24 L3 128.4.8.0/24 L5 1. If 128.4.6.0 is in A, what is the routing table at R1? 2. The ISP that owns all these networks is short on IP addresses, so theyuse a NAT router for R2. How many public IP addresses will C andD use together assuming they use as many private 10.X IP addresses asthey can? How many total public IP addresses will be used by the entirenetwork? Why doesn’t the ISP care about how many private IP addressesare used? 3. Fix R3’s routing table now that we are using NAT: 4. A node in C is given the IP address 10.0.0.1 and only sends and receivespackets on port 1234. A packet destined for this node reaches R2 witha source of (IP=128.4.6.6, Port=3000) and destination of (IP=128.4.8.0,Port=10000).…QUESTION 54 Network layer provides two basic functionalities (_______), and(_______) QUESTION 55 Network layer consists of two planes:(_________) , and(_______). QUESTION 56 What is AIMD in TCP stands for? What is the main purpose of it? QUESTION 57 Link layer uses IP for source and destination addresses True False QUESTION 58 SHA-1 is a Cryptographic hash function True False QUESTION 59 CRC is a cryptographic hash function True False
- Consider a scenario where a “Class C” network is divided into 8 subnets of fixed length. Design each subnet and find the IP Range and subnet mask of each subnet. (Choose any class C address)Computer Science Suppose We Are Going To Import A Capture Dump File Via WIRESHARK(Networking Analysis) Version 3.6.0 Show all steps on how to solve the following problems: A) Explore specific packet number let's suppose number 4 and give its source IP and MAC addresses (Show How To Do It With Steps - ScreenShots) B) Identify the Application protocols used in the communication (Show How To Do It With Steps - ScreenShots) C) Filter all TCP traffic and identify the login name and password (Show How To Do It With Steps - ScreenShots)Consider the subnet address 100.0.0.0, divided into 9 subnets. If we want to maximize the number of hosts per subnet, what subnet mask should we use? What would the numbers of the first 2 and last 2 subnets be, along with their address range and their broadcast? Explain your answers.
- Consider a class C network with the subnet mask 255.255.255.41. How many network id (NID) and host id (HID) are there in the subnet mask? (A) 24,3 (B) 24,5 (C) 20,6 D) 20, 8q no 5: In the above network diagram, IP and MAC addresses are given for network nodes. Suppose Host1 (Shahid) sends a datagram to Host2 (Khalid). What IP and MAC addresses (source and destination) will be written in IP and Data link layer headers respectively, for the following intermediate points from Host1 to Host2? Host1 to Router1 (R1) Router1 to Router2 (R2) Router2 to Host2If the network component of a class B subnet mask were borrowed, would it still be viable to have at least 130 hosts in each individual subnet?