Consider a class C network with the subnet mask 255.255.255.41. How many network id (NID and host id (HID) are there in the subnet mask? (A) 24, 3 (В) 24, 5 (C) 20, 6 (D) 20, 8
Q: 6c. Utilization. Consider the scenario shown below, with a two clients sending to a server. The…
A: As per given information :- R1 = R2 = 10 Mbps R3 = 100 Mbps
Q: In NAT, how does an IP gateway ensure that outgoing traffic can traverse public networks?a. It…
A: Answer: d. It replaces each outgoing packet's source address field with a public IP address.
Q: Problem 1 a) When the destination in a datagram is an IP multicast address, how are ICMP error…
A: The IP is does not an inbuilt structure to transfer error messages. Internet Control Message…
Q: Let IP address 200 210 56.76/28 find the subnet mask, subnet id broadcast address and also find…
A: Introduction: Subnet mask: Number that distinguishes/separates host and network address Subnet…
Q: Let IP address 200.210.56.76/28 find the subnet mask, subnet id ,broadcast address and also find…
A: IP Address: An IP is stands for Internet protocol It is a numerical label(designation), such as…
Q: Decompose the given ip address to these networks using VLSM, and write the ip adress and the subnet…
A: Supposed the scenario bellow, we have 3 networks to be submitted with the ip address 192.171.0.0/16.…
Q: Suppose that the two-layer fully connected network pictured below is trained with a batch size of 3.…
A: Answer: Given Batch size =3 and Input(i)=3072 Hidden layer(h)=100 and output(o)=10
Q: Based on the information in the graph, we need to design a network addressing scheme that will…
A: Given Data : Number of subnets = 3 Host for subnet = 24 , 60 , 15.
Q: 4.03-2. Network Address Translation (b). Consider the following scenario in which host 10.0.0.1 is…
A: Answer: Given host :10.0.0.1 and IP :128:119:40:186
Q: Consider transferring an enormous file of L bytes from Host A to Host B. Assume an MSS of 536 bytes.…
A: a) The size of TCP sequence number field = 4 bytes…
Q: 4.03-2. Network Address Translation (b). Consider the following scenario in which host 10.0.0.1 is…
A: Correct answer is: At point B, Source IP Address is: 138.76.29.7 At point B, Destination IP Address…
Q: A large number of consecutive ip address are vailable starting at 172.26.0.0/16. Suppose that or…
A: 172.26.0.0/16 /16 means number of network bits is 16. Therefore number of host bits is 16 and for…
Q: Consider an IP packet with a data length of 4400 bytes. TCP header is of 40 bytes while that of IPv4…
A: Consider an IP packet with data of 4400 bytes. TCP header is 40 bytes while that of IPv4 reader is…
Q: 3. Suppose a client uses UDP to send data to a server and suppose that the length of the UDP…
A: Efficiency of UDP level = total data bytes / total size of packet.
Q: Given a subnet mask of 255.255.255.192 for a C Class network, there will be how many bits for subnet…
A: The following is the solution
Q: In IPV4, consider sending a 1,300 byte datagram (20 bytes of IP header) into a link that has an MTU…
A: The problem is based on transfer of data using ip addreses.
Q: 2. Suppose a large file of size F bits is to be sent from host A to host B. There are two links and…
A: Answer: I have given answered in the handwritten format in brief explanation.
Q: nd subnet mask of each subnet. (Choose any class C address)
A: Subnet Mask and IP Address A 32-bit IP address identifies a single device on an IP network. The…
Q: Suppose you have the following network requirements, for Given an IP address and mask of 9.0.0.0/8,…
A: Given: Suppose you have the following network requirements, for Given an IP address and mask of…
Q: Three subnets have the following network prefixes: 57.6.96.0/21, 57.6.104.0/21, 57.6.112.0/21, and…
A: The given networks are: 57.6.96.0/21 57.6.104.0/21 57.6.112.0/21 57.6.120.0/21 Only the second…
Q: Consider a class C network with the subnet mask 255.255.255.41. How many network id (NID) and host…
A: Subnet mask: 255.255.255.41 First of all, convert it into binary:…
Q: In IPV4, consider sending a 4,000 byte datagram (20 bytes of IP header) into a link that has an MTU…
A: Given:
Q: Let IP address 200 210.56.76/28 find the subnet mask, subnet id ,broadcast address and also find…
A: Find the required answer given as below :
Q: Consider the NAT scenario below. IP datagrams being sent from, or destined to, these three private…
A: Dear Student, Here the datagrams will be first sent from the host to the router , then from the…
Q: Consider a scenario in which Host A and Host B want to send messages to Host C. Hosts A and C are…
A: ->The sender has sent a message to the recipient many times. In the situation here. The channel…
Q: a) A large number of consecutive ip address are available starting at 172.26.0.0/16. Suppose tha for…
A: 172.26.0.0 /16 /16 means number of network bits is 16 and number of host bits is 16. For subnetting…
Q: You are asked to create equal-size subnets in the 205.33.44.0 network using subnet mask…
A: Given IP address is 205.33.44.0 Subnet mask= 255.255.255.224(/27) Number of network and subnet…
Q: If the network component of a class B subnet mask is borrowed, is it feasible to have at least 130…
A: Overview: To get 130 hosts per subnet, you will need to borrow eight bits from the Class B subnet…
Q: 5.08. How to forward to a border router? Consider the network shown below. Suppose AS1, AS2, AS3,…
A: According to the information given:- we have to find out the border router in the given network.
Q: How to forward to a border router? Consider the network shown below. Suppose AS1, AS2, AS3, and AS4…
A: According to the information given:- we have to find out the border router in the given network.
Q: Consider an IP datagram with the following characteristics: Length of IP header: 20 bytes Total…
A: The Answer is
Q: Registration Number: 193046 Consider a network with 3 hosts and a NAT router. Suppose that the…
A: a) Home address : 192.168.1.1, 192.168.1.2, 192.168.1.3, 192.168.1.4 b) NAT Translation table…
Q: Consider a subnet 120.128.128.0/17. Suppose an ISP owns the block of addresses of this subnet and…
A: Given that, A subnet 120.128.128.0/17 Suppose an ISP owns the block of addresses of this subnet and…
Q: Let IP address 200.210.56.76/28 find the subnet mask , subnet id ,broadcast address and also find…
A: Given IP address is 200.210.56.76/28 In this IP address, 28 bits are network id bits. Number of host…
Q: Consider an IP packet with a length of 4,500bytes that includes a 20-byteIPv4 header ans 40-byte TCP…
A: Here total number of payload allowed in each fragment = floor (600-20/8) *8 = 576 Bytes. 576 Bytes…
Q: A large number of consecutive IP address are available starting at 192.16.0.0. Suppose that four…
A: 1) For 7000 addresses => 7000/256=28 hence Hence Address range is 192.16.0.0 to 192.16.27.255/19…
Q: Suppose host A is sending a large file to host B over a TCP connection. The two end hosts are 10…
A: Given:
Q: Consider a scenario where a “Class B” network is divided into 5 subnets of fixed length. Design each…
A: I have considered class B, IP as 131.56.12.64 and for this IP we will divide it into 5 subnets of…
Q: Q5) 1- Write the routing table for router R1 for the networks N2, N3, and Host B. 2- Define: RIP…
A: Routing table: A routing table is a set of rules, often viewed in table format, that is used to…
Q: How to forward to a border router? Consider the network shown below. Suppose AS1, AS2, AS3, and AS4…
A: In this question we have to answer as the correct statement for forwarding to border router will…
Q: If the network component of a class B subnet mask were borrowed, would it still be viable to have at…
A: According to the information given:- We have to define If the network component of a class B subnet…
Q: 4.03-1. Network Address Translation (a). Consider the following scenario in which host 10.0.0.1 is…
A: At point A the computer host with the IP 10.0.0.1 wants to communicate with web server…
Q: 7.1 In IEEE 802.11, open system authentication simply consists of two communications. An…
A: a. Benefits of the authentication scheme: This authentication scheme defends towards very simple…
Q: Under IPV6, fragmentation is implemented in end nodes only, unlike IPV4 where fragmentation can be…
A: Fragmentation is a common event on packet switched networks. This error happens when a large packet…
Q: Question#7: Calculate TCP and UDP efficiency while sending data of size 512 bytes? Justify the…
A: Hey there, I am writing the required solution based on the above given question. Please do find the…
Q: Consider two hosts A and B that are quite far apart. They are communicating using Selective Repeat…
A: The solution is given below:
Q: Consider two-dimensional parity scheme: a) Choose any random packet entries such that the following…
A:
No explanation
Step by step
Solved in 2 steps
- If the network component of a class B subnet mask is borrowed, is it feasible to have at least 130 hosts per subnet?Supposed the scenario bellow, we have 3 networks to be submitted with the ip address 192.171.0.0/16. Network 1 has 150 host, network 2 has 100 and network 3 has 7 host. VLSM Decompose the given ip address to these networks using VLSM, and write the ip adress and the subnet mask for router 1, switch 0 , switch 2 , switch 3 , PC0 , PC1 , PC2Consider the subnet address 184.84.0.0 divided into 9 subnets. If we want to maximize the number of hosts per subnet, what subnet mask should we use? What would the numbers of the first 2 and last 2 subnets be, along with their address range? Explain your answer.
- 21.) Consider the following configuration. Computer “A” IP address: 172.16.100.100 Subnet mask: 255.255.0.0 Computer “B” IP address: 172.16.200.200 Subnet mask: /16 What should be done to allow these computers to send and receive data to and from each other? A.) Nothing needs to be changed. B.) Delete the subnet mask from each computer. C.) A router must be configured and placed between the two computers. D.) Remove the hub between the two computers and replace it with a switch.Consider the following diagram: A,B,C and D are subnets, R1, R2, and R3 are routers. Default signifies theentire rest of the internet. All 4 subnets each contain the same number of hosts.Consider the following routing table at R3: CIDR Mask Link 0.0.0.0/0 L4 128.4.6.0/24 L3 128.4.8.0/24 L5 1. If 128.4.6.0 is in A, what is the routing table at R1? 2. The ISP that owns all these networks is short on IP addresses, so theyuse a NAT router for R2. How many public IP addresses will C andD use together assuming they use as many private 10.X IP addresses asthey can? How many total public IP addresses will be used by the entirenetwork? Why doesn’t the ISP care about how many private IP addressesare used? 3. Fix R3’s routing table now that we are using NAT: 4. A node in C is given the IP address 10.0.0.1 and only sends and receivespackets on port 1234. A packet destined for this node reaches R2 witha source of (IP=128.4.6.6, Port=3000) and destination of (IP=128.4.8.0,Port=10000).…QUESTION 54 Network layer provides two basic functionalities (_______), and(_______) QUESTION 55 Network layer consists of two planes:(_________) , and(_______). QUESTION 56 What is AIMD in TCP stands for? What is the main purpose of it? QUESTION 57 Link layer uses IP for source and destination addresses True False QUESTION 58 SHA-1 is a Cryptographic hash function True False QUESTION 59 CRC is a cryptographic hash function True False
- Consider a scenario where a “Class C” network is divided into 8 subnets of fixed length. Design each subnet and find the IP Range and subnet mask of each subnet. (Choose any class C address)Computer Science Suppose We Are Going To Import A Capture Dump File Via WIRESHARK(Networking Analysis) Version 3.6.0 Show all steps on how to solve the following problems: A) Explore specific packet number let's suppose number 4 and give its source IP and MAC addresses (Show How To Do It With Steps - ScreenShots) B) Identify the Application protocols used in the communication (Show How To Do It With Steps - ScreenShots) C) Filter all TCP traffic and identify the login name and password (Show How To Do It With Steps - ScreenShots)Consider the subnet address 100.0.0.0, divided into 9 subnets. If we want to maximize the number of hosts per subnet, what subnet mask should we use? What would the numbers of the first 2 and last 2 subnets be, along with their address range and their broadcast? Explain your answers.
- Consider a class C network with the subnet mask 255.255.255.41. How many network id (NID) and host id (HID) are there in the subnet mask? (A) 24,3 (B) 24,5 (C) 20,6 D) 20, 8q no 5: In the above network diagram, IP and MAC addresses are given for network nodes. Suppose Host1 (Shahid) sends a datagram to Host2 (Khalid). What IP and MAC addresses (source and destination) will be written in IP and Data link layer headers respectively, for the following intermediate points from Host1 to Host2? Host1 to Router1 (R1) Router1 to Router2 (R2) Router2 to Host2If the network component of a class B subnet mask were borrowed, would it still be viable to have at least 130 hosts in each individual subnet?