Consider an IP packet with a data length of 4400 bytes. TCP header is of 40 bytes while that of IPv4 header is 20 bytes. The packet is forwarded to an IPv4 router that supports MTU of 900 bytes. Length of the IP header for outgoing fragments is 20 bytes. Assume that the fragment offset value stored in the first fragment is 100. The fragmentation offset value of the penultimate fragment is

Consider an IP packet with a data length of 4400 bytes. TCP header is of 40 bytes while that of IPv4 header is 20 bytes. The packet is forwarded to an IPv4 router that supports MTU of 900 bytes. Length of the IP header for outgoing fragments is 20 bytes. Assume that the fragment offset value stored in the first fragment is 100. The fragmentation offset value of the penultimate fragment is

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Similar questions

(ESP) Consider that we protect a TCP SYN packet using the ESP in the transport mode. A TCP SYN packet just comprises a TCP header which is 20 bytes (i.e., without TCP option). The IP packet header is also 20 bytes long (i.e., without IP option). Moreover, the block size for encryption is 256 bits (e.g., using AES-256), and the hash output’s size for message authentication is 512 bits (e.g., using SHA-1). What is the minimum amount of padding required?
Consider the following scenario in which host A is sending a file to host B over a TCP connection. Assuming that the sequence number of the first data byte sent by A is 0 and every segment always includes 1000 bytes of data, excluding the TCP header. At some point of time, bytes up to 6400 have been written into the sender’s buffer. Bytes up to 4999 have been sent out but the segment which contains bytes 2000~2999 has not arrived at host B yet. At the receiver’s side, all bytes up to 3999 have been received except for bytes 2000~2999. Bytes up to 499 have been read from the buffer by the application. Assume that the maximum size of the sender’s buffer is large enough. Consider the sliding window algorithm in TCP and answer the following questions. 1) What are the values for LastByteAcked, LastByteSent, and LastByteWritten? 2) What are the values for LastByteRead, NextByteExpected, and LastByteRcvd? 3) Assuming that the maximum size of the receiver’s buffer is 4000 byte, what would…
Consider sending a 2400-byte datagram into a link that has an MTU of 700 bytes. Suppose the original datagram is stamped with the identification number 522. Write down the values of the following IP header fields for each of the generated fragments and also length, ID, fragflag, offset?
P14. Consider sending a 2400-byte datagram into a link that has an MTU of 700 bytes. Suppose the original datagram is stamped with the identification number 422. How many fragments are generated? What are the values in the various fields in the IP datagram(s) generated related to fragmentation?
Consider sending a file of F bits over a path of Q links. Each link transmits at R bits per second (bps). The network is lightly loaded so that there are no queueing delays. When a form of packet switching is used, the F bits are broken up into packets, each packet with L bits, of which h bits of it are header. Propagation delay is negligible. Let F = 5x104, Q = 20, R = 1 Mbps, L = 1000, and h = 10. b) Suppose the network is a packet-switched datagram network and a connectionless service is used. How long does it take to send the file?
Host A is sending an enormous file to Host B over a TCP connection. Over this connection there is never any packet loss and the timers never expire. Denote the transmission rate of the link connecting Host A to the Internet by R bps. Suppose that the process in Host A is capable of sending data into its TCP socket at a rate S bps, where S=10·R. Further suppose that the TCP receive buffer is large enough to hold the entire file, and the send buffer can hold only one percent of the file. What would prevent the process in Host A from continuously passing data to its TCP socket at rate S bps? TCP flow control? TCP congestion control? Or something else? Elaborate.
Consider 2 hosts, Host A and Host B, transmitting a large file to a Server C over a bottleneck link with a rate of R kbps. To transfer the file, the hosts use TCP with the same parameters (including MSS and RTT) and start their transmission at the same time. Host A uses a single TCP connection for the entire file, while Host B uses 9 simultaneous TCP connections, each for a portion (i.e. a chunk) of the file. Describe the relative transmission rates achieved by each host at the beginning of the file transfer?
True or false? Suppose Host A is sending Host B a large file over a TCP connection. The number of unacknowledged bytes that A sends cannot exceed the size of the receive buffer.
Consider transferring an enormous file of L bytes from Host A to Host B. Assume an MSS of 536 bytes.a. What is the maximum value of L such that TCP sequence numbers are not exhausted? Recall that the TCP sequence number field has 4 bytes.b. For the L you obtain in (a), find how long it takes to transmit the file. Assume that a total of 66 bytes of transport, network, and data-link header are added to each segment before the resulting packet is sent out over a 155 Mbps link. Ignore flow control and congestion control so A can pump out the segments back to back and continuously.
Consider sending a 2400-byte datagram into a link that has an MTU of 700 bytes. Suppose the original datagram is stamped with the identification number 522. Write down the values of the following IP header fields for each of the generated fragments? a. length b. ID c. fragflag d. offset
Consider transferring an enormous file of L bytes from host A to host B. Assume an MSS of 1460 bytes.a. What is the maximum value of L such that TCP sequence numbers are not exhausted? Recall that the TCP sequence number field has four bytes.b. For the L you obtain in (a), find how long it takes to transmit the file Assume that a total of 66 bytes of transport, network, and data-link header are added to each segment before the resulting packet is sent out over at 10 Mbps link. Ignore flow control and congestion control so A can pump out the segments back to back and continuously.
A large number of consecutive IP addresses are available starting at 198.16.0.0. Sup- pose that four organizations, A, B, C, and D, request 4000, 2000, 4000, and 8000 ad- dresses, respectively, and in that order. For each of these, give the first IP address as- signed, the last IP address assigned, and the mask in the w.x.y.z/s notation. A router has just received the following new IP addresses: 57.6.96.0/21, 57.6.104.0/21, 57.6.112.0/21, and 57.6.120.0/21. If all of them use the same outgoing line, can they be aggregated? If so, to what? If not, why not? The set of IP addresses from 29.18.0.0 to 19.18.128.255 has been aggregated to 29.18.0.0/17. However, there is a gap of 1024 unassigned addresses from 29.18.60.0 to 29.18.63.255 that are now suddenly assigned to a host using a different outgoing line. Is it now necessary to split up the aggregate address into its constituent blocks, add the new block to the table, and then see if any reaggregation is possible? If not, what can be…