Consider a completely miscible liquid mixture of A (PA° = 150 torr) and B (Pg° = 230 torr) which behaves ideally in both the liquid and vapor states. If a solution that contains 40% mole of B is prepared at 25°C, at what pressure will vaporization start? %3D 130 torr O 182 torr O 380 torr O 250 torr

Consider a completely miscible liquid mixture of A (PA° = 150 torr) and B (Pg° = 230 torr) which behaves ideally in both the liquid and vapor states. If a solution that contains 40% mole of B is prepared at 25°C, at what pressure will vaporization start? %3D 130 torr O 182 torr O 380 torr O 250 torr

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter11: Properties Of Solutions

Section: Chapter Questions

Problem 2ALQ: Once again, consider Fig. 10-9. Suppose instead of having a nonvolatile solute in the solvent in one...

See similar textbooks

Similar questions

Sketch graphs of total vapor pressure versus the mole fraction of two volatile substances that show (a) positive deviation from Raoults law. (b) negative deviation from Raoults law. (c) a maximum boiling azeotrope. (d) a minimum boiling azeotrope.
A mixture of toluene (bp110.8C) and water is steam distilled. Visual inspection of the distillate reveals that there is a greater volume of toluene than water present, yet water (bp100C) has the higher vapor pressure. Explain this observation.
In some regions of the southwest United States, the water is very hard. For example, in Las Cruces, New Mexico, the tap water contains about 560 g of dissolved solids per milliliter. Reverse osmosis units are marketed in this area to soften water. A typical unit exerts a pressure of 8.0 atm and can produce 45 L water per day. a. Assuming all of the dissolved solids are MgCO3 and assuming a temperature of 27C, what total volume of water must be processed to produce 45 L pure water? b. Would the same system work for purifying seawater? (Assume seawater is 0.60 M NaCl.)
A sucrose (C12H22O11) solution that is 45.0% sucrose by mass has a density of 1.203 g/mL at 25C. Calculate its (a) molarity. (b) molality. (c) vapor pressure(vpH2Oat25C=23.76mmHg). (d) normal boiling point.
In the distillation of a pure substance (e.g., water), why does all of the water not vaporize at once when the boiling point is reached?
If l-mol samples of urea, a nonelectrolyte, sodium chloride, and calcium chloride are each dissolved in equal volumes of water in separate containers: a Which solution would have the highest boiling point? b Which solution would have the highest freezing point?
The solubility of nitrogen in water is 8.21 104 mol/L at 0C when the N2 pressure above water is 0.790 atm. Calculate the Henrys law constant for N2 in units of mol/L atm for Henrys law in the form C = kP, where C is the gas concentration in mol/L. Calculate the solubility of N2 in water when the partial pressure of nitrogen above water is 1.10 atm at 0C.
A certain gaseous solute dissolves in water, evolving 12.0 kJ of heat. Its solubility at 25C and 4.00 atm is 0.0200 M. Would you expect the solubility to be greater or less than 0.0200 M at (a) 5C and 6 atm? (b) 50C and 2 atm? (b) 20C and 4 atm? (b) 25C and 1 atm?
Acetylene can be made by reacting calcium carbide with water. CaC2(s) + 2 H2O() C2H2(g) + Ca(OH)2(aq) Assume that you place 2.65 g CaC2 in excess water and collect the acetylene over water. The volume of the acetylene and water vapor is 795 mL at 25.0 C and a barometric pressure of 735.2 mmHg. Calculate the percent yield of acetylene. The vapor pressure of water at 25 C is 23.8 mmHg.
Once again, consider Fig. 10-9. Suppose instead of having a nonvolatile solute in the solvent in one beaker, the two beakers contain different volatile liquids. That is, suppose one beaker contains liquid A (Pvap = 50 torr) and the other beaker contains liquid B (Pvap = 100 torr). Explain what happens as time passes. How is this similar to the first case (shown in the figure)? How is it different?
A solution contains 3.75 g of a nonvolatile pure hydrocarbon in 95 g acetone. The boiling points of pure acetone and the solution are 55.95C and 56.50C, respectively. The molal boiling-point constant of acetone is 1.71 C kg/mol. What is the molar mass of the hydrocarbon?