Consider a simple ideal Rankine cycle with fixed boiler and condenser pressure and condenser pressuresand turbine inlet temperature. What happens if the cycle is modified with ideal regeneration thatinvolves one closed feed water heater? (Per unit mass of steam flowing through the boiler)

Regeneration in the Rankine cycle is done by extracting a small amount of steam from the…

Answered: Consider a simple ideal Rankine cycle…

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A simple ideal Rankine cycle with water as the working fluid operates between the pressure limits of 3 MPa in the boiler and 30 kPa in the condenser. If the quality at the exit of the turbine cannot be less than 79 percent, what is the maximum thermal efficiency this cycle can have? Use steam tables. The maximum thermal efficiency is
A simple ideal Rankine cycle using water as a working fluid has a condenser temperature of 70 ° C and a boiler temperature of 250 ° C. What will be the thermal efficiency of the cycle as the steam enters the turbine as saturated steam?
Water enters the turbine of an ideal Rankine cycle as superheated vapor at 10 MPa and 600°C. If the condenser pressure is 10 kPa, Calculate the thermal efficiency of the system.
Consider a steam power plant that operates on the ideal reheat Rankine cycle. The plant maintains the boiler at 5000 kPa, the reheat section at 1200 kPa, and the condenser at 20 kPa. The mixture quality at the exit of both turbines is 96 percent. Determine the temperature at the inlet of each turbine and the cycle's thermal efficiency. Answers: 327°C, 481°C, 35.0 percent.
A steam power plant operating on a simple ideal Rankine cycle maintains the boiler at 6000 kPa, the turbine inlet at 600C, and the condenser at 50 kPa. Compare the thermal efficiency of this cycle when it is operated so that the liquid enters the pump as a saturated liquid against that when the liquid enters the pump 11.3C cooler than a saturated liquid at the condenser pressure.
An ideal reheat 210 MW Rankine cycle with water as the working fluid operates the boiler at 15 MPa, the reheater at 2 MPa, and the condenser at 10 kPa. The temperature is 500 0C at the entrance of the high-pressure and low-pressure turbines. Determine (a) the quality of the steam at the low-pressure turbine exit, (b) the thermal efficiency of this system, and (c) the rate of heat transfer in the reheater.
An ideal Rankine cycle with double reheat operates the boiler at 12MPa, the reheater at 5 MPa and 2.0 MPa, and the condenser at 0.01 MPa. The temperature at the boiler and reheater outlets are maintained at 400°C. a) Determine the total rate of heat transfer per unit mass in the reheaters, andb) the thermal efficiency of this cycle.
A simple ideal Rankine cycle which uses water as the working fluid operates its condenser at 40C and its boiler at 300C. The steam enters the turbine without any superheating. Determine the thermal efficiency
A power plant is to be operated on an ideal Rankine cycle with the superheatedsteam exiting the boiler at 4 MPa and 500°C. Calculate the thermal efficiencyand the quality at the turbine outlet if the condenser pressure is (a) 20 kPa,(b) 10 kPa, and (c) 8 kPa.
A simple Rankine cycle works between the boiler pressure of 4 Mpa and condenser pressure of 30 bar. The steam is dry saturated before the throttling in the turbine. Determine the Rankine cycle efficiency.
A steam power plant operates on the ideal Rankine cycle principle (see installation schematic and T-s diagram below). Water vapor enters the turbine at 15 MPa and 500°C and is condensed at a condenser pressure of 10 kPa. Calculate the thermal efficiency of the cycle.
In a steam power plant operating according to the ideal Rankine cycle at 4MPa pressure and 400CIt enters and condenses in the condenser at a pressure of 100kPa. Determine the efficiency of the cycle.What would the efficiency be if the steam entered the turbine at 5MPa pressure and condensed at 90kPa pressure.

SEE MORE QUESTIONS

Recommended textbooks for you

Elements Of Electromagnetics

Mechanical Engineering

ISBN:

9780190698614

Author:

Sadiku, Matthew N. O.

Publisher:

Oxford University Press

Mechanics of Materials (10th Edition)

Mechanical Engineering

ISBN:

9780134319650

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Thermodynamics: An Engineering Approach

Mechanical Engineering

ISBN:

9781259822674

Author:

Yunus A. Cengel Dr., Michael A. Boles

Publisher:

McGraw-Hill Education

Elements Of Electromagnetics

Mechanical Engineering

ISBN:

9780190698614

Author:

Sadiku, Matthew N. O.

Publisher:

Oxford University Press

Mechanics of Materials (10th Edition)

Mechanical Engineering

ISBN:

9780134319650

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Thermodynamics: An Engineering Approach

Mechanical Engineering

ISBN:

9781259822674

Author:

Yunus A. Cengel Dr., Michael A. Boles

Publisher:

McGraw-Hill Education

Control Systems Engineering

Mechanical Engineering

ISBN:

9781118170519

Author:

Norman S. Nise

Publisher:

WILEY

Mechanics of Materials (MindTap Course List)

Mechanical Engineering

ISBN:

9781337093347

Author:

Barry J. Goodno, James M. Gere

Publisher:

Cengage Learning

Engineering Mechanics: Statics

Mechanical Engineering

ISBN:

9781118807330

Author:

James L. Meriam, L. G. Kraige, J. N. Bolton

Publisher:

WILEY

SEE MORE TEXTBOOKS

Consider a simple ideal Rankine cycle with fixed boiler and condenser pressure and condenser pressures and turbine inlet temperature. What happens if the cycle is modified with ideal regeneration that involves one closed feed water heater? (Per unit mass of steam flowing through the boiler)