Consider the below circuit. Suppose that Vrms = 700 V and R = 30 Ω. 1- Find the power delivered by the source, and the reactive power delivered by the sources. 2. Find the apparent power delivered by the source, and the power factor

Q: 2.2 Refer to the parallel ac network below: 0.5 H 500 μF, 10Ω wwww 13 5Ω 100 μF www 12 0.1 H_ wwww…

A:

Q: ZIN 200 2 j250 2 -j500 2 50 2 V2 10 0 V 400 Vx IB IA 2VX +.

A:

Q: A parallel circuit of 25 – ohm resistor, 64 – mH inductor and 80 - μF capacitor connected across a…

A:

Q: Q3. Each phase of a delta-connected load comprises a resistance of 300 and an 80µF capacitor in…

A:

Q: O Uoy the network. Then, determine the power factor (pf) of the network. Based on the calculated…

A:

Q: FN.Q4 – Each phase of a star-connected load comprises a resistance of 56 2 and a 155 mH inductance…

A:

Q: 2- Calculate the effective, reactance and apparent capacities provided by the circuit source shown…

A:

Q: 1. Three loads are connected in parallel to a 12040° Vrms source. Load 1 absorbs 60 kVAR at p.f =…

A: According to given question Load 1 : 60 kVAR at P.F.=0.85 lagging, cos∅=0.85⇒∅=cos-1(0.85)=31.788°…

Q: Z1 V1 3PH 120V 60HZ

A:

Q: Example 2.7 Consider the following 50 Hz-based circuit with the given parameters: R= 0.5 2 L= 2.122…

A:

Q: A small installation consists of the following loads connected in parallel across a single-phase…

A: When the devices are connected in parallel, the potential difference across all the elements is…

Q: a) The network shown in Figure 1 has a total active power of 2253 W. Determine: i) the total…

A:

Q: Calculate the input impedance for the circuit shown in figure. Assume A = 0. Şekildeki devre için…

A:

Q: (a) Calculate real power, reactive power and apparent power dissipated by each component (resistor,…

A:

Q: In the network of Figure below use nodal analysis to determine (a) the voltage at nodes 1 and 2, (b)…

A:

Q: 6. A 240-Vma 50-Hz supply serves a load that is 10 kW (resistive), 15 KVAR (capacitive), and 22 KVAR…

A: Dear,as per company guidelines we can answer only 3 sub-parts at a time, kindly post other sub-part…

Q: The circuit given in the figure below is continuously sinusoidal and the element values in the…

A: The circuit has one independent source and one dependent source. The value of XL and XC is given as:…

Q: Given the circuit below, determine a) the overall power factor, b)the real power dissipated, c.) the…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: 20 Vrms source supplies a parallel RLC circuit with the following values: R=100 ohms, XL=200 ohms…

A:

Q: When drawing three-phase inductive 250 kW from the 440 V transmission line, the power coefficient is…

A: The complex power in an AC system is defined as the product of rms value of applied voltage and…

Q: The network shown in Figure 1 has a total active power of 2253W. Determine (a) the total impedance,…

A: Disclaimer:  Since you have asked multipart questions, we will solve the first three subpart for…

Q: R1 Ib=5 Ic R2 + Zyük C V

A:

Q: The circuit given in the figure below is continuously sinusoidal and the element values in the…

A:

Q: Q3. Each phase of a delta-connected load comprises a resistance of 300 and an 80µF capacitor in…

A:

Q: The circuit given in the figure below is continuously sinusoidal and the element values in the…

A:

Q: For the circuit given below i) Find the Thevenin equivalent circuit (i.e. Thevenin voltage and…

A:

Q: 1.8. A balanced three-phase Y-connected source has a line voltage of 208 V and feeds two balanced…

A:

Q: A set of 100-ohm resistor, 0.5-Henry inductor, and 50-microFarad capacitor elements are arranged in…

A:

Q: A 440Vrms, 60-Hz source supplies two loads connected in parallel : Load 1(L1): 12 kVA, 0.70 pf…

A:

Q: 1. a) A load takes 100kW at a power factor of 0.8 lagging. Calculate the apparent power and the…

A: The solution is as follows.

Q: BA series-connected load draws a current i(t) = 4 cos(315t + 10°) A when the applied voltage is v(t)…

A: According to question we have to calculate the value of Apparent power, power factor  and value of…

Q: For the circuit in the figure below, the reactance of each impendence is specified according to the…

A:

Q: Ri Ib-5 Ic R2 L + Zyūk e(t) V 'Ic

A:

Q: 5. A voltage having frequency of 50 Hz and expressed by V = 200+j100 is applied to a circuit…

A:

Q: a power station has a connected load of 48MW. the energy generated for the year is 61500MWh. if the…

A: Load factor = average load / maximum demand  Demand factor = maximum demand/ connected load.

Q: The balanced system below has a phase voltage of 120 V. It supplies a balanced load Z1 that has…

A: In this question we need to find a total reactive power and true power of the given three phase…

Q: 6. A 240-V,ms 50-Hz supply serves a load that is 10 kW (resistive), 15 KVAR (capacitive), and 22…

A:

Q: 6. A 240-Vms 50-Hz supply serves a load that is 10 kW (resistive), 15 kVAR (capacitive), and 22 KVAR…

A:

Q: An electrical load has an apparent power of 8000 VA with a power factor of 0.6 lagging. The load is…

A:

Q: For the circuit shown in the following figure, a) Find and draw the Thévenin equivalent circuit at…

A: Given that Electrical network as follows

Q: 6)  A circuit consisting of a resistor in series with an inductance takes 210W at a power factor of…

A: We are authorized to answer first three parts. As you have not mentioned which part to answer. So,…

Q: The balanced system below has a phase voltage of 120 V. It supplies a balanced load Z1 that has…

A:

Q: R1 Ib-5 Ic R2 L + + Zyük t) C V

A: (a) In the given question we know that   e(t ) = 2 cos (t + 90 )  c  = 1μF L  = 2H R1    = 1ΩR2  =…

Q: A set of 100-ohm resistor, 0.5-Henry inductor, and 100-microFarad capacitor elements are arranged in…

A: As per the guidelines of bartleyby I need to answer first three subparts only so kindly repost other…

Q: An electrical load has an apparent power of 8000 VA with a power factor of 0.6 lagging. The load is…

A: The phasor diagram of the given problem is cosϕ1 = Load power factor without capacitor, cosϕ2 =…

Q: Calculate the input impedance for the circuit shown in figure. Assume A = 0. Şekildeki devre için…

A: Here it us asked to find out the input resistance of the amplifier. To have the input resistance we…

Q: a) Find the Thevenin equivalent of the circuit in the form V = ZThI + VTh, viewed from the A-B ends…

A:

Q: In the circuit below find a) Find the total admittance, Yr b) Find the power factor of the network.…

A: a) This inductive reactance ,XL is given by, XL1= jωL1= j(200π)(9.56x10-3)  [∴ 1mH = 10-3]=…