Consider the glass sheet in the path of X-rays. When passes through this sheet X-rays found with intensity reduced by 30%. The value of absorption coefficient is : [Given In 1.428 = .356] X-гаys Sheet of glass mm (a) Always less than unity (b) Less than 70 but more than 55 (c) Less than 20 (d) Always more than unity but less than 20

Consider the glass sheet in the path of X-rays. When passes through this sheet X-rays found with intensity reduced by 30%. The value of absorption coefficient is : [Given In 1.428 = .356] X-гаys Sheet of glass mm (a) Always less than unity (b) Less than 70 but more than 55 (c) Less than 20 (d) Always more than unity but less than 20

University Physics Volume 3

17th Edition

ISBN:9781938168185

Author:William Moebs, Jeff Sanny

Publisher:William Moebs, Jeff Sanny

Chapter6: Photons And Matter Waves

Section: Chapter Questions

Problem 6.8CYU: Check Your Understanding An incident 71-pm X-ray is incident on a calcite target. Find the...

See similar textbooks

Similar questions

Please refer again to Figure 2. This time, the incident ray is coming in from water (n=1.33) rather than air. And this time, theta = 42.5 degrees, y = 28.6 cm and h = 1.07 cm. What is x now?
After passing a bone tissue with thickness 20 mm, the intensity of X-ray radiation was reduced by a factor 33of 5. Find linear and mass attenuation coefficients for the bone tissue having density ρ = 1.6 ·10 kg/m .
After passing a bone tissue with thickness 15 mm, the intensity of X-ray radiation was reduced by a factor of 3. Find linear and mass attenuation coefficients for the bone tissue having density ρ = 1.6 × 10³ kg/m³
X ray diffraction in Potassium Chloride (KCl) results in a first order maximum when 97 pm wavelength X rays graze the crystal plane at 8.5 degrees. Find the spacing between crystal plane?
Potassium chloride (KCI) has a set of crystal planes separated by a distance of d= 0.34 nm. At what glancing angle 0 to these planes would the first-order Bragg maximum occur for X-rays of wavelength 0.05 nm?
Check Your Understanding An incident 71-pm X-ray is incident on a calcite target. Find the wavelength of the X-ray scattered at a 60° angle. What is the smallest shift that can be expected in this experiment?
An X-ray scattering experiment is performed on a crystal whose atoms form planes separated by 0.440 nm. Using an X-ray source of wavelength 0.548 nm, what is the angle (with respect to the planes in question) at which the experimenter needs to illuminate the crystal in order to observe a first-order maximum?
When x - ray incident to the layer of Aluminum , and the transmitted intensity was 10 % from the original incident ray when the thickness of Aluminum was 2 cm , if the density of Aluminum is (2.7gm/cm .^3) , then the Half: Value Layer equal to 1.626 cm. O 0.601 cm . O 3.108 cm. O Please I need an answer within 30 minutes
After passing a bone tissue with thickness 15 mm, the intensity of X-ray radiation wasreduced by a factor of 3. Find linear and mass attenuation coefficients for the bone tissue havingdensity ρ = 1.6 ·103kg/m3.
At 293 K, the Bragg angle for X-ray peak (111) from a powdered gold metal specimen is 38.30o. If the same peak is detected at 493 K, calculate the angle. Assume gold metal has a coefficient of linear thermal expansion of 14.2 x10-6 K-1 and a length of 0.47 nm for its standard FCC unit cell.
A laser with 589 nm wavelength and a beam diameter of 2 mm is fed through a beam-expander,then aimed from the G.O. Jones building to the Canary Wharf tower at a distance of 2.75 km.What expansion factor is required for the beam-expander in order that the diffraction-limited spotat Canary Wharf tower has a diameter of 30 cm (defined as the diameter of the first dark ring) ?
During the deep X-ray therapy high energy X-rays are used. They are filtered by passing them through copper and aluminium plates. If the copper plate has thickness ?1 = 2 mm and aluminium plate ?2 =3 mm, find reduction in X-ray beam intensity. Linear attenuation coefficients for copper and aluminium are ?1 = 0.32 cm‐¹, and ?2 = 0.15 cm‐¹, respectively.