Consider the reaction. 2 Fe,0, – 4Fe + 30, Ali = +824.2 kJ The decomposition of 53.0 g of Fe,0; results in ) the release of 21800 kJ of heat. the release of 274 kJ of heat. the absorption of 274 kJ of heat. the release of 137 kJ of heat. the absorption of 21800 kJ of heat. O the absorption of 137 kJ of heat.

Consider the reaction. 2 Fe,0, – 4Fe + 30, Ali = +824.2 kJ The decomposition of 53.0 g of Fe,0; results in ) the release of 21800 kJ of heat. the release of 274 kJ of heat. the absorption of 274 kJ of heat. the release of 137 kJ of heat. the absorption of 21800 kJ of heat. O the absorption of 137 kJ of heat.

Chemistry: The Molecular Science

5th Edition

ISBN:9781285199047

Author:John W. Moore, Conrad L. Stanitski

Publisher:John W. Moore, Conrad L. Stanitski

Chapter4: Energy And Chemical Reactions

Section: Chapter Questions

Problem 54QRT

See similar textbooks

Similar questions

9.96 Most first aid "cold packs" are based on the endothermic dissolution of ammonium nitrate in water: NH4NO3(s)NH4+(aq)+NO3(aq) H= 25.69 kJ A particular cold pack contains 50.0 g of NH4NO3 and 125.0 g of water. When the pack is squeezed, the NH4NO3dissolves in the water. If the pack and its contents are initially at 24.0°C, what is the lowest temperature that this bag could reach? (Assume that the ammonium nitrate solution has a specific heat of 4.25J g-l K-l, and that the heat capacity of the bag itself is small enough to be neglected.)
9.61 Silane, SiH4, burns according to the reaction, SiH4+2O2SiO2+2H2O , with H=1429 kJ. How much energy is released if 15.7 g of silane is burned?
You have a large balloon containing 1.0 mol of gaseous water vapor at 80 C. How will each step affect the internal energy of the system? (a) The temperature of the system is raised to 90 C. (b) The vapor is condensed to a liquid, at 40 C.
9.83 A student performing a calorimetry experiment combined 100.0 mL of 0.50 M HCl and 100.0 mL of 0.50 M NaOH in a coffee cup calorimeter. Both solutions were initially at 20.0°C, but when the two were mixed, the temperature rose to 23.2°C. (a) Suppose the experiment is repeated in the same calorimeter but this time using 200 mL of 0.50 M HCl and 200.0 mL of 0.50 M NaOH. Will the T observed he greater than, less than, or equal to that in the first experiment, and why? (b) Suppose that the experiment is repeated once again in the same calorimeter, this time using 100 mL of 1.00 M HCl and 100.0 mL of 1.00 M NaOH. Will the T observed he greater than, less than, or equal to that in the first experiment, and why?
Shown below is a diagram depicting the enthalpy change of a chemical reaction run at constant pressure. a Is the reaction exothermic or endothermic? b What is the sign of H? c What is the sign of q? d If the reaction does no work, what is the sign of E for this process?
9.53 Using these reactions, find the standard enthalpy change for the formation of 1 mol of PhO(s) from lead metal and oxygen gas. PbO(s)+C(graphite)Pb(s)+CO(g) H = 106.8 kJ 2C(graphite)+O2(g)2CO(g) H= -221.0 kJ If 250 g of lead reacts with oxygen to form lead(II) oxide, what quantity of thermal energy (in kJ) is ahsorhed or evolved?
Combustion of table sugar produces CO2(g) and H2O( l). When 1.46 g table sugar is combusted in a constant-volume (bomb) calorimeter, 24.00 kJ of heat is liberated. a. Assuming that table sugar is pure sucrose, C12H22O11 (s), write the balanced equation for the combustion reaction. b. Calculate E in kJ/mol C12H22O11 for the combustion reaction of sucrose.
Nitromethane, CH3NO2, can be used as a fuel. When the liquid is burned, the (unbalanced) reaction is mainly CH3NO2(l) + O2(g) CO2(g) + N2(g) + H2O(g) a. The standard enthalpy change of reaction (Hvan ) for the balanced reaction (with lowest whole-number coefficients) is 1288.5 kJ. Calculate Hf0 for nitromethane. b. A 15.0-L flask containing a sample of nitromethane is filled with O2 and the flask is heated to 100.C. At this temperature, and after the reaction is complete, the total pressure of all the gases inside the flask is 950. torr. If the mole fraction of nitrogen (nitrogen) is 0.134 after the reaction is complete, what mass of nitrogen was produced?
Coal is used as a fuel in some electric-generating plants. Coal is a complex material, but for simplicity we may consider it to be a form of carbon. The energy that can be derived from a fuel is sometimes compared with the enthalpy of the combustion reaction: C(s)+O2(g)CO2(g) Calculate the standard enthalpy change for this reaction at 25C. Actually, only a fraction of the heat from this reaction is available to produce electric energy. In electric generating plants, this reaction is used to generate heat for a steam engine, which turns the generator. Basically the steam engine is a type of heat engine in which steam enters the engine at high temperature (Th), work is done, and the steam then exits at a lower temperature (Tl). The maximum fraction, f, of heat available to produce useful energy depends on the difference between these temperatures (expressed in kelvins), f = (Th Tl)/Th. What is the maximum heat energy available for useful work from the combustion of 1.00 mol of C(s) to CO2(g)? (Assume the value of H calculated at 25C for the heat obtained in the generator.) It is possible to consider more efficient ways to obtain useful energy from a fuel. For example, methane can be burned in a fuel cell to generate electricity directly. The maximum useful energy obtained in these cases is the maximum work, which equals the free-energy change. Calculate the standard free-energy change for the combustion of 1.00 mol of C(s) to CO2(g). Compare this value with the maximum obtained with the heat engine described here.
Explain in your own words what is meant by the term entropy. Explain how both matter spread and energy spread are related to the concept of entropy.
When 7.11 g NH4NO3 is added to 100 mL water, the temperature of the calorimeter contents decreases from 22.1 C to 17.1 C. Assuming that the mixture has the same specific heat as water and a mass of 107 g, calculate the heat q. Is the dissolution of ammonium nitrate exothermic or endothermic?
Explain what happens as a reaction starts with G0 (negative) and reaches the point where G=0.

SEE MORE QUESTIONS

Recommended textbooks for you

Chemistry: The Molecular Science

Chemistry

ISBN:

9781285199047

Author:

John W. Moore, Conrad L. Stanitski

Publisher:

Cengage Learning

Chemistry

ISBN:

9781305957404

Author:

Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:

Cengage Learning

Chemistry

ISBN:

9781133611097

Author:

Steven S. Zumdahl

Publisher:

Cengage Learning

General Chemistry - Standalone book (MindTap Cour…

Chemistry

ISBN:

9781305580343

Author:

Steven D. Gammon, Ebbing, Darrell Ebbing, Steven D., Darrell; Gammon, Darrell Ebbing; Steven D. Gammon, Darrell D.; Gammon, Ebbing; Steven D. Gammon; Darrell

Publisher:

Cengage Learning

Chemistry: An Atoms First Approach

Chemistry

ISBN:

9781305079243

Author:

Steven S. Zumdahl, Susan A. Zumdahl

Publisher:

Cengage Learning

Chemistry for Engineering Students

Chemistry

ISBN:

9781337398909

Author:

Lawrence S. Brown, Tom Holme

Publisher:

Cengage Learning

Chemistry: The Molecular Science

Chemistry

ISBN:

9781285199047

Author:

John W. Moore, Conrad L. Stanitski

Publisher:

Cengage Learning

Chemistry

ISBN:

9781305957404

Author:

Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:

Cengage Learning

Chemistry

ISBN:

9781133611097

Author:

Steven S. Zumdahl

Publisher:

Cengage Learning

General Chemistry - Standalone book (MindTap Cour…

Chemistry

ISBN:

9781305580343

Author:

Steven D. Gammon, Ebbing, Darrell Ebbing, Steven D., Darrell; Gammon, Darrell Ebbing; Steven D. Gammon, Darrell D.; Gammon, Ebbing; Steven D. Gammon; Darrell

Publisher:

Cengage Learning

Chemistry: An Atoms First Approach

Chemistry

ISBN:

9781305079243

Author:

Steven S. Zumdahl, Susan A. Zumdahl

Publisher:

Cengage Learning

Chemistry for Engineering Students

Chemistry