Consider two closed systems A and B. System A contains 3000 kJ of thermal energy at 20°C, whereas system B contains 200 kJ of thermal energy at 50°C. Now the systems are brought into contact with each other. Determine the direction of any heat transfer between the two systems.

Consider two closed systems A and B. System A contains 3000 kJ of thermal energy at 20°C, whereas system B contains 200 kJ of thermal energy at 50°C. Now the systems are brought into contact with each other. Determine the direction of any heat transfer between the two systems.

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter3: The First Law Of Thermodynamics

Section: Chapter Questions

Problem 62P: For a temperature increase of 10 at constant volume, what is the heat absorbed by (a) 3.0 mol of a...

See similar textbooks

Related questions

Q: Consider a well-insulated horizontal rigid cylinder that is divided into two compartments by a…

Q: The p-V diagram in the figure shows two paths along which a sample of gas can be taken from state a…

A: Introduction: It is known that the internal energy of a system is a point function i.e. it depends…

Q: A system is taken from state A to state B along two different paths 1 and 2. The heat absorbed and…

A: Given: A System is taken from state A to state B along two different paths 1 and 2.

Q: A system gains 2500 J of heat at a constant pressure of 1.26 x 10° Pa, and its internal energy…

A: Given: ∆Q=2500 J P = 1.26*105 Pa ∆ U =3870 J

Q: A quantity of oxygen gas is slowly compressed adiabatically in an insulated container to two-thirds…

Q: The heat of evaporation of water at atmospheric pressure is Lv 2260 kJ/kg. a. How much of this heat…

A: Scenario - Water is evaporated at atmospheric pressure. Heat of evaporation - It is amount of energy…

Q: In a system, 4 mol of water is condensed. (a) If 157 kJ of heat is lost by the system to the…

Q: A steam engine operation between 150 C and 550 C. What is the theoretical maximum thermal…

A: Given value--- low temperature = 150 degree C. higher temperature = 550 degree C. We have to…

Q: What is the change in internal energy of a system that takes in 3.33 106 J of heat, and does 4.50…

A: According to the first law of thermodynamics,∆U=Q-W.......(1)Where,∆U is the change in internal…

Q: A stationary mass of gas is compressed without friction from an initial state of 2 m^3 and 2 × 10 ^5…

A: Given data: Initial volume is, V1=2 m3. Pressure is, P1=P2=P=2×105 N/m2. Final volume is, V2=1 m3.…

Q: 4.0 mol of monatomic gas A initially has 9000 J of thermal energy. It interacts with 3.0 mol of…

A: At thermal equilibrium temperature of both gases become same. Therefore, Energy of monoatomic gas =…

Q: The p-V diagram in the figure shows two paths along which a sample of gas can be taken from state a…

Q: What is the magnitude of energy (in MJ) that must be removed to freeze 366 L of water with a density…

A: Given:- The volume of the water V = 366 L The water with a density = 999.8 Kg/m3 that is already…

Q: How much heat is needed to raise the temperature of 2 kg of water 5K? a. 41800J b. 42800J c. 43800J…

Q: The P-V diagram relates to a fixed quantity of O2, assumed to be an ideal gas. The temperature at…

A: the internal energy is the difference between the heat and work done .the expression for the…

Q: During a compression at a constant pressure of 250 Pa, the volume of an ideal gas decreases from…

A: We know that the expression for the change in the internal energy of the gas is given as below

Q: A gas is compressed from 600 cm^3 to 200 cm^3 at a constant pressure of 400 kPa. At the same time,…

Q: System 1 is at 0 °C and system 2 is at 0 °F. If these systems are placed in thermal contact, which…

A: System 1 is at 0 °C and system 2 is at 0 °F

Q: three moles of an ideal monatomic gas have a pressure of 3.0 atm and a temperature of 100 C. if the…

A: Given that, Temperature(T1)=100°C Temperature (T2)= 500°C…

Q: A force, P = 3.0 N, acts at 40 degrees to the horizontal on an object as shown in the figure. The…

A: Let work dome by friction is Wf Work done by P (WP) = (PCos40°)×2.5 WP = 3×Cos40° × 2.5 = 5.74 J

Q: A piece of iron block moves across a rough horizontal surface before coming to rest. The mass of the…

Q: Can the temperature of a system not increase, even if the system an amount of heat Q? absorbs an (A)…

A: To explain : can the temperature of a system not increase , even if the system absorbs an amount of…

Q: Radiation is the process of heat transfer in which heat flows from a _____________________, in a…

A: Radiation is the process in which heat is transferred through electromagnetic waves. In this process…

Q: If 555 cal of heat is added to gas, and 555 J of work is done by the gas while it expands, what is…

A: Given Data : The amount of heat added to the gas is given as Q = 555 cal. The amount of work done by…

Q: An arrow in a bow in a bow has 270 (J) of potential energy. Assuming 100 (J) of energy were…

Q: What is the change in internal energy of a system which does 4.50×105J of work while 3.00×106 J of…

A: The change in internal energy(ΔU) of a system.given,workdone(W)=4.50×105 J Heat goes…

Q: When amount of heat Q is added to a system, and no work is done on it or done by it, its internal…

A: According to the first law of thermodynamic the expression for internal energy is ∆U=Q-WAs the work…

Q: Which of the following statements about heat transfer is NOT true? O The rate at which heat is…

Q: When 25.6J was added as heat to a particular ideal gas, the volume of the gas changed from 45.4cm 2…

A: Given Q= 25.6 J V1 =45.4 cm3 V2 = 97.7 cm3

Q: If I add 11664 J of energy to an ideal gas inside a balloon, causing the internal energy to increase…

A: Write the given values with the suitable variables. Q=11664 JΔU=7278 J Here, Q and ΔU are the amount…

Q: Which of the following statements is true regarding calorimetry? No heat is transferred from the…

Q: A mole of an ideal gas of vibrating diatomic molecules at initial temperature T is expanded from an…

Q: If I add 12,183 J of energy to an ideal gas inside a balloon causing the internal energy to increase…

A: Given data: Q=12183 J∆U=5185 JNeed to determine the work is done on the environment by the gas as…

Q: A quantity of a monatomic ideal gas undergoes a process in which both its pressure and volume are…

A: Given,

Q: (P.Ç.1.1) A sample of an ideal gas is initially at a volume of 3.5 L. The gas expands to a volume of…

A: Given Data : The initial volume of the gas is given as Vi = 3.5L. The final volume of the gas is…

Q: 15.3.1. An insulated container is filled with a mixture of water and ice at zero °C. An electric…

Q: Consider a surface at -5ºC in an environment at 25ºC. The maximum rate of heat that can be emitted…

Q: You add 2196 J of heat to a system at constant pressure of 1.5 x105 Pa. While doing so, its…

A: The total of the kinetic & potential energies of a system's atoms and molecules is called…

Q: A total of 105 J of work is done on a gaseous refrigerant as it undergoes expansion. If the internal…

Q: The first low of the thermodynamics shows U = Q - W, where U is a changing internal energy of the…

A: Given:Heal flown out of the system = 15 kJWork done by the system = 30 kJ

Q: In a calorimetry experiment, two liquid substances X and Y with the same mass are placed in separate…

A: given,The specific heat of the substances are related by cX=2cY. two liquid substances X and Y with…

Q: In an isochoric process, one mole of an ideal gas of rigid diatomic molecules at volume V is taken…

Q: For a temperature increase of 10 °C at constant volume, what is the heat absorbed by (a) 3.0 mol of…

A: (a) Given: The increase in temperature is 10 degrees Celcius. The number of moles is 3.0 mol.

Question

Consider two closed systems A and B. System A
contains 3000 kJ of thermal energy at 20°C, whereas system B
contains 200 kJ of thermal energy at 50°C. Now the systems
are brought into contact with each other. Determine the direction
of any heat transfer between the two systems.

Video Video

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

For a temperature increase of 10 at constant volume, what is the heat absorbed by (a) 3.0 mol of a dilute monatomic gas; (b) 0.50 mol of a dilute diatomic gas; and (c) 15 mol of a dilute polyatomic gas?
What is the change in internal energy of a system which does 4.50 X 105 J of work while 3.00 X 106 J of heat transfer occurs in a system, and 8.00 X 106 J of heat transfers to the environment?
Consider the change in the internal energy of a system. -What is the change in the internal energy, in joules, of a system that does 4.725 × 105 J of work, while 3.2 × 106 J of heat is transferred into the system and 7.8 × 106 J of heat is transferred from the system to the environment?
A heat engine under development is expected to transfer heat from reservoir A to reservoir B. Which is a requirement for the two reservoirs? A) The temperature of reservoir A must be greater than the temperature of reservoir B. B) The temperature of reservoir A must be equal to the temperature of reservoir B. C) The internal energy of reservoir A must be greater than the internal energy of reservoir B. D) internal energy of reservoir A must equal the internal energy of reservoir B.
One gram of water (1 cm3) becomes 875 cm3 of steam when boiled at a constant pressure of 1 atm (1.013 x 105 Pa). The heat of vaporization at this pressure is Lv = 2.256 x 106 J/kg. Compute a) the heat absorbed by the water b) the work done by the water when it vaporizes and c) its increase in internal energy.
What happens to the internal energy of an insulated system when mechanical work is done on it? What happens to its temperature assuming no change of phase occurs? A: The internal energy increases, but the temperature decreases. B:Both decrease. C:The internal energy decreases, but the temperature increases. D:Both increase.
A block of 10.0 kg of solid gold at its melting point of 1,063.00°C changes phase to liquid gold at 1,063.00°C and then changes phase back to solid gold at 1,063.00°C. The latent heat of fusion for gold is 6.44×104 J/kg. What is the total change in internal energy of the gold during this whole process?
A body has 10J of heat energy in a particular state. At the same state it has an internal energy of 20J. Assume no work is done, what will happen to the internal energy if 10J of heat is added to the system? A. None of the above B. Heat energy = 15J, Internal energy = 30J C. Heat energy = 20J, Internal energy = 35J D. Heat energy = 15J, Internal energy = 35J
What is the change in internal energy of a system which does 4.50×105J of work while 3.00×106 J of heat transfer occurs into the system, and 8.00×106 J of heat transfer occurs to the environment?
A thirsty nurse cools a 2.30 LL bottle of a soft drink (mostly water) by pouring it into a large aluminum mug of mass 0.257 kgkg and adding 0.123 kgkg of ice initially at -14.0 ∘C∘C. If the soft drink and mug are initially at 20.9 ∘C∘C, what is the final temperature of the system, assuming no heat losses?
The 2nd Law of thermodynamics states that the change in internal energy of a system equals the net heat transfer into the system minus the net work done by the system.True or False
Consider a well-insulated horizontal rigid cylinder that is divided into two compartments by a piston that is free to move, but does not allow either gas to leak into the other side. Initially, one side of the piston contains 1 m3 of N2 gas at 500 kPa and 120°C while the other side contains 1 m3 of He gas at 500 kPa and 40°C. Now thermal equilibrium is established in the cylinder as a result of heat transfer through the piston. Using constant specific heats at room temperature, determine the final equilibrium temperature in the cylinder. What would your answer be if the piston were not free to move?