Current Attempt in Progress m d D D. d m The device shown above is made of low-mass rods and four point masses. The smaller masses (m = 0.20 kg) are a distance d = 0.35 m from the center, and the larger masses (M = 0.63 kg) are a distance D = 0.19 m from the center. The device is initially rotating about its center with a period of 0.67 s. You do 9.4 J of work to make the device rotate faster. What is its new period? New period = i

Current Attempt in Progress m d D D. d m The device shown above is made of low-mass rods and four point masses. The smaller masses (m = 0.20 kg) are a distance d = 0.35 m from the center, and the larger masses (M = 0.63 kg) are a distance D = 0.19 m from the center. The device is initially rotating about its center with a period of 0.67 s. You do 9.4 J of work to make the device rotate faster. What is its new period? New period = i

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter10: Rotational Motion And Angular Momentum

Section: Chapter Questions

Problem 29PE: While exercising in a fitness center, a man lies face down on a bench and lifts a weight with one...

See similar textbooks

Similar questions

A hollow cylinder that is rolling without slipping is given a velocity of 5.0 m/s and rolls up an incline to a vertical height of 1.0 m. If a hollow sphere of the same mass and radius is given the same initial velocity how high vertically does it roll up the incline?
A 40.0-kg solid cylinder is rolling across a horizontal surface at a speed of 6.0 m/s. How much work is required to stop it?
Two particles of equal mass travel with the same speed in opposite directions along parallel lines separated by a distance d Show that the angular momentum of this two- particle system is the same no matter what point is used as the reference for calculating the angular momentum.
A roller coaster has mass 3000.0 kg and needs to make it safely through a vertical circular loop of radius 50.0 m. What is the minimum angular momentum of the coaster at the boom of the loop to make it safely through? Neglect friction on the track. Take the coaster to be a point particle.
A top has moment of inertia 3.2104kgm2 and radius 4.0 cm from the center of mass to the pivot point. If it spins at 20.0 rev/s and is precessing, how many revolutions does it precess in 10.0 s?
The blades of a wind turbine are 30 m in length and rotate at a maximum rotation rate of 20 rev/min. (a) If the blades are 6000 kg each and the rotor assembly has three blades, calculate the angular momentum of the turbine at this rotation rate. (b) What Is the torque require to rotate the blades up to the maximum rotation rate in 5 minutes?
A thin rod of length 2.65 m and mass 13.7 kg is rotated at anangular speed of 3.89 rad/s around an axis perpendicular to therod and through one of its ends. Find the magnitude of the rodsangular momentum.
The precession angular velocity of a gyroscope is 1.0 rad/s. If the mass of the rotating disk is 0.4 kg and its radius is 30 cm, as well as the distance from the center of mass to the pivot, what is the rotation rate in rev/s of the disk?
A pendulum consists of a rod of mass 2 kg and length 1 m with a solid sphere at one end with mass 0.3 kg and radius 20 cm (see the following figure). If the pendulum is released from rest at an angle of 30 , what is the angular velocity at the lowest point?
A buzzard (m = 9.29 kg) is flying in circular motion with aspeed of 8.44 m/s while viewing its meal below. If the radius ofthe buzzards circular motion is 8.00 m, what is the angularmomentum of the buzzardaround the center of its motion?
Using the parallel axis theorem, what is the moment of inertia of the rod of mass m about the axis shown below?
Consider two objects with m1 m2 connected by a light string that passes over a pulley having a moment of inertia of I about its axis of rotation as shown in Figure P10.44. The string does not slip on the pulley or stretch. The pulley turns without friction. The two objects are released from rest separated by a vertical distance 2h. (a) Use the principle of conservation of energy to find the translational speeds of the objects as they pass each other. (b) Find the angular speed of the pulley at this time.