cylinder contains an amount of gas. At pressure of 470 kPa and at temperature of 27 ̊C, the gas occupies a volume of 0.03 m3. It is then compressed according to Boyle’s law until its pressure is 1.3 MPa, and then expanded according to Charles’ Law until its volume is 0.02 m3. Calculate the final temperature of the gas.

cylinder contains an amount of gas. At pressure of 470 kPa and at temperature of 27 ̊C, the gas occupies a volume of 0.03 m3. It is then compressed according to Boyle’s law until its pressure is 1.3 MPa, and then expanded according to Charles’ Law until its volume is 0.02 m3. Calculate the final temperature of the gas.

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter31: Gas Heat

Section: Chapter Questions

Problem 5RQ: The specific gravity of natural gas is A. 0.08. B. 1.00. C. 0.42. D. 0.60.

See similar textbooks

Similar questions

Water at 210°C is heated, which increases the internal energy of the water by 1000 kJ/kg. Initially the quality of the system is 0.9. What is the final temperature, in °C, if the final pressure is 1.8 MPa? Report your answer to one decimal place.
A piston-cylinder arrangement contains water at 110°C, 85% quality with a volume of 1 L. What is the initial mass, in grams? The system is heated, causing the 150-mm-diameter piston to rise and encounter a linear spring with k = 800 kN/m. Calculate the specific internal energy (kJ/kg) at this instant knowing that the measured volume is 1.65 L. The heating continues and compresses the spring in the process. When the piston encounters the stops, the pressure is 200 kPa. What is the temperature (in °C) and entropy (in J/K) at this point? Heating continues until the pressure reached 300 kPa. What is the volume, in L at this instant? Illustrate the process in separate P-v and T-v diagram. Note:1000 L = 1m3. Hint: Draw the FBD of the piston in each state.
A piston-cylinder arrangement contains water at 112°C, 84% quality with a volume of 0.98 L. What is the initial mass, in grams? The system is then heated, causing the 150-mm-diameter piston to rise and encounter a linear spring with k = 800 kN/m. Calculate the specific internal energy (kJ/kg) at this instant knowing that the measured volume is 1.65 L. The heating continues and compresses the spring in the process. When the piston encounters the stops, the pressure is 200 kPa. What is the temperature (in °C) and entropy (in J/K) at this point? Heating then continues until the pressure reaches 300 kPa. What is the volume, in L, at this instant? Illustrate the complete process in separate P-v and T-v diagrams.
SECOND LAW OF THERMODYNAMICS write your soln. complete. draw a sketch and explain if necessesary THANK YOU! answer it in 1hr
A coal sample gave the following analysis by weight, Carbon 66.9 per cent, Hydrogen 6.58 per cent, Oxygen 8.77 per cent, the remainder being incombustible. For 20% excess air , determine actual weight of air required per kg of coal. Round your answer to two decimal places.
An engine uses a fuel which, when tested at 35°C with a 15.6°C hydrometer showed a relative density of 0.905. What is the HHV of this in Btu/lbm
what is the enthalpy of water at a pressure of 1000 kPa and a temperature of 50 oC, in kJ/kg * 632.18 1085.7 2745.9 none of the given anwers 209.34 2113.8 With all explanation please
A Boeing 767 due to fly from Montreal to Edmontonrequired refueling. Because the fuel gauge on the aircraft was not working, a mechanic used a dipstick todetermine that 7682 L of fuel were left on the plane.The plane required 22,300 kg of fuel to make the trip. Inorder to determine the volume of fuel required, thepilot asked for the conversion factor needed to converta volume of fuel to a mass of fuel. The mechanic gavethe factor as 1.77. Assuming that this factor was in metric units the pilot calculated the volume to beadded as 4916 L. This volume of fuel was added andthe 767 subsequently ran out the fuel, but landed safelyby gliding into Gimli Airport near Winnipeg. The errorarose because the factor 1.77 was in units of pounds perliter. What volume of fuel should have been added?
What ideal gas process is shown by the graph?
SG of Water=1.0 SG of Mercury=13.6 SG of n-Octane=0.65
18 - A cylindrical tank with a diameter of 20 cm and a height of 50 cm was filled with water to a height of 30 cm. If the tank is rotated about the vertical axis of symmetry at a constant speed of 21 rad/s, what will be the pressure difference between the bottom center and bottom edge of the tank? a) 1750 Pa B) 1045 Pa NS) 3327 Pa D) 2205 Pa TO) 1125 Pa
1. A driver fills an 18.9L steel gasoline can with gasoline at 15 deg C right up to the top. He forgets to replace the cap and leaves the can in the back of his truck. The temperature climbs to 42 deg C by 1P.M. how much gasoline spills out of the can?