polyphaseplease answer as soon as possible (i)Describe an unbalanced or asymmetrical of three-phase electrical system.(ii)State two (2) effects of voltage unbalance in low voltage (LV) of distributionsystem.

Answered: Describe an unbalanced or asymmetrical…

Describe an unbalanced or asymmetrical of three-phase electrical system. i) State two (2) effects of voltage unbalance in low voltage (LV) of distribution system.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.13MCQ: Consider the adopted per-unit system for the transformers. Specify true or false for each of the...

See similar textbooks

Related questions

Q: Line to ground fault has the highest probability in the power system O True False

A: Need to find true false

Q: Three zones of a single-phase circuit are identified in Figure. The zones are connected by…

A: per unit system The ratio of actual value to the base or reference value in the same unit is called…

Q: What is load line and what is duty cycle?

Q: Which among the following faults does mostly happen in 3-phase power systems? Single line to ground…

A: As 3 phase fault in power system are, 1. Single Line to Ground fault 2. Three phase short circuit 3.…

Q: Discuss basic character of smart grid

A: Smart grid is one type of the electrical grid that is used efficiently and able to integrate the…

Q: ix. What is the purpose of surge tank in hydro electric plant?

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: State the condition for a three-phase system to be considered as a balance system.

A: The three phase voltages are not cophasal. they are mutually displaced by each other.

Q: For the circuit shown, the normal operating values shown are known. If a symmetrical three-phase…

A: We can redraw the per-phase equivalent circuit as

Q: With a neat sketch discuss the working of a Grid - connected system for power generation and explain…

A: According to guidelines we need to solve only the first question. According to the question we have…

Q: Figure 8.26 shows a single-line diagram of a three-phase, interconnected generator- reactor system,…

Q: Describe the effects of harmonics on power distribution system.

A: Harmonics are the undesirable noises in the power distribution system.It usually occurs due to the…

Q: What is the difference between modules and ways ? and how many ways we need to construct a…

A: The Electrical distribution system consists of some standardized terminologies in which the…

Q: A single-line diagram of a three-phase balanced system is given below. A bolted three- phase short…

Q: In AC regulator, compare between the (a) resistive and electronic voltage control, (b) On- off and…

A: (a) Comparison between Resistive voltage control and Electronic voltage control, Resistive control:…

Q: 1.2 For each set of voltages, state whether or not the mCE voltages form a balanced three-phase set.…

A: The explanation is as folows.

Q: Calculate the initial symmetrical short circuit current that will occur when a 3 phase short circuit…

A: We can re draw the given system as Let the base MVA of the system i.e SB 500MVA and base Voltage…

Q: The positive-, negative-, and zero-sequence reactances of a 15-MVA, 11-kV, three-phase, wye-…

A: Given data about a three phase, wye-connected generator is, Positive sequence reactance X1=11%=j0.11…

Q: In case of unbalanced 3-Φ, 4-wire system % voltage drop is… not possible to estimate same as in…

A: it should estimate for each phase .

Q: I. Draw the reactance diagram for the following power system in per unit using base power = 50 MVA…

Q: For the circuit shown, if a symmetrical three-phase fault occurs in node 2, determine a. The…

Q: Write about voltage drop and power loss for Radial d.c distribution system.

A: In the radial dc distribution system, various feeders are connected to the single substation such…

Q: Calculate the zero, positive, and negative sequence current of phase "a" for the following phase…

Q: Mention and discuss the uncertainties affecting the power system operation and planning indices.

A: Uncertainty is associated with the massive power generation of the renewable energy. The renewable…

Q: What are the Salient Features of Indian Grid Codes for Wind Power Generation

A: The Salient Features of Indian Grid Codes for Wind Power Generation are given below- IEGC stands…

Q: What happens if a new pi equivalent circuit given the busbar admintas matrix and reactance and…

A: If a new element is added in two buses, then it will not affect the other bus matrix elements. As…

Q: three phase generator with constant terminal voltages gives the following currents when under fault:…

A: The solution can be achieved as follows.

Q: 5.20 Three individual 3-phase 400 kV power system, each one of which consists of a generator…

A: we need to explain about fault level if extra lines connected.

Q: 2_ What case/cases in which the measured phase current include the three symmetrical components (…

Q: for the same alternator, the ratio of rated KVA when connected as 3-phase winding alternator to when…

A: For 3-phase connection of the windings, the phase spread will be ψ=π3=60o So, distribution factor…

Q: Discuss FOUR (4) advantages of per-unit system.

Q: You are given that the system shown in Figure 4.25 has a 110/220 kV autotransformer. The positive-…

A: Since there is single line to ground fault in phase a. So, fault current in phase a will be IF and…

Q: (b) Explain the steps involved in analysing balanced bolted fault in power system using Zbus method,…

A: Admittance matrix and impedence matrix is very important to analyze the power system .Admittance…

Q: Write a conclusion about voltage drop and power loss calculations for Ring d.c distribution system.

A: Ring DC distribution system: It is the system for distributing the power. In this system, the first…

Q: Consider a 3-phase transmission line operating at 66 KV and connected through a 1000 KVA transformer…

Q: In a 3 phase, 3 wire system, it has normal voltage of 10.4kV line to line fault occurs at generator…

A: For the 3- phase line to line the positive sequence phase current is evaluated as:

Q: What is the negative sequence component

Q: Q1. A// Choose the correct answer: 1. One of the advantage of using a per unit system in power…

A: According to guidelines we are allowed to do only first 3 questions , please post again for…

Q: The making current of 3-phase breaker with rating 2000 MVA, 33 kV will be

A: Given, Power rating, S = 2000 MVA Voltage rating, V = 33 kV

Q: Q3: Derive the relationship between positive and negative sequence components when single phasing…

A: Single phasing Three phase supply is fed to a load e.g. induction motor When one of the phase is get…

Q: With a sketch of block diagram, describe the importance of smart grid in modern electric power…

A: Smart power grid integrate the various renewable energy resources such as wind farm,hydro electric…

Q: 6.1. A power system network is shown in Figure 47. The generators at buses 1 and 2 are represented…

A: The power system network is shown below,

Q: 2- The Purpose of using Unbalanced Three-phase Systems:

A: The purpose of using unbalanced three phase system is

Q: All Choose the correct answer: 1. One of the advantage of using a per unit system in power system…

A: Per unit quantity is equal to the division of actual quantity and base quantity. There are two types…

Q: Q1. All Choose the correct answer: 1. One of the advantage of using a per unit system in power…

A: As per the guidelines of Bartley we supposed to answer first three subpart only.

Q: Each line of a 3-phase system is suspended by a string of 3 similar insulators. If the voltage…

A: The solution can be achieved as follows.

Q: Why the elements of Jacobian matrix belong to derivative of reactive power of a voltage controlled…

A: Voltage-controlled bus: It is also called a generator bus or PV bus. In this bus, the known…

Q: A 10 MVA, 6-6 kV, 3-phase star-connected alternator having a reactance of 20% is connected through a…

A: The last digits of student ID is 21. Given information We need to draw the transmission line and…

Q: In a 3-phase, 4 wire unbalanced system, the current in neutral wire is 18 A. The magnitude of zero…

A: Given a 3-phase, 4 wire unbalanced system having, The current in neutral wire, IN=18 A

Q: A three-phase, 50 Hz, 800-kV tranmission line

A: Since you have asked too many questions, I will answer part a, you can ask the other question in a…

Question

polyphase

please answer as soon as possible

(i)
Describe an unbalanced or asymmetrical of three-phase electrical system.
(ii)
State two (2) effects of voltage unbalance in low voltage (LV) of distribution
system.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Introduction

VIEW

Explanation

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What are the hazards of phase failure and phase reversal?
Consider the adopted per-unit system for the transformers. Specify true or false for each of the following statements: (a) For the entire power system of concern, the value of Sbase is not the same. (b) The ratio of the voltage bases on either side of a transformer is selected to be the same as the ratio of the transformer voltage ratings. (c) Per-unit impedance remains unchanged when referred from one side of a transformer to the other.
Three single-phase two-winding transformers, each rated 3kVA,220/110volts,60Hz, with a 0.10 per-unit leakage reactance, are connected as a three-phase extended autotransformer bank, as shown in Figure 3.36(c). The low-voltage winding has a 110 volt rating. (a) Draw the positive-sequence phasor diagram and show that the high-voltage winding has a 479.5 volt rating. (b) A three-phase load connected to the low-voltage terminals absorbs 6 kW at 110 volts and at 0.8 power factor lagging. Draw the per-unit impedance diagram and calculate the voltage and current at the high-voltage terminals. Assume positive-sequence operation.
Three single-phase, two-winding transformers, each rated 450MVA,20kV/288.7kV, with leakage reactance Xeq=0.10perunit, are connected to form a three-phase bank. The high-voltage windings are connected in Y with a solidly grounded neutral. Draw the per-unit equivalent circuit if the low-voltage windings are connected (a) in with American standard phase shift or (b) in Y with an open neutral. Use the transformer ratings as base quantities. Winding resistances and exciting current are neglected.
Discuss with block diagram, the principle of operation of single phase energy meter.
c) Briefly explain about single phase and three phase power supply with diagrams.
Discuss the role of power system protection in ensuring the safety and reliability of electrical grids.
Discuss the concept of electrical grid resilience and strategies for minimizing power outages and disruptions.
Explain the importance of power system protection. Discuss various types of protection devices and strategies used to safeguard electrical infrastructure from faults and disturbances.
“Electronic regulators are better than resistive ones in many aspects to control AC power” – explain with suitable examples and aspects. Out of on-off and phase control used in AC regulator, describe which one is better and why. Define a cycloconverter and write its application areas.
Describe the concept of power system harmonics and their impact on the quality of electrical supply.
Write a conclusion about voltage drop and power loss calculations for Ring d.c distribution system.