Answered: Determine the resultant R of the three…

Determine the resultant R of the three forces acting on the simple truss. Specify the points on the x and y axes through which R must pass. 30° 20 kN 25 kN 5 m 6 m 3 m 3 m 30 kN

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter10: Rotational Motion

Section: Chapter Questions

Problem 32P

See similar textbooks

Related questions

Q: The members of a truss are pin connected at joint 0. Determine the magnitude of F and its angle 0…

Q: Calculate the forces in members CG and CF for the truss shown. 2 kN 2 m B 2 m C 2 m 4 kN 3 m F

A: SOlution: to find the force in CG and CF

Q: A uniform plank of length 2.00 m and mass 30.0 kg is supported by three ropes as indicated by the…

Q: A horizontal beam weighing 300 N is attached to a wall. It is supported by a cable which makes an…

Q: Determine the magnitude of the forces acting in the wire P and the strut Q. 1.5 m 2.0 m 100N

Q: Problem A uniform horizontal beam 5.00 m long and weighting 3.00 × 102 N is attached to a wall by a…

Q: 4/6 Calculate the force in each member of the loaded truss. E D 2 kN 3 m 3 m 3 m A C B Problem 4/6

A: The external applied force is, F=2 kN

Q: 37° 10 m A uniform beam of length 10 m and weight 60 N is attached to a wall by a cable as shown in…

Q: 1. (i) The members of a truss are pin connected at joint O. Determine the magnitudes of F, and F,…

A: SOlution:

Q: The wooden sign is supported by three chains attached to the ceiling (AC, AB & AD) If the tension in…

A: According to guidelines we are suppose to do only three part from multipart questions. Kindly repost…

Q: The truss is subjected to the system of forces as shown in the following figure. The truss is…

Q: The boom in the figure is 2m long and weighs 100 N. If the 800N load is suspended 50cm from the end,…

Q: 3. The members of a truss are pin-connected at joint O. Determine the magnitudes of F1 and F2 for…

A: Solution:

Q: The system in the figure is in equilibrium. A concrete block of mass 267 kg hangs from the end of…

Q: A horizontal L=1.5 m long mb=D14 kg uniform bar is hinged on the left end and pulled at the right…

Q: A 10 m ladder with a mass of 15 kg leans against the wall. If the ladder is in static equilibrium,…

A: Given. m = 15 Kg L = 10m Concept - Force balancing in all directions.

Q: A ladder weighing 180 N is set against the wall and does not slip. There is friction between the…

A: Given: The weight of the ladder is 180 N. There is no friction force between the wall and ladder.

Q: 5.00 m 3.00 m 4.00 m 300 N 6. The horizontal beam in the figure weighs 150 N, and its center of…

A: Net torque on the beam about hinge is zero. Mg×4 + mg×2 = T( Sin37) × 4 Given Mg = 300 N mg = 150 N…

Q: A uniform beam of length L= 0.18 m and mass mb=0.83 kg is pinned at one end to a vertical wall. A…

A: The weight of the beam acts on the midpoint of the beam at L/2, in downward direction. The tension…

Q: angles = 24.8° and 9 = 57.0°, find (a) the tension T in the cable and the (b) horizontal and (c)…

Q: A uniform horizontal beam with a length of 8 m and a weight of 200 N is attached to a wall by a pin…

Q: The system in the figure is in equilibrium. A concrete block of mass 327 kg hangs from the end of…

Q: Determine the load in member AB of the pin-connected truss 3m 3m 1 m 4 m 2m A 81 B 15 68 KN E www

A: given the load in member AB of the pin-connected truss is

Q: When the structure shown below is supported at point P, it is in equilibrium. Find the magnitude of…

A: Draw the free-body diagram of the system.

Q: L d- ms A horizontal L=1.3 m long mb=15 kg uniform bar is hinged on the left end and pulled at the…

Q: The system in the figure is in equilibrium. A concrete block of mass 203 kg hangs from the end of…

A: Given : Mass of concrete block (Mb) = 203 kg Mass of strut (Ms)= 57.1 kg φ = 29.7°θ= 62.4° Let the…

Q: A sign is supported by a uniform horizontal boom of length 3.10 m and weight 72.0 N. A cable,…

A: In the system is in equilibrium so we know \sum F = 0∑F=0 and \sum\tau = 0∑τ=0. First we use the net…

Q: The system in the figure is in equilibrium. A concrete block of mass 333 kg hangs from the end of…

Q: A person is standing on a section of uniform scaffolding as shown has a ms = 22.0 kg mass and is…

A: A person is standing on a section of uniform scaffolding as shown in the figure. The section of…

Q: The following uniform beams are pivoted about their center of mass. Which of them is in static…

Q: The system in the figure is in equilibrium. A concrete block of mass 241 kg hangs from the end of…

A: Mass of concrete block ( M ) = 241 kg Mass of struct ( m ) = 47.6 kg Acceleration due to gravity (…

Q: Current Attempt in Progress The system in the figure is in equilibrium. A concrete block of mass 248…

Q: A crate of mass 523 kg is hanging at the end of a uniform beam of mass 112 kg. If the angle between…

Q: Determine the resultant R (single equivalent force) of the three forces acting on the simple truss.…

Q: A uniform plank of length 2.00 m and mass 30.0 kg is supported by three ropes, as indicated by the…

A: The solution is given by drawing FBD and applying rules of summation of forces and moments.

Q: The system in the figure is in equilibrium. A concrete block of mass 314 kg hangs from the end of…

A: GIVEN : mass of block, m = 314 kg mass of uniform strut, M = 50.6 kg strut angle, θ = 59.0° φ =…

Q: A uniform beam of length 12.0 m and weight 690 N is connected to a wall by a bolt, and is supported…

Q: The system in the figure is in equilibrium. A concrete block of mass 220 kg hangs from the end of…

A: We know that We have given that The system in the figure is in equilibrium. A concrete block of mass…

Q: A weightless strut, hinged to a wall, is used to support a 200.0 N block as shown. The horizontal…

A: Given data: Weight of the block, W=200 N

Q: The Howe roof truss shown carries the given loads. The wind loads are perpendicular to the inclined…

Q: 1001 N uniform beam is attached to a vertical wall at one end and js supported by a cable at the…

Q: Determine the resultant R (single equivalent force) of the three forces acting on the simple truss.…

A: In this question we have to determine the resultant R (single equivalent force) of the three forces…

Q: 2 kN F 3 kN 3 kN G E Az = 0 A 30° 60 60° 60% 60° 30 -3 m 3 m -3 m- Ay = 4 kN D, = 4 kN

A: In this question we have to determine the force in members AG and FB of the roof truss as shown in…

Q: 1. The horizontal beam AB shown has a mass of 2.04 kg with center of gravity at its center. Find: A…

A: Consider the known data as below. Mass at the middle of the beam, m=2.04 kg Gravity, g=9.81 ms2…

Q: Find the smallest and largest value of P to maintain equilibrium when the weight of the rectangular…

Q: The system in the figure is in equilibrium. A concrete block of mass 345 kg hangs from the end of…

A: Given, Given,mass of the concrete block, M = 345 kgmass of unifomr strut, m = 56.1 kgφ =38.4°θ…

Q: A uniform bridge span weighs 50.0x 10° N and is 40.0 m long. An automobile weighing 15.0 x10° N is…

Q: 2 m 45 2 m 2 m 2 m F F F

Concept explainers

Rotational Equilibrium And Rotational Dynamics

In physics, the state of balance between the forces and the dynamics of motion is called the equilibrium state. The balance between various forces acting on a system in a rotational motion is called rotational equilibrium or rotational dynamics.

Equilibrium of Forces

The tension created on one body during push or pull is known as force.

Question

7. Determine the resultant R of the three forces acting on the simple truss.
Specify the points on the x and y axes through which R must pass.
30
20 kN
25 kN
5 m
6 m
3 m
3 m
30 kN

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Suppose the weight of the drawbridge in Figure 9.34 is supported entirely by its hinges and the opposite shore, so that its cables are slack. (a) What fraction of the weight is supported by the opposite shore if the point of support is directly beneath the cable attachments? (b) What is the direction and magnitude of the force the hinges exert on the bridge under these circumstances? The mass of the bridge is 2500 kg.
A uniform horizontal strut weighs 400.0 N. One end of the strut is attached to a hinged support the wall and the other end of the strut is attached to a sign that weighs 200.0 N The strut is also supported by a cable attached between the end of the strut and the wall. Assuming that the entire weight of the sign is attached at the very end of the s find the tension in the cable and the force at the hinge of the strut.
A uniform drawbridge must be held at a 37.5 ∘∘ angle above the horizontal to allow ships to pass underneath. The drawbridge weighs 45000 NN, is 16.5 mm long, and pivots about a hinge at its lower end. A cable is connected 3.00 mm from the hinge, as measured along the bridge, and pulls horizontally on the bridge to hold it in place. 1)What is the tension in the cable? 2)Find the magnitude of the force the hinge exerts on the bridge. 3)Find the direction of the force the hinge exerts on the bridge. 4)If the cable suddenly breaks, what is the initial angular acceleration of the bridge?
If the roller at B can sustain a maximum load of 4.5 kN, determine the largest magnitude of each of the three forces F that can be supported by the truss.
a 1001 N uniform beam is attached to a vertical wall at one end and js supported by a cable at the other end 1550 N crate hangs from the far end of the beam find the magnitude if the tension in the wire the angle theta is 21 degrees and phi is 32 degrees length of beam is L
A 40.0kg uniform platform is suspended by two cables, 2.00m apart, where the centre of the platform lies midway between the cables. A 5.00kg paint bucket is placed on the platform, 24.0cm to the right of the right cable. Determine the tension in each cable.
A uniform drawbridge must be held at a 38o angle above the horizontal to allow ships to pass underneath. The drawbridge weights 55000 N and is 15.0 m long. A cable is connected 3.5 m from the hinge where the bridge pivots (measured along the bridge) and pulls horizontally on the bridge to hold it in place. What is the tension in the cable? Find the magnitude and direction of the force the hinge exerts on the bridge. If the cable suddenly breaks, what is the magnitude of the angular acceleration of the drawbridge just after the cable breaks? What is the angular speed of the drawbridge as it becomes horizontal? What is the velocity of the drawbridge, just before it “hits” (i.e. goes horizontal)?
one end of a uniform beam of weight 222 N is hinged to a wall; the other end is supported by a wire that makes angles u 30.0° with both wall and beam. Find (a) the tension in the wire and the (b) horizontal and (c) vertical components of the force of the hinge on the beam.
The positive direccion are indicated in the figure. The 880kg concrete bucket is in static equilibrium and the force in cable BC is 8000 N. 1. Determine the x component of the force BC, BCx =__N 2. Determine the Y component of the force BC,BCy=__N 3.Determinate the component of the force BA,BAx =__ N 4.Determinate the component of the force BA,BAy=__N 5. Determine the magnitude of force BA = __N 6. Determine the angle of the force BA =__°
The wooden sign is supported by three chains attached to the ceiling ( AC,AB,AD). If the tension in AB= 100 lbf and AC=65 Lbf, determine the tension in AD and the weight of the sign in equilibrium. 1 Determine the x component of the force AB: ABx= __lbf 2 Determine the Y component of force AB:ABy=__lbf 3 Determine the x component of force AC:ACx=__lbf 4 Determine the y component of the force AC:ACy =__lbf 5 Determine the magnitude of the force AD =__lbf 6 Determine the weight of the sign=__lbf
An 80 kgkg construction worker sits down 2.0 mm from the end of a 1450 kgkg steel beam to eat his lunch, as shown in: 1) Determine the tension in the cable under this scenario. 2) Given that the cable supporting the beam is rated at 1.5×104 N , should the worker be worried? yes/no
4. A 3 m long weightless beam is supported at each end by cables. A painter weighing 900 N stands 1 m from the left cable. Calculate the tension in each cable. 5. Where must a 500 N weight be hung on a uniform 150 N pole with a length of 5 m so that a girl at one end supports ¼ as much as a man at the other end? pleasebinclude complete solutions