Determine the surface tension of liquid in contact with air and a glass tube. If the capillary tube diameter 2 mm is dipped in a liquid of specific gravity 0.8, the liquid rises in the tube by 15 mm, making an angle of contact of 25° with the tube.

Determine the surface tension of liquid in contact with air and a glass tube. If the capillary tube diameter 2 mm is dipped in a liquid of specific gravity 0.8, the liquid rises in the tube by 15 mm, making an angle of contact of 25° with the tube.

Name: Determine the surface tension of liquid incontact with air and a glas
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: Determine the surface tension of liquid incontact with air and a glass tube. If thecapillary tube diameter 2 mm is dipped in aliquid of specific gravity 0.8, the liquid risesin the tube by 15 mm, making an angle ofcontact of 25° with the tube.

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter8: Centroids And Distributed Loads

Section: Chapter Questions

Problem 8.76P: A 6-in. diameter hole is drilled in the conical frustum. Calculate the volume and the surface area...

See similar textbooks

Similar questions

One side of the container has a 03-m square door that is hinged at its top edge. If the container is filled with water, determine the smallest force F that must be applied to the bottom edge of the door to keep it closed.
A 6-in. diameter hole is drilled in the conical frustum. Calculate the volume and the surface area of the resulting body.
he gage pressure of the air in the tank shown in the figure is measured to be 65 kPa. Determine the differential height h of the mercury column.
two vertical parallel glass plates 0.1 mm apart are partially immersed in water. Considering that the water does not reach the upper edges of the sheets and that the liquid completely wets the glass, determine: a) the height that rises in the flat capillary, b) the attractive force between the plates. Consider the width of the sheet l=12cm and density y=72.8*10^-3 N/m
A tank contains a liquid of relative density 0.80. The height of the tank is 4, and the width of the tank is 2m. The tank is subjected to the acceleration of 5m/s^2 along a 30o inclined plane in the upward direction. Under this condition, there is no loss of liquid. determine the slope of free surface determine the pressure at presure
An open tank containing water is accelerated vertically at 5.8 If the motion is downward with positive acceleration, determine the pressure (kPa) 1.85 m below the surface.
Find the surface tension of the water droplet of 30 mm diameter when the inside pressure is 3.5 N/m2 The surface tension in N/m is
Determine the surface tension of liquid is contact with year and a glass tube if the capeearty tube diameter to 2 mm is depend in a liquid of specific gravity 0.8 the liquid risce in the tube by 50 mm making an angle of contact of 25 digree see the tube
An oil tanker 3m wide 2 m deep and 10 m long contains oil of density 800 kg/m3, if the tanker is closed and completely filled with the oil and accelerated horizontally at 3m/s2. a.) determine the total liquid thrust (hydrostatic force) on the front end. (in kN) b.) determine the total liquid thrust (hydrostatic force) on the rear end. (in kN)
Air flows past a two-dimensional wedge-nosed body as inFig. . Determine the wedge half-angle δ for whichthe horizontal component of the total pressure force on thenose is 35 kN/m of depth into the paper.
Determine the height of water h above the top of the circular 2 m diameter gate which will cause it to open. The gate is hinged at the top and is initially kept closed by the action of mass M (on the lever arm) which is 220kg. Ignore from consideration the weight of the gate and the self-weight of the lever arm.
Two capillary tubes with 4mm and 2mm inside diameters were inserted into a liquid of density 1.12gcm^-3. Calculate the surface tension of the liquid if the difference between the capillary rises in the tubes is 2cm. Assume contact angle Is zero.