Answered: Determine the total inductance in the…

Determine the total inductance in the below figure. L1 L3=6 mH, and L2 = L 4 = 2 mH. The result should be in mH Calculate Answers to 2 decimal points lll lll lll lll L2 LA

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.2P: Convert the following instantaneous currents to phasors, using cos(t) as the reference. Give your...

See similar textbooks

Related questions

Q: calculate the magnitude and direction of the -current for each battery and total current 110v 0-21…

A: Given that the Electrical circuit is as follows

Q: (11) What is the 4800bps?

Q: An AC voltage an RMS value and average value of 200 Volts and 150 Volts respectively. What is the…

A: Given: AC voltage RMS value, Vrms=200 V AC voltage average value, Vavg=150 V

Q: -2π -TT ↑f(t) sint TC 2TT t

Q: 20. In an inductive series circuit, a voltage of 10V at 25 Hz produces 100 mA while the same voltage…

Q: Home Work: in 91 Two resistors must be selected so that like cust one is four times the current in…

A: We need to find out resistance value for given condition

Q: Q.3) The input voltage to a Full-wave rectifier employing a center tapped step-down transformer and…

Q: Q-2. B. A 2 MVA, 3-phase, 8-pole alternator runs at 750 r.p.m and operates in parallel with other…

Q: Use the Fourier series to represent the following periodic function: 2 f(t) = {_²/₂ -2 -1<t<0 0<t<1

A: We need to find out Fourier series coefficient for given signal

Q: A dc shunt motor has the following

A: DC shunt motor the speed can can be controlled very easily The speed can be maintained constant…

Q: The switch in the circuit shown in figure beside has been closed for a long time, and then opens at…

A: To find the numerical expression for the voltage across the capacitor Vo(t)

Q: A short transmission line is represented by an impedance of 0.01 + jo.04. What is the voltage…

A: Given data, A short transmission line has Z=0.01+j0.04 ΩI=1.93∠-8° puVs=1∠0° pu

Q: 12 Ω w w 8 Ω a 10V 6Ω b What is the Thevenin resistance external to the resistor R? 15.4 Q 3.4 Ω Ο…

Q: Q1. For the system shown in Figure (1) E. R(a) C( K₁ 2+1 D(a) Figure (1) Design the values of K, and…

A: A block diagram of closed-loop control system is given in the question. The steady state error due…

Q: superposition theorem

Q: Find i and v, in the circuit of Fig. 7.15. Let i(0) = 12 A. Answer: 12e-2¹ A, -12e-2¹ V, t > 0.

Q: 25. The p.d. measured across a coil is 20 V when a direct current of 2 A passed through it. With an…

A: We need to find out current for given circuit

Q: C₁ = 15 µF V C C₁= 8 µF * V₂20 V

Q: Determine the current supplied by each battery shown in fig 412 ww. +F 802 w 32.522 -Bov I…

A: For the above given question we need to calculate the value of current flowing through the each…

Q: Q-2. B. A 2 MVA, 3-phase, 8-pole alternator runs at 750 r.p.m and operates in parallel with other…

Q: 8. How FM wave can be converted into PM wave?

Q: 5. The amount of energy that can be stored in a single system per unit volume is a. Energy volume c.…

A: Note: As per the policy we can solve only question, please re-upload the remaining question as a…

Q: 1. The Locus of inductive load is a vector in the: a. 2nd quadrant b. 1st quadrant s. 4th quadrant.…

A: Q.1) b Q 2) b Q. 3) b

Q: a balanced Inductor and resistance, (Y), 30, ha 2000), (VL= 400v), (F= 60 Hz), Calculate :-The

Q: IA IB VCA B VAB VBC 7 1AB 10/0° 10/30° N 15/-30° Lac ICA

A: In balanced Delta connected Load VLine=VphaseILine=3 Iphase In balanced star connected Load…

Q: Que 2 ÷ write the classification of Substations.

Q: A 3-phase 60 Hz I.M. has a rated speed = 1650 R.P.M., its speed at slip = -0.15 is equal to:

A: In this question, We need to determine the speed at the slip = -0. 15 We know Synchronous speed N=…

Q: Find the current through 50 resistor using superposition theorem 802 ww + 48 V - 60 M 50 5Ω ww R₁…

A: We need to find out the current for given circuit by using of superposition Theorm

Q: ja Joz) A resistance R₁ of. 5kr is shunted by conductance G of 50 µ.S. The combination draws. a…

A: We need to find out conductance and resistance and voltage and current for given circuit

Q: 24 A 6V battery, delivers tomA to three.... resistors in parallel, R₁=1kr, R₂ = 2tr₂fs=Rx-…

Q: 4. Typical interior LED lightbulbs have a power rating of 19 W. These bulbs have a brightness of…

A: Given: Power rating of LED bulb, P=19W Power rating of filament bulb, P=100W Brightness of 1 bulb or…

Q: Consider the following signal: s(t) = 20 cos(1000.pit)][cos(4000.pit)]. The Nyquist rate for this…

A: Given signal, st=20 cos 1000πtcos4000πt

Q: difference equation form this transfer function H(z)=(z^2+0.5z^1-0.8)/z^2 is…

A: In this question, We need to choose the correct options We know Z transform of the x(n-no )--->…

Q: - b) Draw the block diagram of the phase- locked loop (PLL) that can be used to demodulate FM…

A: `

Q: A 3-phase, star-connected alternator generates 6,360 V per phase and supplies 500 kW at a p.f. 0.9…

A: Delta Connected system VLine= VphaseIline=3 ×Iphase Star connected system VLine=3 VphaseIline=Iphase

Q: Choose the correct answer 1- The resistivity of the conductor depends on (a) area of the conductor…

Q: The channel _______when Id=Idss. a. does not exist b. is closed c. is narrowest d. is widest

Q: What are the drawbacks of slope detector? 8. How FM wave can be converted into PM wave?

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: by Draw the block diagram of the phase locked loop detector that can be used to detect FM signal and…

A: The working of a PLL is alike to some other feedback approach where the feedback signal favor to…

Q: b) A single-phase diode bridge rectifier has a purely resistive load of R-15 2 and, VS-300 sin 314 t…

Q: 7- Determine the power factor of 220V, 0.4A, 20W fluorescent lamp? and when it will be leading or…

Q: The effective resistance between B and Cof letter A containing resistances as shown in Fig. 2.25 is…

A: Given circuit,

Q: Q4:- A) Series resonance Circuit, R = 156 2, L = 1.26 mH, C= 2.01 µF Calculate:- 1) fr, 2) Qr, 3)…

Q: H.W. I If a microprocessor can perform 4 million. instructions per second, how many nanoseconds are…

A: In this question we will find time taken by microprocessor to perform an operation ....

Q: Example: Three inductors have values L₁ = 10 mH, L₂ = 100 MH, and L3 = 500 MH. Determine the total…

Q: QUESTION 1 The A-i relationship for an electromagnetic system is given by: A = 1/(11/3) Calculate…

A: Given the λ-i relationship for an electromagnetic system is, λ=1i13 i=5 A

Q: F ← N₂ = 40 t ell Denotes iron-core 1,-100 mA For the iron-core transformer of figure. Find the…

Q: PAN is abbreviation of: O Private Area Network. O Personal Area Network. OPublic Area Network. O No…

A: We need to select correct option

Q: What is the bandwidth of FM system

A: In this question we will write about bandwidth of FM system...

Q: 13- If a sine wave goes through 10 cycles in 20 us, what the periodic time 14-How many radians are…

Concept explainers

HVDC

HVDC stands for high voltage direct current in the electric power transmission system. The high voltage direct current system uses direct current (DC) for the transmission of electrical power through transmission lines in contrast with the alternating current that is the AC system. The HVDC is used to transmit bulk power point-to-point through long distances transmission lines. Power is rapidly transferred because the efficiency of transmission lines is greatly increased over long distances due to HVDC lines.

Question

Determine the total inductance in the below figure.
L1 L3=6 mH, and L2 = L 4 = 2 mH.
The result should be in mH
Calculate Answers
to 2 decimal points
m
m
ell
L2
illl
LA

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted between the plates without changing the spacing, and the capacitance becomes 15 F. What is the dielectric constant of this material?
Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7 A. What is the inductance of the load connected in parallel with the incandescent lights? Assume a voltage of 120 V and a frequency of 60 Hz.
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
Capacitive Circuits Fill in all the missing values. Refer to the formulas that follow. XC=12fCC=12fXCf=12CXc Capacitance XC Frequency 38 F 60 Hz 78.8 400 Hz 250 pF 4.5 k 234 F 10 kHZ 240 50 Hz 10 F 36.8 560 nF 2 MHz 15 k 60 Hz 75 nF 560 470 pF 200 kHz 6.8 k 400 Hz 34 F 450
Consider the circuit shown in Figure 2.23 in time domain. Convert the entire circuit into phasor domain.
What frequency must be applied to a 33-mH inductor to produce an inductive reactance of 99.526 ?
Convert the following instantaneous currents to phasors, using cos(t) as the reference. Give your answers in both rectangular and polar form. (a) i(t)=5002cos(t30) (b) i(t)=4sin(t+30) (c) i(t)=5cos(t15)+42sin(t+30)
You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
Inductive Circuits Fill in all the missing values. Refer to the following formulas: XL=2fLL=XL2ff=XL2L Inductance (H) Frequency (Hz) Inductive Reactance ( ) 1.2 60 0.085 213.628 1000 4712.389 0.65 600 3.6 678.584 25 411.459 0.5 60 0.85 6408.849 20 201.062 0.45 400 4.8 2412.743 1000 40.841