Please disregard the question on the picture. Here's the right question, at what frequency will the value of the impedance be twice that at 25Hz (refer to the given in question #20). 20. In an inductive series circuit, a voltage of 10V at 25 Hz produces 100mA while the same voltage at 75 Hz produces 60 mA. Find the values ofR and L.

Answered: Image /qna-images/answer/17769976-124f-4bcf-af97-152b5df0e7f4.jpg

Answered: 20. In an inductive series circuit, a…

20. In an inductive series circuit, a voltage of 10V at 25 Hz produces 100 mA while the same voltage at 75 Hz produces 60 mA. Find the values of R and L.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 7RQ: An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a...

See similar textbooks

Related questions

Q: 10. A capacitor of 50 µF shunted across a non-inductive resistance of 100 Q is connected in series…

A: given here discription of a circcuit and asked to find the current through the shunted resistor.

Q: 1. A 500-KVA, 3-phase, 50-Hz transformer has a voltage ratio (line voltages) of 33/11-kV and is…

Q: What is the Thevenin resistance external to the resistor R?

A: This question belongs to circuit theory . It is based on the concept of calculation of Thevenin's…

Q: Find 11 and 12

Q: A-x(t)= exp(1+t) u(-t+2) B-y(t)= sin(2nt) exp(-t) u(t) signa

Q: E6.24 Consider the system represented in state variable form x = Ax + Bu y = Cx + Du, where 0 1 0 […

Q: -2π -TT ↑f(t) sint TC 2TT t

Q: An AC voltage an RMS value and average value of 200 Volts and 150 Volts respectively. What is the…

Q: Que 2 ÷ write the classification of Substations.

Q: Home work: Q1] Two resistors must be selected so that the current in one is four times the current…

A: We need to find out value of resistance.

Q: If an angle modulated signal Xc(t) = 24 cos (2π * 10 ^9 t + 50 sin 10^4 π t) Calculate a- the…

Q: B) Sketch the phasor diagram and the circuit of medium transmission line using nominal- T model…

Q: When two identical parallel wires are 3 m apart, the inductance per unit length is 2.5 μH/m.…

Q: 42 sin 8r V 252 www H IH ¹/2 7652

Q: * If X= (1100101)excess-3 X=(101)octal O X=(65)decimal O X=(110000)gray O X=(1000001) binay O none…

Q: We need a three-stage space-division switch with N = 100. We use 10 crossbars at the first and…

Q: If a summing point is placed after a take off point, they will be represented ______ a. separate…

A: If a summing point is placed after a take off point, they will be represented ______ Options are:…

Q: 11. Use the Routh array to assist in computing the roots of the polynomial q(s) = 25³ +25² + s + 1 =…

A: Given data, Characteristic equation , 2S^3 + 2S^2 + S + 1 = 0 By Routh array criteria,

Q: 4) Consider the feedback system G(s) = K(s +1+j)(s+1-j). The root-locus is which of the…

A: 4) To choose the root locus for the given feedback system G(s) from the options

Q: 93 Two conductances G₁ and. 6₂. having values of 600 and. Yoo S respectively. are connected in…

Q: Q1) Find the Fourier transform of the flowing functions: cos(20ot) and sin(coot)?

Q: فرق الطور بين إشارات الجهد والتيار في الشكل * HORSE FREMDELES Cande S SHEAREST AN AN E P t

Q: A DC-DC boost converter has an input of 200 V with a load of 7.5 Ohm. Find the output voltage and…

A: Given data, DC-DC boost converter has Vin=200 VR=7.5 Ωd=0.4

Q: Q-1. A 3 phase, 0.8 MVA, 3.3 kV, star - connected synchronous generator has 5 2/phase synchronous…

Q: Q-2. A. A lighting load of 2000 kW and a motor load of 4000 kW at a p.f. 0.8 lagging are supplied by…

Q: L Determine the resistance and conductance of 20m of copper wire 2mm in diameter. ४ = 1-72 x10. M.

Q: Source 1 -jxc VLOAD R ww ZLOAD Figure 1 j XL 0000 Source 2

Q: We need a three-stage time-space-time switch with N = 100. We use 10 TSIs at the first and third…

A: Given a three-stage time-space-time switch with, N =100 No of TSIs at the first stage= 10 No of TSIs…

Q: If a summing point is placed before a take off point, they will be represented ___ a. one branch…

Q: For the circuit shown in figure (2): Calculate the current and voltage for the resistor R using…

Q: The minimum number of flip- flops that can be used to construct a Mod-5 counter is

Q: - Calculate the e modulation in

Q: Find 11 and 12

Q: 12 Ω w w 8 Ω a 10V 6Ω b What is the Thevenin resistance external to the resistor R? 15.4 Q 3.4 Ω Ο…

A: We need to find out thevenin equivalent resistance

Q: The group of bits 10110111 is serially shifted right (right- most bit first) into an 8-bit

A: Given that Serial In Parallel out initial data in register is 11110000 If Serial Data is 10110111 is…

Q: Q.3) The input voltage to a Full-wave rectifier employing a center tapped step-down transformer and…

A: For the above given circuit question we need to draw the full wave rectifier circuit with having…

Q: Q2/A-list the characteristics of PIC 17 series B- Explain with drawing the basic blocks in PIC16F48

A: (A) PIC 17 a memory mapped accumulator. read access to code memory (table reads) direct register…

Q: In a 4-bit magnitude comparator with first input A= 1101 and second input B-1110, the output A> Bis…

Q: Q6) Find the Fourier transform of the following function? f(1) A 24 3T 2 0 эт E2 1

A: In this question, The rectangular function is given. We need to find the Fourier transform of the…

Q: 1012 W 15 4 R ㅏ R=6.62 0 R=6Q 0 R=6.22 ○

Q: My name is Ahmed, I come from Mosul, A city in the North of Iraq. I'm a student at the University of…

A: Given: Details about Ahmad

Q: c) Draw the block diagram of delta modulation with a brief explanation of this modulation techniques

A: Delta modulation is a Differential Pulse Code modulation (DPCM) technique in which the difference…

Q: . Determine the Fourier series of full wave rectified signal whose amplitude is Vm and period is π

Q: the circuit shown in figure (1), solve the circuit using chhoff's laws to determine currents and…

Q: Calculus Design a circuit that generates even parity for a 4-bit input: a. Using a single…

Q: ohm per phase. Calculate the synchronizing power per mechanical degree displacement

A: The synchronous machine is a double fed machine. The synchronous generator works on the faraday's…

Q: In a 4-bit magnitude comparator with first input A= 1101 and second input B=1110, the output

Q: Q2. A) What are the main differences between the three-phase bridge 180 and 120 degree modes of…

A: Types of converters AC AC Converter AC to DC Converter (Rectifier) DC to DC Converter (Chopper) DC…

Q: 6. When a 240 V, 50 Hz supply is applied to a combination of a resistor of 15 Q in parallel with an…

Q: The main difference between a register and a counter is

A: ans:(d) register has no specific sequence of states

Question

Please disregard the question on the picture. Here's the right question, at what frequency will the value of the impedance be twice that at 25Hz (refer to the given in question #20).

20. In an inductive series circuit, a voltage of 10V at 25 Hz produces 100
mA while the same voltage at 75 Hz produces 60 mA. Find the values of
R and L.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The circuit is connected to a 60-Hz line. The apparent power in the circuit is 29.985 VA, and the power factor is 62.5%. The resistor has a voltage drop of 14.993 V, the inductor has an inductive reactance of 60 , and the capacitor has a capacitive reactance of 45 . ETITZVA29.985PF62.5%ER14.993VIRRPELILXL60VARsLLECICXC45VARsCC
An AC circuit contains a 24 resistor, a 15.9-mH inductor, and a 13.3F capacitor connected in parallel. The circuit is connected to a 240-V, 400-Hz power supply. Find the following values. XL=XC=IR=AIL=AIC=AP=WVARsL=VARsC=IT=AVA=PF=%=
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
What frequency must be applied to a 33-mH inductor to produce an inductive reactance of 99.526 ?
Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7 A. What is the inductance of the load connected in parallel with the incandescent lights? Assume a voltage of 120 V and a frequency of 60 Hz.
Assume that the voltage drop across the resistor, ER, is 78 V; the voltage drop across the capacitor, EC, is 104 V; and the circuit has a total impedance, Z, of 20 . The frequency of the AC voltage is 60 Hz. Find the missing values. ET ER78V EC104V IT IR IC Z20 R XC VA P VARSC PF C
Assume that the current flow through the resistor, IR, is 15 A; the current flow through the inductor, IL is 36 A; and the circuit has an apparent power of 10,803 VA. The frequency of the AC voltage is 60 Hz. ET ER EL IT IR15A IL36A Z R XL VA10,803 P VARSL PF L
An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted between the plates without changing the spacing, and the capacitance becomes 15 F. What is the dielectric constant of this material?
You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.