discuss the application of nyquist criterion to determine stability of a closed loop control system
Q: Given the field: D = 20 [-sinØ ap + sin 2Ø aØ] Find the total charge lying within the volume 1<p <…
A:
Q: 15-23. Determine the power density at a point 20 km from an antenna with an input power of 1200 W…
A: It is given that: d=20 kmPI=1200 WApdB=46 dBApdB=10logAp46=10logApAp=3.98×104
Q: Describe the difference between using a leading and atrailing electrode angle.
A: Leading electrode angle The electrode angle is the angle between the electrode and the surface of…
Q: For the below circuit, find the power dissipated in the 62 resistor 1.6 Ω 10 A Select one: O a.…
A: We need to find out power dissipation in the given circuit
Q: Determine VP(sec), VP (out), PIV, Vp(rect), Vr(p-p), VDC and the ripple factor, r 1 : 1 D₁ 120Vrms…
A: Given: Consider the following circuit: To find: VP(sec), VP(out), PIV, Vo(rect), Vr(p-p), VDC, and…
Q: Iron losses in a DC machines are independent of variations in: * voltage and current speed and…
A: The iron loss is classified in two types, Hysteresis loss and Eddy current loss. Where, Eddy current…
Q: pply LPF to eliminate the higher frequencies in 3*3 image using a 3*3 average filter, the image…
A:
Q: ergy-efficient wireless network, which emphasizes energy efficiency ectrum efficiency, have been…
A: In wireless communication systems, the nonlinear effect and inefficiency of power amplifier (PA)…
Q: Why transformer rated in KVA ?
A: Power may be transferred between two sides of a circuit using transformers without affecting the…
Q: Figure Q2(b) shows a BJT amplifier with ß= 120 and VBE = 0.7 V. (i) Calculate current, IB, IC and IE…
A:
Q: Derive the transfer function of dc servometer
A: Derive the transfer function of dc servometer
Q: circuit with a resistance of 25 ohms, the current flowing through the circuit is which of the…
A: Given data, Supply voltage V = 100 V Resistance R = 25 ohm
Q: Determine the voltage across the
A: Given- Coil resistance= 10 ohm Coil inductance= 15 Henry Series resistance= 15 ohms DC source…
Q: 3. Based on Figure 1, determine which one is f and f'. Provide a reason for your choice. AAA Figure…
A:
Q: 3-9. a. Determine the noise gain for the circuit of Figure P3-9. b. Use the result to calculate the…
A: Given data: The given circuit is shown below
Q: what is the reason behind parallel operation of alternators?
A: Electric power networks are linked together for reliable, cost-effective operation. Synchronous…
Q: Calculate the maximum efficiency, n for the class B push-pull amplifier shown in Figure Q4(b).…
A: According to the question, for the given class B amplifier as shown below We need to discuss (1)…
Q: (ii) Calculate the maximum efficiency, n for the class B push-pull amplifier shown in Figure Q4(b).…
A: According to the question, for the given class B amplifier as shown below We need to discuss (1)…
Q: The radar in which both transmission and ception is done using the same antenna are called:
A: The solution is provided in the following section.
Q: If in an RC circuit, the capacitance is increased by 20% and the resistance, R, is increased by 10%,…
A:
Q: Calculate Required size of core and calculate number of turns in primary and secondary for small…
A: It is given that: Vs or Vo=12 VIo=3 AVp=230 Vf=50 Hzη=90%
Q: 10k ww R₁ Ry = ? www OP-AMP V₁=1V V₁= 10v
A:
Q: 3. A relay coil has a resistance of 500 ohms and inductance of 10mH. The triggering current of relay…
A: Solution is attached with this notes.Thank you.
Q: If two 115-volt loads were connectedin parallel with 240 volts, they would__________.a. burn dimlyb.…
A: The given loads are rated for 115 Voltage. The loads are connected in parallel, hence each load will…
Q: 700 V 0.35 A 0,53 A The total current flowing in the circuit in Figure 5-9 is: • 106 Α 470 Ω Μ 2.82…
A:
Q: When connected to a 4-ohm resistor, a battery has a terminal voltage of 6.5V. If the open-circuit…
A: A broken continuity caused by an obstruction in the current flow channel is known as an open…
Q: 3. The radar in which both transmission and reception is done using the same antenna are called: a)…
A: We need to select the correct option
Q: When connected to a 4-ohm resistor, a battery has a terminal voltage of 6.5V. If the open-circuit…
A:
Q: The total charge of a uniform insulating sphere is 14.16 nanocoulombs. If the radius of the…
A: The total electric flux, according to Gauss's law, is equal to the contained charge divided by the…
Q: The symbol shown is for i Ţ O a. DPST O b. DPDT O C. SPDT d. SPST
A: Given, The symbol shown is
Q: 3. The radar in which both transmission and reception is done using the same antenna are called: a)…
A: The correct option, along with the explanation, is provided in the following section.
Q: A modulating wave has a peak value of 2 volts. The carrier wave equation for the voltage is 1.2…
A: Given here a peak amplitude of modulating signal and carrier wave equation and asked to find the…
Q: 4. Which of the following is the correct relationship between temperature (T) and mobility (u) of…
A: The solution is provided in the following section.
Q: Approximate solution time is 5 minutes. A transformer supplies power to a feeder that has five…
A:
Q: 8. Design a synchronous counter, with module 11, NBC code using only T synchronous Flip Flops with…
A:
Q: Calculate the value of feedback resistor (R) required to self bias an n-channel JFET with Ipss = 25…
A:
Q: system which consist of two power plants, the incremental cost in GHC/MWhr are dC₁ dP -= 0.17 P₁ +…
A: Given data : The given incremental cost , dC1dP1=0.17P1+140dC2dP2=0.24P2+185 The system operates…
Q: µC/m² and B=2a, mT, Find the value of k If D=10xã¸-4y@y+kza. to satisfy the Maxwell's equations for…
A:
Q: 41. If a wire conductor of 0.2 ohm resistance is doubled in length, its resistance becomes (a) 0.4…
A: Given data, Initial resistance of wire, R1=0.2 Ω Let initial length is l1 Final length l2=2l1
Q: A 12-pole induction motor has a frequency of 60 Hz. Its synchronous speed would be: (a) 600 rpm (b)…
A: Given: Total number of pole, P = 12 Induction motor frequency, f = 50 Hz
Q: An infinite length wire carrying current 10A is positioned along the x-axis . a point is located…
A: By Amperes law , Magnetic field at a distance r from the line is given by uoI/(2*π*r) Also, the…
Q: The unit for electric displacement D is O a. N/m² O b. no units C. C/m² d. c/m
A: The ratio of charge per unit area which would be shifted across a conductor once it has been put…
Q: Approximate solution time is 5 minutes. A transformer supplies power to a feeder that has five…
A: Given a transformer supplies power to a feeder that has a 5 consumers. Daily maximum demands for…
Q: The total charge of a uniform insulating sphere is 12.84 nanocoulombs. If the radius of the…
A: We need to find out the electric field due to sphere
Q: The capital investment in an energy conservation project is 15,00,000/- and its useful life is 25…
A:
Q: A 12 V, 1kHz ac voltage source is connected to a parallel RC circuit. Given that R = 220 22 and Xc =…
A:
Q: 4-9. Consider the circuit of Figure P4-9 with R₁ = 10 kn and R, = 70 kn. If the unity-gain fre-…
A: For the given op-amp circuit calculation of closed loop 3-dB bandwidth. Given: Ri=10 kΩRf=70 kΩand…
Q: The magnetic field intensity in free space is given as H = Ho sine ay A/m. where 0 = (wt-Bz) and ß…
A:
Q: A safe has 5 locks: V, W, X, Y and Z, all of which must be unlocked for the safe to open. The keys…
A: The following table indicates the executives and the locks they can open. v w x y z A 1 1…
Q: what are the advantages of root locus? need of feedback ?
A: The root locus is a graph that displays the position of a system's poles (the roots of the…
discuss the application of nyquist criterion to determine stability of a closed loop control system
Step by step
Solved in 2 steps
- Why transient response? What is the importance of the transient response of a control system? ples write in deatilControl System Answer with an explanation would be highly appreciated. (a) Determine the location(s) of the (finite) open-loop zero(s). open-loop zero(s) at s = ? (b) Determine the location(s) of the open-loop pole(s). open-loop pole(s) at s = ?A 54-slots, 216 segments has four poles lap armature windings that is equalized 100 per cent at the commutator. a) How many equalizer connections are there? b) To what two segments is the first equalizer be connected?
- What should the parameters K and K1 be in order for the following (finite value) steady-state errors of the closed loop control systems to be ess = 0.02?What is feedback system for automatic control of physical quantities? Explain?This Question is related to feedback control system What are the different options to reject disturbances on a system? Comment briefly on feasibility of each case.