Discussion: 1- Explain the properties of the following controllers: P, PI, PID. 2- Suggest an op-amp circuits for practical realization of PI, PD, and PID controllers. 3- What is the suitable type of controller for compensating the steady-state error? Why? what effect is sometimes noted in using this type of controller on the transient response of the system? 4- What is the suitable type of controller for improving the transient respone performance of the control system? Why?

Discussion: 1- Explain the properties of the following controllers: P, PI, PID. 2- Suggest an op-amp circuits for practical realization of PI, PD, and PID controllers. 3- What is the suitable type of controller for compensating the steady-state error? Why? what effect is sometimes noted in using this type of controller on the transient response of the system? 4- What is the suitable type of controller for improving the transient respone performance of the control system? Why?

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter30: Ac Solid-state Reduced Voltage Controller

Section: Chapter Questions

Problem 1SQ: List some advantages of solid-state control.

See similar textbooks

Similar questions

Please explain step by step (like the charging and discharging) how the output of this uncompensated attenuator became like that.
control system theory question
Explain the concept of “EXTENDED EQUAL AREA CRITERION” 2. Discuss in detail about “The Transient Energy Function Method” 3. Write about the “Factors Affecting Transient Stability”. Discuss about NUMERICAL SOLUTION OF SWING EQUATION
Significance of transient response in control systems. Could an example with temperature control for a human occupied building be provided?
3. What is harmonic restrain and startup characteristic for differential protection and in which circumstances they are useful
i. Draw the graph of Ramp signal and also write the equation. i. Define Peak time.
1) Define a martingale sequence. Give the intuition of it and two examples. 2) What is a white noise process? Give examples. 3) Explain the difference between a moving-average and an autoregressive process.
b. Describe how the zener stabiliser circuit reacts when: i. there is a fluctuation of the source (input) voltage. ii. there is a fluctuation of the output resistance (load).
Control system engineering....
Using a labelled diagram, describe cold-junction compensation for athermocouple and explain why it is necessary. Describe cold-junctioncompensation using a temperature reference unit. Outline practicablemethods for compensation on industrial plant including electronic andsoftware compensation. State the advantages and disadvantages of thevarious techniques.
Suppose a shunt regulator voltage is 250V, the armature current is 30A. field coils are required to provide an MMF of 500AT. The field might typically say 200turns with resistance of 0.5Ohms/turn. Find the dissipated power as heat and total input required and the efficiency
I am given the task as a trainee control engineer to design a closed-loop controller for the air conditioning unit pictured so that it has the following properties: Maximum overshoot: 10% Maximum time to reach 99% of steady state: 10 seconds Maximum steady-state error: 10% Please find the values of the gain, natural frequency and damping coefficient of the open-loop system to two places after the decimal point. Many thanks :)