Discussion 1. Define the specific gravity of the soil solids. 2. What is the importance of the test? 3. What are the likely sources of error in this test? 4. If you are not able to perform the test, what values would you use to estimate the specific gravity of sand and clay?

Discussion 1. Define the specific gravity of the soil solids. 2. What is the importance of the test? 3. What are the likely sources of error in this test? 4. If you are not able to perform the test, what values would you use to estimate the specific gravity of sand and clay?

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter5: Soil Compaction

Section: Chapter Questions

Problem 5.2P

See similar textbooks

Related questions

Q: The data shown below are the results of a liquid limit test done on a soil. Moisture Content (%)…

Q: SITUATION 4: Results from liquid and plastic limit tests conducted on a soil are given in the table.…

Q: 2. A soil sample of moist clay has a diameter of 38 mm, length of 76 mm and a mass of 183.4 g. After…

A: Given data: Diameter=38 mm Length=76 mm m1=183.4 g m2 =157.7 g

Q: The results of the particle-size analysis of a soil are as follows: % passing no 10 sieve = 100, %…

A: Given, % passing no 10 = 100 No 40 = 80 No 200 = 65 LL = 30 PL = 15 To Find :- group index of soil

Q: You are given the following results from Atterberg Limits testing on a soil sample (PL= 30%, LL =…

Q: QUESTION ONE A particle size distribution curve is given in the figure below Classify the soil using…

Q: Volume by immersion vs. volume by measurement Provide a comparison about the two methods on how to…

A: comparison about the two methods on how to determine the unit weight of the soil

Q: Results from liquid and plastic limit tests conducted on a soil are given below. Liquid limit tests:…

Q: ctivity 3 Problem Set Questions Liquid Limit and Plastic Limit Tests were conducted on a soil given…

Q: 4.15 The following results were obtained from a liquid limit test on a clay using the Casagrande cup…

A: Number of blows(N) 6 12 20 28 32 Water Content (%) 52.5 47.1 43.2 38.6 37.0

Q: Q.2 Results of sieve analysis are shown in the table below. Check whether this soil can be…

A: To determine if the soil with given sieve analysis can be classified as SP. Given, Sieve Finer…

Q: 2.7 The results of a liquid limit test and a plastic limit test on a sample of soil are given below:…

A: To find - Liquid limit, plastic limit, Plasticity index and classification of soil based on the…

Q: The table below shows the results from the specific gravity (S.G.) test performed in a soil…

Q: Why it is important to know the plasticity index of soil.

A: The difference between the numerical value of the liquid limit and the numerical value of the…

Q: What is the consistency index of the soil

A: ####What is the consistency index of the soil ####

Q: A standard Proctor test was performed on a soil which has a G = 2.75. The moisture content and total…

A: We have to determine the value of dry unit weight for each sample and dry unit weight for 12% and…

Q: The coefficient of permeability of coarse-grained soil and fine-grained soil can be measured using…

A: Soil permeability, also known as hydraulic conductivity, is the rate at which water flows through…

Q: Question Answer Calculate the percentage of sand when the 40 second hydrometer reading is 35 g;…

Q: Three kinds of experiments for measuring soil permeability coefficient

A: The following methods were used to measure the coefficient of permeability of fine grained and…

Q: Sieve Size Sieve opening (mm) Percent Finer 3 in. 76.2 100% 2 in. 50.8 90% 1 in. 25.4 80% #4 4.75…

A: Given the sieve sizes and percentage finer soil in those sieves.

Q: Question attached

A: The optimum moisture content of the soil is defined as the water content corresponding to the…

Q: 11.4 The following are the results of a consolidation test on a sample of a clayey soil. Pressure, o…

A: Given :

Q: With the aid of a diagram, explain how sieve analysis is conducted to determine the particle size…

A: The procedure of sieve analysis:

Q: Q#1 The following are the results of different tests on soil samples are provided in the following…

Q: Soil granulation experiment was performed on 2 kg of tested soil and the following results were…

A: Knowing the particle size distribution data, the particle size distribution curve is prepared. It…

Q: A fall cone test was carried out on a soil to determine its liquid and plastic limits using a cone…

A: Soil sample mass=80 grams Clay percentage=45% Penetration 8 15 19 28 Water content(%) 43.1 52.0…

Q: Soil granulation experiment was performed on 2 kg of tested soil and the following results were…

A: For calculating the passing percent of soil we have to calculate the cumulative weight on each…

Q: 4. The permeability test as mentioned in the question above (a) was carried out twice on the same…

A: To Find :- duration of test 2 in permeability test of soil.

Q: Soil Percent passmg sieve Liquid plasticity sample No 10 No 40 No 200 75 Limit Index 100 25 35 15…

A: AASHTO is generally a Soil Classification System that divides soils into seven different groups,…

Q: A clay sample is placed in a glass container. Total mass of clay sample and container is 72.49 g.…

Q: A cohesive soil sample was taken from an SPT and returned to the laboratory in a glass jar. It was…

A: solution Given Volume of water Vw=423cm3density of water ρ=1gmccwe know density ρ=massvolume 1=mass…

Q: QUESTION#1: Find the mass of soil in grams required for the specimen preparation if; Height of the…

A: Given data; H = 3" D= 1.85" Density of soil = 106.25lb/cubic ft. Mass of the soil= ?

Q: 3.A. What type of laboratory test can be used to determine soil permeability B in Table 1) Tabel 1…

Q: 9. The following laboratory test results for Casagrande liquid limit test. a. Draw Flow curve for…

A: according to question given in table flow curve for the given soil is drawing in asemilog graphx…

Q: The following tabulated data shows laboratory results of a soil sample tested for its atterberg…

A: (a) The formula to calculate the plastic limit is given by, Plastic limitwp=Weight of container+ wet…

Q: A test of density of soil in place was performed by digging a small hole in the soil, weighing the…

Q: Results from liquid and plastic limit tests conducted on a soil are given below. Liquid limit tests:…

A: To find out the :- a) The flow curve and obtain the liquid limit. b) What is the plasticity index of…

Q: Derive the following equation using Figure 1 where e is the void ratio, S, is the degree of…

A: Hi there! since you have asked multiple questions, we will solve the first question for you. If you…

Q: 1. The results of a standard Proctor test are given in Table Q1 below. Determine the maximum dry…

Q: Problem 2: A 0.4 m³ moist soil sample was tested in the lab, and the following data was observed:…

Q: SITUATION 4 Given the void ratio of a soil is 0.85. What is the percentage error of the bulk unit…

Q: The table below shows the results from the specific gravity (S.G.) test performed in a soil…

A: specific gravity samples cumulative sample 2.30-2.39 1 1 2.40-2.49 2 3 2.50-2.59 3…

Q: A) A sample of soil was tested in the laboratory and the test results were listed as shown in Table…

A: Basically, the sand or gravel is said to be well graded with the help of coefficient of curvature…

Q: The following data represent the results obtained from the specific gravity (S.G.) test performed in…

A: Given Total samples= 20 Mode = 2.65

Q: 1. A soil sample is taken from the field, placed in a container having a volume of 100 ml. The…

A: Given data in question Soil sample weight =175 gm = 175×10-3 kg Volume = 100 ml = 100×10-3 litre =…

Q: Q#1 The following are the results of different tests on soil samples are provided in the following…

A: The given data is shown below: The Reg No is given as 120.

Q: The table below shows the results from the specific gravity (S.G.) test performed in a soil…

A: The frequencies of all preceding classes are added to the frequency of a class. This series is…

Q: Discuss your results and compare your results with any published data. For the bulk density test,…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Question

100%

Soil mechanics lab Write the answer in word please Not in hand-Write And thanks.

Discussion
1. Define the specific gravity of the soil solids.
2. What is the importance of the test?
3. What are the likely sources of error in this test?
4. If you are not able to perform the test, what values would you use to estimate the specific
gravity of sand and clay?

Branch of science that deals with the stationary and moving bodies under the influence of forces.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Three kinds of experiments for measuring soil permeability coefficient
Q#3 :The following are the results of different tests on soil samples are provided in the following table. Classify the soil according to AASTHO classification and determine the Group Index in each case. You may use the information provided.
A soil sample presents the physical indices presented in Table 2. Determining the classificationof the soil sample, according to the Unified Classification System (SUCS), diagram in Figure 1.
A soil profile is shown in Figure P3.3 along with the standardpenetration numbers in the clay layer. Use Eqs. (3.8b)and (3.9) to determine the variation of cu and OCR withdepth. What is the average value of cu and OCR?
You measure a soil sample's pH using a testing strip. If the reading is 5.2, how would you classify the sample?
Engineering statistics, i need solutions in 15 minutes please. MCQ/The table below shows the results from the specific gravity (S.G.) test performed in a soil laboratory including twenty samples of sand. Determine the Coefficient of Quartile Variation. A-0.011 B-0.033 C-0.024 D-0.087 E-0.065
Subj- civil Q. An undisturbed soil sample that is cylindrical in shape and measures 3 in (76.2 mm) in diameter by 6 in (152.4 mm) in length after oven drying weighs 2.57 lb (1.166 kg bulk) as opposed to 3.04 lb (1.38 kg mass). What are the densities and the weights in (a) wet and dry units? Additionally, find out the moisture content.
0.4 m3 moist soil sample was tested in the lab, and the following data was observed
A soil sample has the following size distribution; 4 to 2mm = 17%, 2 to 0.05 mm = 12%, 0.5 to 0.005 mm = 22% 0.005 to 0.002 mm = 10% <0.002 mm = 39% what are the percentages of clay, silt, and sand? Using USDA calssification what is the modifier and tetural classification
Let us assume that a soil sample taken in the field is taken and it must be identified by the SUCS Method and AASHTO Method. Moisture content = 5.75% Limit liquid = 53.5 Plastic limit = 31.6 Granulometry Sieve % Pass No. 4 100 # 40 68 # 200 54.3 Do you select the best answer? a) Inorganic silt and sand, with low plasticity b) Inorganic clay with low plasticity c) Clay silt, traces of gravel, dark Brown
Can u solve ?(readable) A soil specimen is 38 mm in diameter and 76 mm long, and in its natural conditionweighs 168.0 g. When dried completely in an oven, the specimen weighs 130.5 g. The value ofGs is 2.73. What is the degree of saturation of the specimen?
A 50 mm diameter and 90 mm-long silty clay sample was subjected to a falling head permeameter test using a setup similar to the one shown in Figure 6.4b, where the inner diameter of the standpipe was 3.0 mm. The head dropped from 870 mm to 450 mm in 5 minutes. What is the permeability of the sample?