Discussion: 1. Did your experimentali results verify the equivalence between the delta and star connections? (Compare the voltage and the currents in both cases). 2. The sum of the three voltage for Y or A (Vs. Voc. Va) must be equal to zero .Why ? Did your readings of the voltages verify this condition? Prove that. 3. Did the power delivers from (DC power supply) is changed after using the conversion from A to Y. Prove that? 4. When we have three equal resistors for a Y connection prove that (the value of each resistor of the delta is equal to three times the value of any resistor of the Y).

Discussion: 1. Did your experimentali results verify the equivalence between the delta and star connections? (Compare the voltage and the currents in both cases). 2. The sum of the three voltage for Y or A (Vs. Voc. Va) must be equal to zero .Why ? Did your readings of the voltages verify this condition? Prove that. 3. Did the power delivers from (DC power supply) is changed after using the conversion from A to Y. Prove that? 4. When we have three equal resistors for a Y connection prove that (the value of each resistor of the delta is equal to three times the value of any resistor of the Y).

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

For a home, you planned to install a solar photovoltaic system. While measuring, you got the peak electrical load as 15kW and you decided to meet the all load by solar photovoltaic system during peak sun shine hours and life time of the system is 20 years. Consider the peak shine hours as 6 hours for that location with the solar intensity of 1000W/m2. (1) Calculate the total PV power generation from the system for its entire lifetime. (2) Calculate the loss in PV power generation if the solar intensity is reduced to 800W/m2 and 500W/m2 for 3 years.
a) A 380V, 7.5kW electric water pump of power factor 0.8 lagging and efficiency of 85% will be wired by an armoured XLPE insulated copper cable. The circuit will be run on cable tray with three other similar circuits at an ambient temperature of 40℃. MCCB will be used as the overcurrent protective device for the circuit. The estimated length of the circuit for the machine is 50m. i) Determine the minimum rating of MCCB for the circuit, available MCCB rating are 25A, 30A, 40A, 50A ii) Determine the minimum cable size of the circuit if the allowable voltage drop of the circuit is 1.5% of the nominal supply voltage?
A meeting hall in an organization is to be provided with a lighting installation. The hall is 30 m × 20 m × 8 m (high). The mounting height is 5 m and the required level of illumination is 144 lm/m2. Design a lighting system for the hall with the given data. Lumens/watt for 200-W lamp = 12 and Lumens/ watt for 500-W lamp = 16. Utilization coefficient = 0.6 Maintenance factor = 0.75 space/height ratio=1 Using metal filament lamps, estimate the following: Flux Luman output per 200 W lamp Luman output per 500 W lamp Number of 500W lamps required Number of 220W lamps required Draw the spacing layout of these lamps State the reason if any of these 2 lamps cannot be arranged in the hall with the given specification. What is the significance of ‘room surface maintenance factor’ and ‘utilization factor’ in the lighting design
write only the option The electrical power is delivered to the users through five distribution levels. True or False? A.True B.False The average supply restoration for voltage level 11 kV is A.more than 4 hours B.between 1 and 4 hours C.less than 4 hours Tariff is the rate of charging for electrical energy supplied by the utility company to its consumer. Tariff is depends on various factors excpet: A.Type of facilities B.Type of services C.Type of consumers D.Total fixed running annual charges of the utility company Under primary distribution netwrok system, the electrical power is delivered to the users through _________ distribution levels. A.3 B.5 C.2 D.4
Use mesh analysis to compute the current ?6Ω, and the power supplied (or absorbed) by the dependent source.
A wind energy system has been designed for 20 years of operation . The designed system has a wind turbine of power 600 kW with a capacity factor of 28.54% which costs $450,000. The installation place has the following terms and conditions: Price of electricity =$0.05 I kWhr Rate of return = 66% r = 5 percent/yr, the real rate of interest (1) Estimate the net yearly income from the system. (2)Estimate the return of investment. (3)Estimate the present value of electricity.
11.a. In dwelling units, motels, hotels, and other occupancies such as dormitories, nursing homes, and similarresidential occupancies, any luminaire or receptacle for plug-connected loads rated up to 1440 VA, or lessthan ¼ HP, shall be supplied at not more thanA. 277 V.B. 50 V.C. 120 V.D. 600 V. 11.b. A feeder neutral with a load of 400 A would be permitted the demand factor applied to ________of theload.A. 140 AB. 340 AC. 200 AD. 100 A
A barangay power station supplies 60kW to a load over 2,500ft, 100 mm², two conductors copper feeder. The resistance of which is 0.0078 ohm per 1,000 ft the bus bar voltage is maintained constant at 600V. determine the load current. Answer = 108 A
Calculate the total load and service for a 38 ft 28 ft (11.6 m 8.55 m) apartment building. Base your analysis on: Air conditioner - 2,000W Electrical Range - 10,500W Water heater, 3,500W Dishwasher - 1,000 W ..
TOPIC: Power Systems, Power Plants & IlluminationINSTRUCTIONS:- Answer in this format: Given, Illustration, Required Conversion, Solution, Final Answer.- Step-by-step solution, do not skip even simple calculations to avoid confusion.- If answered in written form, make sure it is readable.PROBLEM:A substation supplies power by four feeders to its consumers. Feeder No. 1 supplies six consumers whose individual daily maximum demands are 70 kW, 90 kW, 20 kW, 50 kW, 10 kW, and 20 kW, while the maximum demand on the feeder is 200 kW. Feeder No. 2 supplies four consumers, whose daily max. demands are 60 kW, 40 kW, 70 kW, and 30 KW, while the maximum demand on feeder No. 2 is 160 kW. Feeders Nos. 3 and 4 have a daily maximum demand of 150 kW and 200 kW respectively, while the maximum demand on the station is 600 kW. Determine the diversity factor for the four feeders. 1.18 1.25 1.30 1.36
A single family dwelling with a floor area of 80 square meters has the following receptacles and outlets load: a. Lighting 7 pcs – 40 watts fluorescent lamp 2 pcs – 20 watts LED lamp b. Convenience outlet 1 – Electric Iron ; 1,000 watts 1 – Portable Stereo; 100 watts1 – Electric Stove ; 1,100 watts 1 – Electric Fan ; 500 watts 7 cu. ft. Refrigerator; 175 watts Required: Circuit 1 – Lighting Load by the Area Method a. Determine the wattage required per square area. b. Determine the current load (230 volts) c. Compute the actual lighting load d. Solve the actual current load
An industrial customer with a three-phase, 480 V service entrance is running the followingset of loads:• One 12 ton heat pump1 with a COP of 2.7 and a 0.90 lagging power factor• Three 5 HP, 87% efficient lathes, 0.82 lagging power factor• Three electric autoclaves, 10 kBTU/h, 98% efficient, 0.97 lagging PF• One 12 kW high-intensity discharge (HID) lighting system, unity PFIf the lighting system is replaced with a T8 fluorescent system with magnetic ballast thatconsumes 25% less than the previous system, but introduces a 0.89 leading power factor, byhow much does the service entrance current change? Consider the case when all systems arefully loaded. Consider the AC load under the new lighting regime