Answered: Analyze the following AC networks,…

Analyze the following AC networks, define and calculate all voltages, resistances (if necessary) and ampers! 20 ww 120 ww- www 50/0

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter18: Resistive-inductive Parallel Circuits

Section: Chapter Questions

Problem 10PP: In an R-L parallel circuit, ET=240 volts, R=560, and XL=330. Find apparent power.

See similar textbooks

Related questions

Q: EXAMPLE: Find the total number of watts, volt-amperes reactive, and volt-amperes for the network. R…

A: The given electric circuit is, Determine the impedance for a R-L circuit: Z=R+jXL=3+j4 Ω According…

Q: Design 500 kV AC source used to test for an overhead transmission line by appropriate selection of…

A: You have asked multiple independent questions. We are authorized to answer one question at a time.…

Q: n ac motor is connected to a 560v, 60hz line. The motor has a current draw at full load of 53A. A…

A: Power factor is defined as -the cosine of angle between voltage and current.…

Q: Complete the sentence The power factor must be close to ……………. To insure that losses in the…

A: To find the answer

Q: 1. A piece of equipment consumes 3800 W when supplied with 250 V and takes a leading current of 25…

A: In this question, We need to value of parallel elements to make total impedance non inductive type.…

Q: distribution network

Q: Given voltage source = 100V∠0°, give the value of real power, apparent power, and reactive power…

Q: 20 Vrms source supplies a parallel RLC circuit with the following values: R=100 ohms, XL=200 ohms…

Q: Q1/ For the circuit shown below, determine the value of Vo, using Nodal analysis. ww 12 V

A: We will use nodal analysis to get required voltage.

Q: Electric Circuit Analysis 2020/2021 Dr. Yaseen H. Tahir Example: Convert the following quantities…

Q: Using an AC voltmeter, the potential difference in the electrical line in a house is read to be 234…

Q: A 50 km, 60 Hz transmission line has a resistance of 6 Q and its magnitude equal to 10. Then its…

Q: 80 50V

Q: - The voltage drops across two components when connected in series across an AC supply are vi (t) =…

A: The circuit this is excited the use of alternating supply is referred to as an AC Circuit. The…

Q: For the circuit shown, what is the complex power, S, average power, Pay, and reactive power, Q,…

Q: an overhead transmission line has a span of 220 meters the conductor waiting 0.604 kg/m.What will be…

A: Given: Span, L=220 m Weight of conductor, w=0.604 kg/m Tension, T=2879 kg

Q: Electric Circuit Analysis 2020/2021 Dr. Yaseen H. Tahir Example: Convert the following quantities…

A: To covert the given quantities from polar form to rectangular form

Q: When an impedance coil is connected to a 114 volt 60 cps source, the current is 3 A. If the current…

A: Let inductance =L resistance=R hence impedance of coil=R+jωL

Q: 4) For AC supply voltage of 120 Vac, frequency of 60Hertz and capacitive value of 10.61 micro Farad…

Q: A power station has a daily load cycle as under; 260MW for 6 hours; 200MW for 8 hours; 160MW for 4…

A: The load factor (LF) of a power station is the ratio of average load (AL) on power station to…

Q: A dc transmission facility is modeled by the approximate series circuit shown below. If the load…

Q: J52 K J82 For the circuit shown, find the value of coupling coefficient "k" and put the dots on the…

Q: A single-phase 60 miles 69kV transmission line consist of two 000-AWG solid copper conductors spaced…

A: In this question we need to find a capacitance of the given transmission line.

Q: A single phase transmission line is transmitting 1,100 KW power at 11 KV and at unity power fector.…

A: Efficiency of the transmission line is given by the following equation

Q: A 397-Vrms, 60-Hz supply serves a load that is 10 kW (resistive), 5 kVAR (capacitive), and 15 kVAR…

Q: 7) A 480 volts distribution system delivers a load of 120kw 0.707 pf lagging, what value of the…

Q: 3. Find using nodal analysis 3A 100 ww 202 50i, www 20V 202

Q: Q3: A three-phase transmission line delivers 15 MW at 132 kV with 0.8 power factor lagging. The loss…

A: Given that VL=132KVP=15MWcosϕ=0.8 (1) Formula of delivered active power from 3 phase transmission…

Q: A 130- VOLT 50-CY CLE s OURCE IS CONNECTED TO SERIES CKT. CONSISTIING OF A 402 RESISTOR AND 2IO…

Q: An overhead single phase short transmission line delivers 4000 kW at 20kV at 0.8 pf lagging.…

Q: Find the magnitude of the impedance for the network, and the magnitude and phase of the supply…

A: In this question , we will find impedance of network...And supply current...

Q: The capacitance per kilometre of a 3-phase belted cable is 0.18 µF between two cores with the third…

Q: 102 www. Q.15: For the mutually coupled circuit shown: 1. Find the equivalent circuit? 2. Find the…

A: Given circuit is =

Q: Consider a building with a real power demand of 650 kW and reactive power demand of 480 KVAR.…

A: In building Power demand 650KW Reactive power 480KVAR The power factor? Capacitor rating to be…

Q: Which of the following has the highest percentage of occurrence in a power network? LLL SLG LL DLG

A: The detailed answer is solved below according to the given parameters and instructions in the…

Q: An equipment has a per unit impedance of 0.8 on a base of 50 MVA, 66KV. The actual value of…

A: Given an equipment has, Per unit impedance, Zpu=0.8 pu Base MVA, Sbase=50 MVA Base voltage, Vbase=66…

Q: The capacitance of a single phase two-wire transmission line depends on: Select one: O a. All the…

A: Capacitance of a Single Phase Two Wire Line consisting of two parallel conductors A and B spaced d…

Q: A dc transmission facility is modeled by the approximate series circuit shown below. If the load…

Q: Draw block diagram of solar photovoltaic system which generates DC power and supply AC power (220V…

Q: Which the following parameters are considered for analysis of AC distribution system? O a.…

A: In ac we need to analyse active and reactive power consumption by the distribution system, and we…

Q: QI By applying Nodal method of network analysis, find the current (Ix) as shown. 3A 10 Ix Amp. 23 73…

A: We will apply KCL at both nodes to find node voltage, using ohms law we will find current.

Q: An over head transmission line supported from two towers location at the same level. The distance…

A: A sag in the transmission line is defined as the vertical distance between the wire and its tower…

Q: Given a mesh connected system with reactive factor of 60 percent and true power of 2,500 kW.…

A: We need to find out reactive power

Q: Wind turbine is considered one of the prime mover types. (T or F) • Transmission lines are used to…

A: 1)Prime mover: it is a machine which converts some energy in to useful work as in wind mill as a…

Q: Consider the network depicted in the following figure, and determine the equivalent impedance seen…

A: In given circuit, XL=jωL =j 34×2 =j 68 ΩXc=1jωC=1j×34×2×10-3=-j 14.70 Ω

Q: Refer to the parallel ac network below: 10 Ω 500 µF, 0.5 H wwww 13 100 µF wwww 12 ο.1 Η wwww 100Z0°…

A: To find the total admittance of the network and supply current Admittance Y = 1/ Z

Q: The AC EMF in this electric circuit is described by the following equation: = 3 = 18mF, L = (12V)…

A: In this question, Find the average power supplied by the source E. Power P= VI cos(V^I) watt

Question

Analyze the following AC networks, define and calculate all voltages, resistances (if necessary) and
ampers!
120
j6 2
50/0

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 8 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Alternating Current (AC) Series Motor and Universal Motor

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

3. What is power factor?
What load may be used for an electric range rated at not over 12 kW? (Table 220.55) _____
In an R-L parallel circuit, ET=240 volts, R=560, and XL=330. Find apparent power.
Exercise 2: Resistance-Capacitance Series Circuits on an AC Supply Calculate (a) peak to peak voltage (b) time period (c) Total impedance (d) Total voltage and (e) Voltage across the resistor for the circuit given.
Three coils each having resistance 6  and inductance are connected in star with 415V. If the line current is 30 A, find the value of inductive reactance as well as inductance value. If θ = 450 then calculate the power dissipation in kW when it is connected in Delta?
Three coils each having resistance 6  and inductance are connected in star with 415V. If the line current is 30 A: a) find the value of inductive reactance as well as inductance value? B) If θ = 45 then calculate the power dissipation in kW when it is connected in Delta.
The Dc value of a pure Ac voltage source is zero Select one: True False
Variation of which of the following parameter is not consider as power quality problem for industry?VoltageCurrentPowerFrequency
Consider a 3-phase, 50 HZ, 11 KV distribution system. Each of conductors is suspended by an insulator string having two identical porcelain insulators. The self-capacitance of the insulator is 5 times the shunt capacitance between link and ground. Find the voltages across two insulators.
Draw block diagram of solar photovoltaic system which generates DC power and supply AC power(220V and 50Hz) to the load.
Discuss the concept of power quality in a power system and the various issues, such as harmonics and voltage sags, that can affect it.
The capacitance per kilometre of a 3-phase belted cable is 0.18 µF between two cores with the third core connected to sheath. Calculate the kVA taken by 20 km long cable when connected to 3-phase. 50 Hz, 3300 V supply.