Draw a complete mechanism for the reaction below. Start by redrawing the reactants to include all lone pair electrons, then draw in all necessary arrows to show conversion to the products (redraw the products as well, showing all lone pair electrons). OMe

Q: 10.105 Complete and balance each of the following: (10.7) a. ZNCO3(s) + H,SO,(aq) b. Al(s) + HBr(aq)

A: Active metal react with acid give hydrogen gas

Q: How many grams of Mg3(PO4)2 are needed to make 3.000 L of a 2.500 M solution ?  The GFW for…

A: Formula used: Mole = weight of compound/ Molar mass  Molarity = no of mole / volume in L  So no of…

Q: mass of precipitate

A:

Q: Titanium can be produced by electrolytic reduction from an anhydrous molten salt electrolyte that…

A: Answer: Reaction of formation of Ti(s) through electrolysis is TiCl4(l) is shown below:…

Q: using a standard 0.100 M sodium hydroxide solution to titrate 50.0 mL of a 0.100 M hydrochloric acid…

A: A question based on acid-base titration that is to be accomplished.

Q: Calculate the pH of the solution that results when 56.0 mL of 0.1510 M NH. is a diluted to 90.0 mL…

A:

Q: At T=480.4 °C, when an excess copper (Cu) metal is put into 1.5 M HCl solution, hydrogen gas and…

A:

Q: How many moles in 3.0 L of a 2.00 M solution of sodium chloride ?

A: Given :-  Molar concentration/molarity of NaCl solution = 2.00 M or 2.00 mol/L  Volume of solution =…

Q: Which indicator is used in the complexometric titrations of zinc with EDTA? Define Hardness of…

A:

Q: Potassium thiocyanate, KSCN, is often used to determine the presence of Fe+ ions in solution by the…

A:

Q: Which of the following would be considered the cons of using nuclear fission? Check all that apply.…

A: Solution- Nuclear fission- It defines as Nuclear fission is the splitting of a heavy atomic nucleus,…

Q: write a general rule that defines acid strength, using the concentrations of HA, H,O, A', and H,O*…

A: Strength of an acid is determined from its dissociation in water.

Q: Why is the C-C bond length of an alkyne shorter than the C-C bond length of an alkene? O The…

A: Alkyne contains 2 pi bonds along with one sigma bond while alkene contains 1 pi bond and one sigma…

Q: he final product when 1-methylcyclohexan-1-ol

A:

Q: Assume the energy of hydrogen bonds per base pair to be 5.86 kJ-mol-1. Given two complementary…

A:

Q: To make a common phosphate buffer using potassium hydrogen phosphate and potassium dihydrogen…

A: Answer: A buffer solution is the type of solution that resist the change in its pH on adding small…

Q: An experiment was carried out by reacting cyclopentanone and water in the presence of potassium…

A:

Q: Suppose a 0.32M aqueous solution of oxalic acid (H,C.0,is prepared. Calculate the equiteum molarity…

A:

Q: Calculate the ph of a solution that is 0.040 M in HI.

A:

Q: Predict ducts of the reaction below. That is, complete the right-hand side of the chemical equation.…

A: Neutralization reaction: The hydrogen ion of acid reacts with the hydroxide ion of a base to form…

Q: A 0.5000 g sample containing NaCl (58.44 g/mol), BaCl2 (208.23 g/mol), and 11.56% by mass of…

A:

Q: For the complex [Co(en)2(OH)2]OH, what is the oxidation state of the central metal in the complex?

A: Given :- [Co(en)2(OH)2]OH  To determine :- oxidation state of central metal in given complex

Q: What is the unique reaction rate [in mM/s] for the reaction 2A + 4B 2C if the rate of consumption…

A:

Q: Solid barium nitrate is slowly added to 75.0 mL of a 0.0478 M ammonium sulfite solution. The…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Calculate the [H*] in a solution that has a pH of 9.16.

A: Given :- pH of solution = 9.16  To calculate :- [H+] i.e. hydrogen ion concentration

Q: Carbonated cola is more acidic than coffee or even orange juice because cola contains phosphoric…

A: • The values provided in the question are:-      i) pH of a carbonated cola solution = 3.120    • We…

Q: H2(g) + C2H4(g)- C2H6(g) Using standard absolute entropies at 298K, calculate the entropy change for…

A: Given-> Moles of H2 = 2.46 mole H2(g) + C2H4(g) ----> C2H6(g)

Q: What is the molar mass of a gas if 1.31 grams of the gas in a 0.497 L flask at 281 K has a pressure…

A: Ideal gas equation: The temperature, pressure, volume, and mole of the gas are related to the ideal…

Q: QUESTION 2 2. A weak acid was titrated using 0.20 M KOH. The pH at several volumes added was…

A: On the curve, the equivalence point is located where the graph is most steep. At equivalance point…

Q: 1.1 Fill in the missing (correct) words only: (a) In general, as behavior increases. (b) For an…

A:

Q: Assuming that the molecular orbital energy level diagram for carbon monoxide, shown in the Figure…

A: To answer these questions we would first draw Molecular orbital diagram for CN molecule .

Q: What are the differences between a highly concentrated weak acid and a highly concentrated strong…

A: To differentiate: Between a highly concentrated weak acid and a highly concentrated strong acid.

Q: 0.20 M solution of a compound shows a yellow color with BCG and a yellow color with TB.  What is the…

A: The pH range for Thymol blue indicator is 1.2 - 2.8. Appears red in acidic solution and yellow in…

Q: Draw the major product of this reaction. Ignore inorganic byproducts. HO, 1. SOC2 2. CH3CH2OH,…

A:

Q: Benzocaine experiment 1. Why was a mixture of CH3OH / H2O used for recrystallization of the crude…

A: Both ethanol and methanol are water like solvents (by virtue of the hydroxyl group); for this…

Q: 3.A Calculate the following integral involving the speeds of gas particles at 298 K for a gas with a…

A: Solution: Data given- temperature = 298K , gas with a molar mass of 48.1 g/mol.

Q: The radius of a single atom of a generic element X is 149 pm and a crystal of X has a unit cell that…

A:

Q: Draw the major product of this reaction. Ignore inorganic byproducts, methanal (H2CO) or CO2. 1. O3…

A: Given reaction is ozonolysis reaction.  Terminal Alkenes on ozonolysis gives aldehyde and methanal…

Q: Assume the concentration silver nitrate and gold(III) nitrate are each 1 M. Write the standard cell…

A: Please open the attachment.

Q: Which choice gives the classification for D-threose? O aldotetrose O ketotetrose O aldopentose O…

A:

Q: A cube of brass, 2 cm on a side is heated until the temperature of the brass is 75°C. The cube is…

A: Given: Side of cube = 2 cm Volume of water = 100 mL Initial temperature of water = 23 oC And the…

Q: 1. When you arrive at the lab, 2.0 M H2SO4(aq) and 2.0 M HC2H3O2(aq) will be present. You will need…

A: Since you have posted multiple questions, according to guidelines I am solving first one.If you want…

Q: Consider the reaction: NH4CI(aq)NH3(g) + HCI(aq) Using standard absolute entropies at 298K,…

A:

Q: 1.1 Fill in the missing (correct) words only: (a) In general, as behavior increases. (b) For an…

A: We have find out fill in blanks. Note -As per our company guidelines we are supposed to answer only…

Q: Terminal alkynes have a relatively acidic proton. This proton can easily be deprotonated converting…

A: Terminal alkynes are much more acidic than most other hydrocarbons. Elimination reaction required…

Q: use 17.89 mL (experimental volume) and 0.00074044 mol H2 (theoretical moles of hydrogen gas) to…

A: Given: Volume of gas = 17.89 = 0.01789 L                                    (Since 1 L = 1000 mL)…

Q: The name given to an aqueous solution of HNO3 is what?

A: Nitric acid (HNO3) is a strong acid because when it is dissolved in an aqueous solution, it…

Q: Part A There are conventions for naming and constructing the formulas for acids and bases just as…

A:

Q: An electric current of 0.760 A flows for 54.0 seconds. Calculate the amount of electric charge…

A: The electric charge transported can be calculated as follows

Q: A voltaic cell uses the following reaction T (aq) + 2Cr TI(aq) + 2Cr (aq) has a measured standard…

A:

Designing a Synthesis

Organic synthesis is a branch of chemical synthesis that involves the planned construction of organic compounds/molecules from smaller units that possess functional groups. Friedrich Wöhler was the first scientist who designed the synthesis of an organic compound, urea from inorganic starting materials silver cyanate with ammonium chloride via a simple, one-step synthesis.