Answered: Draw the layout of gas turbine plant…

Engineering

Mechanical Engineering

Draw the layout of gas turbine plant which has two stage of compression with perfect inter-cooling

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter35: Comfort And Psychrometrics

Section: Chapter Questions

Problem 12RQ: A gas furnace has an output of 60,000 Btu/h. The return air temperature is 72F, and the temperature...

See similar textbooks

Related questions

Q: solve a,b and c asap. A steam turbine with rated capacity of 56.4 MW operates with steam at inlet…

Q: In a geothermal power plant, vapour is converted into working fluid in the Select one:

A: Solution:

Q: A refrigeration system with a capacity of 10 tons of refrigeration, operates at 210 kPa evaporator,…

Q: The Figure shows a steam engine based on insulsted turbine. The boiler has a volume 100 liters and…

Q: The steam from a boiler enters a steam turbine and work is done by the steam turbine. After work…

A: Answer: The correct answer is option (a) i.e. Open system.

Q: (B) A liquid subcooler as shown in the Figure receives To high-stage liquid ammonia at 30°C and…

Q: Provide the given, manual step by step solution, and diagram of below problem. The heat added to a…

Q: Q1: A steam turbine gets its supply of steam at 70bar and 450 °C after expanding to 25bar in high…

A: We Will Use The Mollier Chart For Finding The Value Of Enthalpies.

Q: alculate the theoretical power required to operate the compressor.

A: GIven: RE= 10 tons Ph= 750 kPa Pl=210 kPa To determine: power required to operate the compressor

Q: 4. An ideal double reheat steam turbine receives 300,000 kg/h of steam at 10 MPa and 400°C. After…

A: Given DataT=400CP=10MPam=300,000 kg/hr ***Company policy we are supposed to do only three…

Q: A refrigeration system with a capacity of 15 tons of refrigeration, operates at 150 kPa in the…

A: Given, Refrigeration effect ,QR = 15 tons = 15 * 3.5 KW = 52.5 kw Refrigerant - R717 - ammonia…

Q: 3- the highest pressure and temperature of water in the power plant cycle is located a. at the…

Q: thermodynamics Two pounds per second steam enters the turbine at 500 ft/s with 600 BTU/lb enthalpy…

Q: A refrigeration system is used to cool water in the evaporator at 7.5 kg/s from 30°℃ to 4°C.Find the…

A: Given data: m˙=7.5 kg/sT1=30°CT2=4°CCOP=5 Need to determine the required compressor power.

Q: lot the COP of regerigerator and heat pump for temperature range from 1 degree celcius to 28 degree…

A: To determine the COP of refrigerator and heat pump.

Q: Нeat 3-3 A “real" Brayton cycle is shown in Figure 3-3. The cycle starts at 300K (T1) and a pressure…

Q: Q1/A power plant operating on Carnot cycle that produces (500MW). It turned out that this represents…

Q: A centrifugal compressor has a single stage and 4 stage model with suction conditions of 100 kPa and…

Q: The figure to the right gives the schematic of an air conditioner cycle that steadily circulates…

Q: A two-shaft gas turbine power plant is shown in Figure Q2 (b). All the power developed by the…

A: Calculated the temperature at the exit of high pressure turbine. And thermal efficiency ,back work…

Q: Subject: Power Plant How To determine equivalent evaporation of boiler in steam power plant?

A: Given Data⇒ Equivalent evaporation of boiler Steam power plant

Q: In a Geothermal field, saturated steam at 5 MPa is available flowing at a rate of 90,000 kg/hr per…

A: The above-given process is based on the Rankine cycle, which comprises 4 processes: Process 1-2:…

Q: A turbine-based steam engine consists of a tank, regulator and turbine. The tank with a volume of…

Q: A refrigeration system with a capacity of 15 tons of refrigeration, operates at 150 kPa in the…

A: Solution is given below.

Q: Most of the heat in waste heat boiler is absorbed by steam at

A: in the boiler system,flue gas exits the boiler and after that it enters an economizer.

Q: Steam engine with incomplete expansion receives saturated steam at 1.04 Mpa, expands it to 0.105 Mpa…

A: Since you have posted a question with multiple sub-parts, and each subparts there are more than one…

Q: A refrigeration system with a capacity of 10 tons of refrigeration, operates at 210 kPa in the…

A: Consider the diagram shown below for the given refrigeration system.

Q: pressor at 400 kPa as a saturated vapor at a rate of 80 L/min COP, (b) the maximum COP, and (c) the…

Q: A refrigeration system with a capacity of 10 tons of refrigeration, operates at 210 kPa in the…

Q: Q(2-3)A gas-turbine power plant operates on Brayton cycle. The air pressure inside the combustion…

A: We are suppose to solve only 3 subparts. Please post other parts as a separate question.

Q: A canrnot engine receives 180 BTU of heat from a hot reservoir at 500 F and rejects 60 BTU of heat.…

A: Given Heat supplied , Qs=180 BTUHot reservoir temp, T1=500 FCold reservoir temp , T2= ?Heat rejected…

Q: A refrigeration system employs R12 is used for a domestic heating unit. The The capacity of the…

Q: Draw the schematic diagram for regenerative vapour power cycle with 2 steam bleds. Represent the…

Q: Show also the P-s and T-s diagram. Catalogue data for R-134A compressor with a displacement of 75…

Q: Calculate the power output from the turbine. Assume the process is adiabatic. Calculate the heat…

Q: I. Draw the h-s & T-s diagram of the system below CONSIDERING "WORK IN" AS PROCESS 1-2. 2 POUT…

Q: A refrigeration system with a capacity of 15 tons of refrigeration, operates at 150 kPa in the…

Q: using the values given in the two evaporator refrigeration system a) Draw the T-s diagram.…

A: (a) The T-s diagram for the processes in the given system is shown below.

Q: Read the question carefully before answering. Box or indicate your final ansurers when solving and…

Q: The first of the two heat pumps operating on the reverse Carnot cycle 0 between 0C and 22oC, and the…

Q: An ammonia system with a 158-kW evaporator operating at -1°C and a 35-kW evaporator operating at…

A: INTRODUCTION : The compressor is one of the important devices in the refrigeration system. The main…

Q: A heat pump operates between 36 degrees fahrenheit and 120 degrees fahrenheit . If heat added from…

A: Given: Cold temperature reservoir (TL)=36°F or 491.67°R High-temperature reservoir (TH)=120°F or…

Q: A refrigeration system with a capacity of 15 tons of refrigeration, operates at 150 kPa in the…

Q: four-stage single-acting air compressor running in an atmospheric at 87 kPa and 15°C has a F.A.D of…

A: here for perfect intercooling process . reach stage = (7000/80)4 = 3.058 (answer 1)

Q: A combined cycle power plant uses mercury (Hg) for the high-temperature cycle (topping cycle shown…

A: The T-s diagram is

Q: What are the intercooler pressure in a three stage compressor with suction pressure of 101.325KPa…

A: In a series of compressor the compression ratio is constant for every stage, Here let inlet pressure…

Q: A turbine engine air intake is at pressure and temperature of air drawn 99 kPa and 29 °C…

A: Given Data Compressor inlet : 99 kPa, 29°C Turbine Inlet: 990 kPa,888°C K=1.4

Q: 2. A gas turbine that operates on Brayton cycle provides a furnace with hot pressurize through its…

Q: 2. A 10 MW steam turbine generator power plant has a full- load steam rate of 12 kg/kw-hr. Assume…

Q: Regenerative steam power plant shown in figure below employs two feed heaters which are optimally…

A: Given:

Question

Draw the layout of gas turbine plant which has two stage of compression with perfect inter-cooling. The high pressure turbine develops power enough only to drive the high pressure compressor. The low pressure turbine derives both the L.P compressor and load. Show the ideal process of this plant on T-S diagram.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

In a marine gas turbine unit, a high-pressure stage turbine drives the compressor and a low-pressure stage turbine drives the propeller through suitable gearing. The overall pressure ratio is 4/1 and the maximum temperature is 650 o the isentropic efficiencies of the compressor, H. P. turbine, L. P. turbine are 0.8, 0.83 and 0.85 respectively and the mechanical efficiency of both shafts is 98 %. Sketch the process on the T-s diagram i. Calculate the pressure between turbine stages when the air intake conditions are 1.01 bar and 25 oC. ii. Calculate also the thermal efficiency and the shaft power when the mass flow is 60 kg/s. NB: Neglect kinetic energy changes and the pressure loss in combustion.
The first of the two heat pumps operating on the reverse Carnot cycle 0between 0C and 22oC, and the second between -18oC and 22oCis working. Find the percentage increase between the compressor powers since both are heating at the same value.
In a 14 TR ammonia refrigeration plant, the condensing temperature is 250C and evaporating temperature -100C. The refrigerant ammonia is sub-cooled by 5 0C before passing through the throttle valve. The vapor leaving the evaporator is 0.97 dry. Find: 1. Coefficient of performance: and 2. Power required. Use refrigerant table for properties of ammonia at 250C and -100C.
In a refrigerator the power rating impressed on the compressor is 1.2 kW. The circulating wire in evaporator is 5 kW and the cooling water took away 10 kW from condenser coil. The operating temperatures range is 18ºC and 0ºC and their corresponding latent heats are 170 kJ/kg and 230 kJ/kg and the difference between theliquid energy is 35 kJ/kg. Find the actual COP of the system (2) relative COP, assuming the vapor is just dry and saturated at the end of the compression.
Provide a complete given and computation. Include all the decimals. There are received 68,000 kg/h of steam by an ideal regenerated engine, having only one heater, of which the heater receives 15,400 kg/hr the condenser receives the remainder at 0.007 MPa. If the heater pressure is 0.96 MPa, find the state (quality or "SH) of the steam (a) at the heater entrance and (b) at the condenser entrance.
a boiler is producing steam at pressure of 15 bar and quality as 0.98 dry. If the water supplied through feed check valve is at 30°C ,what amount of heat the boiler is using in producing of 1 kg of steam? Also find the overall boiler efficiency in case it is observed that in one hour operation 1000 kg of steam is produced and 82.5 kg of fuel with calorific value = 35000KJ/kg is consumed.
write legibly pls A simple gas-turbine operates with air as the working fluid, a pressure ratio of 18:1 and a maximum temperature of 700°C. The air enters the compressor at 100kPa and 20°C. Determine: a. Thermal Efficiency of the cycleb. The heat addedc. The state of the air exhausted by the turbine
A net of 2500 kW is needed from a gas turbine engine. Air enters the compressor section at 13.005kPag, 315K. The turbine sections receive the hot gas at 1905 K. Draw the (a) P-V and T-S diagrams. Find (b) air flowand, (c) thermal efficiency. (d) For the maximum work, what should be the temperature of the air leaving thecompressor. Consider rp = 11, k = 1.35 and R = 260.078 J/kgm-K.
can you please solve this for me (the fraction of steam extracted from theturbine for the open feedwater heater)
Question-3As seen in the figure, the stable air conditioner keeps the indoor environment at 21oC while the outdoor environment is 32oC. Since the heat transfer rate from the roof and walls to the house is 31,650 kJ/h, is the 2.2 kW power input to the compressor of the air conditioner sufficient? If sufficient, calculate COP, if not, find the theoretical minimum power in kW
Q2: 26 tons of ice from and at 0°C is produced per day in an ammonia refrigerator. The temperature range in the compressor is from 26°C to -15°C. The vapour is dry and saturated at the end of compression. Assuming actual COP is 62% of theoretical, calculate the power required to drive the compressor. Take latent heat of ice 335 kJ/kg.
I- In the compression process of an internal combustion engine, the thermodynamic energy of the gas is increased with 370J. During the process, the gas releases heat to the cooling water with 20J. Please calculate the compression work consumed during the process.