During a test, a rocket travels upward at 70 m/s and when it is 30 m from the ground its engine fails. Determine the maximum height Sb reached by the rocket and its speed just before it hits the ground. While in motion the rocket is subjected to a constant downward acceleration of due to gravity. Neglect the effect of air resistance. Determine also the Velocity at Point C, Vc. use 2 decimal places.

During a test, a rocket travels upward at 70 m/s and when it is 30 m from the ground its engine fails. Determine the maximum height Sb reached by the rocket and its speed just before it hits the ground. While in motion the rocket is subjected to a constant downward acceleration of due to gravity. Neglect the effect of air resistance. Determine also the Velocity at Point C, Vc. use 2 decimal places.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

When the snowmobile leaves the A obstacle at an angle of 40 degrees, its speed is 10 m / s. As it fell to the ground at point B:a) flight time, t1b) his horizontal distance, Rc) The velocity components and the magnitude of velocity at Point B, V = Vxi + Vyj and | V |calculate.
Two water streams of the same size and speed crash like in the picture. Determine the speed V of the resultant combined stream. Gravity can be ignored. Express the result in [ft/s]
Application of de A motorboat and its load weigh 2,450 N. AssumIng that the propeller force is constant and equal to 120 N, and water resistance is equal numerically to 7.50v N, where v is the speed at any instant in m/sec., and if the boat starts from rest, determine the speed and the distance traveled at the end of 10 seconds.
A pump is located near the edge of the horizontal platform shown below. Thenozzle at A discharges water with an initial velocity of 13 m/s at an angle 55° withthe vertical axis. A. Increase the height of cannon from 0 to 15 m at the increment of 1 m andcalculate the horizontal and max vertical distances at each height. B. Evaluate the change of angle of nozzle on horizontal and vertical distance atHeight of 1 m, 5m and 10 m (Try angle of 30°, 45°, 65°)
A jet is flying straight and level at a speed v0 = 1300 km/h when it turns to change its course by 90° as shown. In an attempt to progressively tighten the turn, the speed of the plane is uniformly decreased in time while keeping the normal acceleration constant and equal to 8g, where g is the acceleration due to gravity. At the end of the turn, the speed of the plane is vf = 800 km/h. Determine the radius of curvature ρf at the end of the turn and the time tf that the plane takes to complete its change in course. The radius of curvature ρf at the end of the turn is ___ m.(Round the final answer to one decimal place.) The time tf that the plane takes to complete its change in course is ___ s. (Round the final answer to four decimal places.)
As seen on the figure, the skateboard rider leaves the ramp with the initial velocity VA at 30-degree angle. Determine the initial velocity and the time it took to land at point B.
A freight train travels at v = 60(1-e-t) ft/s, where t is the elapsed time in seconds.Determine the distance traveled in three seconds, and the acceleration at this time. Draw the necessary diagrams.
Q.No.4.A rocket is fired vertically and ascends with a constant vertical acceleration of 20 m/s2 for1.0 min.Its fuel is then all used and it continues as a free-fall particle.(a).what is the maximum altitude ? (b).What is the total time elapsed from takeoff until the rocket strikes the Earth?(ignoring the variation of g with altitude).
A worker uses high-pressure water to clean the inside of a long drainpipe. The water is discharged with an initial velocity v0 of 15.900 m/s. Determine the distance d to the farthest point B on the top of the pipe that the worker can wash from his position at A.
Steep safety ramps are built beside mountain highways to enable vehicles with defective brakes to stop. A 10-ton truck enters a 15° ramp at a high speed v0 = 108 ft/s and travels for 6 s before its speed is reduced to 36 ft/s. Assuming constant deceleration, determine (a) the magnitude of the braking force, (b) the additional time required for the truck to stop. Neglect air resistance and rolling resistance.
The depth of water flowing in a rectangular channel of width b at a speed v1 and a depth d1 increases to a depth d2 at a hydraulic jump. Express the rate of flow Q in terms of b, d1, and d2.
The jet car is originally traveling at a velocity of 10 m/s when it is subjected to the acceleration shown. When t= 0, s = 0. Suppose that a1 = 4.5 m/s2 , a2 = -2.5 m/s2 , and t′' = 13 s Determine the car's maximum velocity. Express your answer to three significant figures and include the appropriate units.