Eight kg of water is heated at a pressure of 600 kPa to produce a mixture with the quality x = 0.6. The final volume occupied by the mixture in m3 is O 1.750727 O 1.840565 O 1.518883 O 1.707111

Q: An OPEN SYSTEM is one in which both the heat and work as well as mass of the working substance cross...

A: Given data: Open system

Q: While drying a material from a moisture content above the critical moisture content to a moisture co...

A: This question is based on Drying of solids. We will analyze each question and then find the answer. ...

Q: With reference to the polymerisation mechanisms explain why the polydispersities of the two samples ...

A: Introduction Polydispersity (PD) is defined by the ratio of the weight-average molar mass Mw and the...

Q: How many joules of chemical energy are there in one liter of gasoline? Your group’s solution needs t...

A: Dear User! As per our authoring guidelines, we have answered the first three subparts in the order t...

Q: f A at location 2 with respect

A:

Q: In a piston-cylinder arrangement, energy is added and the piston is withdrawn in such a way that the...

A:

Q: Using Maxwell's relations, find the equivalent expressions for the following. (a) ()s (b) ()s (c) ()...

A: As per Bartleby Sub-parts Question Guidelines. We are Supposed to answer only first 3 question. Kind...

Q: i need the answer quickly

A: Since you have asked multiple question, we will solve the first question for you. If you want any sp...

Q: Figure 1 shows the elementary reactions of ethylene oxide in series take place in a continuous const...

A:

Q: Rate of chemical reaction (r) in a closed isothermal constant pressure homogenous system is defined ...

A: Introduction

Q: b) Two students were working in a lab to determine experimentally the viscosity of the same substanc...

A: Given, The viscosity of a substance by student A, μA = 10.0 Pa·s The viscosity of a substance by stu...

Q: True or false. if the statement is FALSE, place the correct word/s that should replace the word/s in...

A: Saturated liquid is the liquid which is at its bubble point.

Q: 1. (C, = 2.09 kJ/kg-K; p = 900 kg/m³) and it is cooled from 366.5 K to 344.3 K by 2.02 kg/s of water...

A: Given data: Properties of oil (hot fluid) are, mh=  5.04 kg/s cp,h=  2.09 kJ/kg.K Density = 900 kg/m...

Q: 10.2. Assuming Raoult's law to be valid, prepare a P-x-y diagram for a temperature of 90°C and ar--y...

A: The vapor-liquid equilibrium behavior of the system is represented by this pressure-mole fraction an...

Q: d) What is the main role of the chemical engineer and how he/she is distinguished from the chemists?...

A:

Q: b) In making sugar-based product, it is necessary to crystallize the sugar solution. For crystalliza...

A:

Q: What is the pressure 24.0 m below the surface of a lake? The pressure at the surface is 12.6 m H20 a...

A: Given, Pressure at surface=12.6 m H2O Depth from surface=24 meter g=9.81 m/s2  

Q: The effects on polymer addition to the mixture of colloidal particles has been widely reported. With...

A:

Q: Finds 군x, 군y, Zxx, 군ys, 군xy, 2sx Z = Ln (X+y)

A:

Q: 2. A compound contains 43.38 percent Na, 11.33 percent C, and 45.29 percent oxygen. What is the empi...

A: Given, mass % of the components are 43.38% Na, 11.33% C and 45.29% O.   Let the mass of the compound...

Q: A simple Rankine cycle works betw een pressures 64 bar and 10 Kpa, the initial condition of steam be...

A:

Q: 1. Calculate the orsat analysis of the products of combustion upon burning pure hexane with 38% exce...

A:

Q: SATURATED VAPOR is vapour that is about to condense. *

A: Since saturated vapour is at saturated temperature so any decrease in temperature will lead to conde...

Q: Calculate the time to reduce the number of moles of A to 1% of its initial  value in a constant-volu...

A: following values are given in the question A        ⇒          Binitial concentration of A=CA0final ...

Q: Explain the importance of the compressibility factor.

A:

Q: Steam at 500 K with specific volume 85 cm3/g exists as SATURATED VAPOR. *

A: Given: T = 500 V = 85 cm3/g

Q: A0 and CB0= CC0= CD0 =

A:

Q: Viscous fluid flows down a pipe of circular cross-section r=a under a constant pressure gradient P =...

A:

Q: Q/ A body of mass 5kg falls from a height of 500 cm above the ground. Find Potential energy stored i...

A: Given that, Mass of the body m = 5 kg Height h = 500 cm = 5 m g = 10 m/s2 It is required to calculat...

Q: Problem 1: Continuity and Energy Balance Below is a schematic of a Venturi device. It is esstentiall...

A: Given: Diameter at the inlet D1= 5.5 cm=0.055 m Diameter at the outlet D2=3.3 cm=0.033 m Pressure di...

Q: Internal energy depends on the PRESSURE of the ideal gas.

A: Given data: Internal energy of the ideal gas.

Q: The surface temperature of asphalt (& = 0.93) pavements during hot summer days is approximately 50C....

A:

Q: Subcooled or compressed liquid is the phase of water when it is NOT CLOSE to vaporizing.

A: Given data: Subcooled or compressed liquid. (water)

Q: Using the False Position method, the value xr computed is used to replace either of the two initial ...

A: False position method: False position is almost the similar method to bisectional method It is one o...

Q: 3. The reaction A > B is to be carried out isothermally in a continuous-flow reactor. The entering v...

A:

Q: Calculate the molar volume of saturated liquid (use SRK equation) and the molar volume of saturated ...

A: Given: n-butane at Psat=15.41 bar Calculating molar volume of saturated liquid by RKS method and mol...

Q: On a stove, a rigid high-pressure cooker has a volume of 0.003 m³ contains saturated liquid- vapor m...

A: Given data: Volume of mixture = 0.003 m3 Initial temperature = 95 0C Initial quality = 2 % Temperatu...

Q: Explain (Linear variable differential Transformer) LVDT?

A:

Q: A petrochemical plant manufactures polyethylene by free radical initiation in a continuous process. ...

A: Polyethylene has other names such as polythene, polyethylene, or polyethylene. In present times, thi...

Q: Point d is a two phase region Vapor b liquid solid gas P.

A: A phase diagram basically tells that what phase is possible or what phase transition has happened wh...

Q: Sulphur dioxide is obtained by the following reaction Cu+2H,SO → CUSO + 2H,0 + SO2 (a) When 50 kg Cu...

A: Given data: Mass of Cu = 50 kg

Q: Two aqueous sulfuric acid solutions containing 20.0 wt% H2SO4 (SG = 1.1398 ) and 80.0 wt% H2SO4 (SG ...

A: Given thatC1  = 20 wt % H2SO4C2  =80 wt % H2SO43.729

Q: Most of the sulfur used in the United States is chemically synthesized from hydrogen sulfide gas rec...

A:

Q: From these choices: pressure, temperature, DENSITY and heat, density is not an intensive property.

A: Given information: Examples of intensive properties.

Q: (Q-1) Estimate the thermal conductivity of C02 gas (k) in the (Btu/hr.ft.F) at (180 F') and (1070 Ps...

A: Given data: Temperature = 180 0F Pressure = 1070 psia  

Q: 1. Calculate the orsat analysis of the products of combustion upon burning pure hexane with 38% exce...

A: Orsat analysis is the measurement of combustion gas composition not considering the water produced f...

Q: Write the answers for the following reactions. 1) OHC Ac0 ? CH2N2 NaOAc reaction in OCH3 gase ous me...

A:

Q: Crude petroleum oil is generally considered to be formed from animal and vegetable debris accumulati...

A: Given elemental composition of crude petroleum in percentages of C,H,N, O and S C burning to CO2=70%...

Q: P (kPa) Isotherm 200 V (m) 550 100 Ten kilograms of air experiences the three-process cycle as shown...

A:

Q: 2. A 230 ml ethyl alcohol was placed in a Pyrex glass and makes it full at 22°C. How much alcohol wi...

A: Given data: Volume of ethyl alcohol at 22 0C = 230 mL Final temperature = 100 0C