G(s) = 10s +100 5² +35 H(s) = 1

Q: Determine the Discrete-time Fourier series representation for the sequence below. Show the details…

A:

Q: A battery, resistor, capacitor and switch are connected in series to form an RC circuit as shown…

A:

Q: Given a stable system 2-½- with H(z) =₂ = 2² + 2/2 - 1/1/20 3 16 Is this system causal? Explain

A:

Q: An op-amp comparator in a firing circuit can produce waveforms at the output of up to 24 V…

A: Given data, Peak-to-peak input voltage is 24V.  Thus, the maximum input voltage Vm is 12V. The fact…

Q: H.W: Two capacitors (C₁= 4µF, C₂= 12μF) are connected in series to each other, then the group was…

A:

Q: Determine whether the following systems have the properties linearity, time invariance, BIBO…

A: As per Bartleby guideline we need to answer the first question only. Kindly repost the rest…

Q: A superheterodyne receiver tunes at the frequency range from 25 MHz to 50 MHz. The intermediate…

A:

Q: A sine wave of voltage varies from zero to a maximum of 400V. Voltage is ___ V at the instant of 30…

A: In this question we need to find voltage at the instant of 30 deg of the cycle.

Q: The pulse train shown below represent average Va Hage appearing a resistance load at (R=16²) Sind.…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: 3. Determine current I using superposition theorem. 8A (1 1822 M 100 M Ď 250 + 100v

A:

Q: etermine the value of R. to ensure that the zener diode is conducting. Let Vz=3.5V @ Izr=10mA. Let…

A:

Q: find the complex Fourier expansion of the periodic function shown below 0<x<1 1<x<2 f(x) = {1 Σ(an…

A:

Q: Explain diagram

A: The given diagram is shown below. It is asked to explain the diagram.

Q: GIVEN THE R1 R2 = 2.51 OHMS XF1 = XF2 = 0.83J OHMS GC = 3251 OHMS AND JBM = 1240J OHMS V1 = 220V V2…

A:

Q: 4. Find the per unit value for each component and draw the impedance diagram. Y Generator 10 kV 100…

A:

Q: 1----The dual of the following logical expression x'y+xy' is....

A: In dual expression, • and + are interchanged and also , 0 and 1 are interchanged.

Q: 4. Find the per unit value for each component and draw the impedance diagram. Y Generator 10 kV 100…

A:

Q: A) Compute and plot the convolution y(t) = x(t) * h(t), where: 0 ≤t≤1 x(t) = = 2-t, 1<t≤2 = (0,…

A:

Q: To sketch the characteristic curve of the diode you need to vary voltages on diode and measure…

A: The diode will conduct only during the forward bias and it will not conduct during reverse bias. The…

Q: A 60 Watt light bulb is equivalent to 60 J/s. If the light bulb is on for a minute then we have 60…

A:

Q: Find the detector current id in the unbalanced Whetstone bridge shown in the figure below. You may…

A: Given, The circuit diagram,

Q: Determine ix, assuming ideal op Amp. 4K >№ 2kw Ⓒ4V КЛ Lx 2X42

A:

Q: Use Super position theorem to find the current flowing agh Resistance (Re) and also voltage across…

A:

Q: [u]h Z 0.85

A: We need to find out the transfer function for given block diagram .

Q: Using mesh analysis, determine the values of Vo, and io of the circuit from the Figure. Note: • use…

A: In this question,  We need to determine the voltage Vo   and current Io  using mesh analysis.  We…

Q: Assuming the capacitors in Figure 12-2 are non-polarized electrolytic capacitors, what is the…

A: Given: Three capacitors of different rating connected in parallel. Circuit:

Q: 4-The following sequence represent one period of a sinusoidal sequence of x[n] = Acos(w。n + p).…

A:

Q: ideal ammeter (Give your answer in mA.)

A:

Q: What is the Norton's resistance

A:

Q: Generate and plot each of the following sequences over the indicated interval a) x(n) = 2*delta(n+2)…

A:

Q: 1. Determine v using superposition theorem.

A: It is given that:

Q: Compute and plot the convolution y[n] = x[n] * h[n], where: -n (²) u[ − n − 1] x[n] = h[n] = u[n −…

A:

Q: If a 3-Ø, Y-connected system has a line-to-line voltage of 1018Sin(346t) V, then the frequency of…

A: Given: 3-ϕ Y-connected Line to line voltage, VL=1018sin346t Volt.........(1)

Q: 3. Find the Thevenin's and Norton's equivalent circuits. 62 4A (↑) 222 + lov T €32

A:

Q: The circuit in the image given below is a differential amplifier driven by a bridge. Find vo. Given…

A: In this question,  We need to determine the output voltage Vo .  We are solving this problem using…

Q: (i) A 420 V, 60 Hz, star connected, the four-pole synchronous generator has a synchronous reactance…

A: When the generator is turned, the magnetic field created by the stator poles induces a voltage in…

Q: 0 10 How many roots of the corresponding polynomial are in the Right Half s-Plane? (a) 0 (b) 1 (c) 2…

A:

Q: Given two frequencies, 10 Hz and 320 Hz, calculate the number of octaves between them.

A:

Q: 1) Figure below shown the schematic diagram of 3-phase radial transmission system. The ratings and…

A:

Q: lume-l - minal v k are in t is rec 4 V₂ 15] Z² 5.32 In the network as shown, with Is1 = 5 A, IS2 =…

A:

Q: x [n] = cou[ + n) + √²₁ ( # ") sin

A: We need to find out exponential Fourier series coefficient of given sequence .

Q: The figure shows an instrumentation amplifier driven by a bridge. Obtain the gain vdviof the…

A:

Q: For the circuit given below, determine the value of R which will draw the maximum power and compute…

A: The maximum power will be delivered to the load if the thevenin's equivalent resistance is equal to…

Q: The circuit shown below is in a fixed bias common emitter configuration. This does not have any…

A:

Q: The activation function in the example is assumed to be linear as f(x) = x. Repeat the example and…

A: We have to drawn update code functionthe given Activation Code function

Q: Calculate the current through the 50 by Norton's theorem.

A:

Q: The armature of a d.c. The machine has a resistance of 0.25 ohm and is connected to a 300V supply.…

A: Resistance (R) = 0.25 Ω Voltage (V) = 300 V Ia = 100 (When it runs as a generator) Ia = 100 (When it…

Q: .Use Nodal analysis to find current flowing through all the branches in the following Circuit V₁ =…

A: In this question,  We need to determine the current in the each branch using the nodal analysis.  We…

Q: A 400 V of 50 Hz is supplying a three-phase load of 150kW that is located 150 m away from the…

A:

Q: 13. Find circuit current in this schematic. R-30 kQ o E₁-10 V XL = 40 kn Q

A: Given, The supply voltage, ES=10 V The value of resistor, R=30 KΩ The value of inductive reactance,…

Filter

A filter is a device or process which removes some of the unwanted features or components like frequencies from a signal in signal processing. The feature of filters is the complete or partial suppression of some part of the signal, and filtering is a class of signal processing. This most often means removing some frequency bands or some frequencies. In the frequency domain, the filters do not exclusively act, especially in the image processing field many other targets for filtering exist. Without having to act in the frequency domain, the correlations can be removed for certain frequency components and not for others. The filters are widely used in electronics and telecommunication, in television, radio, radar, audio recording, music synthesis, control systems, computer graphics, and image processing.