Enzymes facilitate reactions in living systems. The figure below presents an energy diagram for the reaction X®Y. The solid line in the energy diagram represents changes in energy as the reactant is converted to product under standard conditions. The dashed line shows changes observed when the same reaction takes place in the presence of a dedicated enzyme. Choose the sentence that best describes this graph. b а X reaction pathway O a DG° = 0 O b. DG° = 1 Oc. DG° = -1 Od. DG° = -5 free energy →

Enzymes facilitate reactions in living systems. The figure below presents an energy diagram for the reaction X®Y. The solid line in the energy diagram represents changes in energy as the reactant is converted to product under standard conditions. The dashed line shows changes observed when the same reaction takes place in the presence of a dedicated enzyme. Choose the sentence that best describes this graph. b а X reaction pathway O a DG° = 0 O b. DG° = 1 Oc. DG° = -1 Od. DG° = -5 free energy →

Chemistry: An Atoms First Approach

2nd Edition

ISBN:9781305079243

Author:Steven S. Zumdahl, Susan A. Zumdahl

Publisher:Steven S. Zumdahl, Susan A. Zumdahl

Chapter11: Chemical Kinetics

Section: Chapter Questions

Problem 75E: One mechanism for the destruction of ozone in the upper atmosphere is a. Which species is a...

See similar textbooks

Similar questions

For the following reaction C(s)+2H2(g)CH4(g) K=0.26 at 1000C (3 significant figures). What is the equilibrium constant at 750C (3 significant figures)?
In Chapter 3, we discussed the conversion of biomass into biofuels. One important area of research associated with biofuels is the identification and development of suitable catalysts to increase the rate at which fuels can be produced. Do a web search to find an article describing biofuel catalysts. Then, write one or two sentences describing the reactions being catalyzed, and identify the catalyst as homogeneous or heterogeneous.
Monochloroethane (C2H5Cl) can be produced by the direct reaction of ethane gas (C2H6) with chlorine gas or by the reaction of ethylene gas (C2H4) with hydrogen chloride gas. The second reaction gives almost a 100% yield of pure C2H5Cl at a rapid rate without catalysis. The first method requires light as an energy source or the reaction would not occur. Yet G for the first reaction is considerably more negative than G for the second reaction. Explain how this can be so.
Consider the following reaction: CH3X+YCH3Y+X At 25C, the following two experiments were run, yielding the following data: Experiment 1: [Y]0 = 3.0 M [CH3X] (mol/L) Time(h) 7.08 103 1.0 4.52 103 1.5 2.23 103 2.3 4.76 104 4.0 8.44 l05 5.7 2.75 l05 7.0 Experiment 2: [Y]0 = 4.5 M [CH3X] (mol/L) Time(h) 4.50 103 0 1.70 103 1.0 4.19 104 2.5 1.11 104 4.0 2.81 l05 5.5 Experiments also were run at 85C. The value of the rate constant at 85C was found to be 7.88 108 (with the time in units of hours), where [CH3X]0 = 1.0 102 M and [Y]0 = 3.0 M. a. Determine the rate law and the value of k for this reaction at 25C. b. Determine the half-life at 85C. c. Determine Ea for the reaction. d. Given that the C8X bond energy is known to be about 325 kJ/mol, suggest a mechanism that explains the results in parts a and c.
One mechanism for the destruction of ozone in the upper atmosphere is a. Which species is a catalyst? b. Which species is an intermediate? c. Ea for the uncatalyzed reaction O3(g)+O(g)2O2(g) is 14.0 kJ. Ea. for the same reaction when catalyzed is 11.9 kJ. What is the ratio of the rate constant for the catalyzed reaction to that for the uncatalyzed reaction at 25C? Assume that the frequency factor A is the same for each reaction.
Substances that poison a catalyst pose a major concern for many engineering designs, including those for catalytic converters. One design option is to add materials that react with potential poisons before they reach the catalyst. Among the commonly encountered catalyst poisons are silicon and phosphorus, which typically form phosphate or silicate ions in the oxidizing environment of an engine. Group 2 elements are added to the catalyst to react with these contaminants before they reach the working portion of the catalytic converter. If estimates show that a catalytic converter will be exposed to 625 g of silicon during its lifetime, what mass of beryllium would need to be included in the design?
Can a reaction mechanism ever be proven correct? Can it be proven incorrect?
For the following two reactions H+Cl2HCl+Cl H+Br2HBr+Br the first reaction has a lower value of A than the second reaction. What can one say about the relative properties of the intermediates HCl2 and HBr2, just from the relative values of A?
Define stability from both a kinetic and thermodynamic perspective. Give examples to show the differences in these concepts.
The reaction NO(g) + O,(g) — NO,(g) + 0(g) plays a role in the formation of nitrogen dioxide in automobile engines. Suppose that a series of experiments measured the rate of this reaction at 500 K and produced the following data; [NO] (mol L ’) [OJ (mol L 1) Rate = -A[NO]/Af (mol L_1 s-1) 0.002 0.005 8.0 X 10"'7 0.002 0.010 1.6 X 10-'6 0.006 0.005 2.4 X IO-'6 Derive a rate law for the reaction and determine the value of the rate constant.
The rate of a certain reaction doubles for every 10 C rise in temperature. (a) How much faster does the reaction proceed at 45 C than at 25 C? (b) How much faster does the reaction proceed at 95 C than at 25 C?
Compare the functions of homogeneous and heterogeneous catalysts.