eter could utilize the Hall effect by applying a magnetic field across a metal pipe and measuring the Hall voltage produced. what is the average fluid speed in a 3.00-cm diameter pipe, if a 0.528-T field across it creates a 56.0-mV Hall voltage?

eter could utilize the Hall effect by applying a magnetic field across a metal pipe and measuring the Hall voltage produced. what is the average fluid speed in a 3.00-cm diameter pipe, if a 0.528-T field across it creates a 56.0-mV Hall voltage?

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter22: Magnetism

Section: Chapter Questions

Problem 25PE: A nonmechanical water meter could utilize the Hall effect by applying a magnetic field across a...

See similar textbooks

Similar questions

A nonmechanical water meter could utilize the Hall effect by applying a magnetic field across a metal pipe and measuring the Hall voltage produced. What is the average fluid velocity (in m/s) in a 3.00 cm diameter pipe, if a 0.480 T field across it creates a 64.0 mV Hall voltage? ______ m/s
To construct a nonmechanical water meter, a 0.500-T magnetic field is placed across the supply water pipe to a home and the Hall voltage is recorded. (a) Find the flow rate in liters per second through a 3.00-cm-diameter pipe if the Hall voltage is 60.0 mV. (b) What would the Hall voltage be for the same flow rate through a 10.0-cm-diameter pipe with the same field applied?
A large water main is 2.50 m in diameter and the average water velocity is 6.00 m/s. Find the Hall voltage produced if the pipe runs perpendicular to the Earth’s 5.00 x 10-5 T field.
Two 1.20 m non-conductive wires meet at a right angle. One segment has +10.0 µC of load evenly distributed along the length, and the other has -10.0 µC of load evenly distributed along the length as shown in the figure. Determine the modulus of the electric field in kN / C produced by these two wires at point P, which is 60.0 cm from each wire.
A student is watching a TV that is receiving a signal though an in house dipole aerial. As the student stands up and walks towards the TV he can observe that the signal gradually degrades and then recovers again. The students walks back and forth to discover that the distance between the points where the best and the worst signals are observed is 0.9 m. Calculate the frequency of the signal TV is receiving given that the velocity of the wave is 3 × 105 km/s. Give your answer in mega-Hz (MHZ).
Explain why the singing of the plates stop after a certain period of time using the concept of Lenz Law and Eddy Current.
You've recently read about a chemical laser that generates a 20.0-cm-diameter, 30.0 MW laser beam. One day, after physics class, you start to wonder if you could use the radiation pressure from this laser beam to launch small payloads into orbit. To see if this might be feasible, you do a quick calculation of the acceleration of a 20.0-cm-diameter, 104 kg, perfectly absorbing block. What speed would such a block have if pushed horizontally 95.0 m along a frictionless track by such a laser? Express your answer with the appropriate units.
CASE STUDY In Example 34.6 (page 1111), we imagined equipping 1950DA, an asteroid on a collision course with the Earth, with a solar sail in hopes of ejecting it from the solar system. We found that the enormous size required for the solar sail makes the plan impossible at this time. Of course, there is no need to eject such an object from the solar system: we only need to change the orbit. A much more pressing problem is Apophis, a 300-m asteroid that may be on a collision course with the Earth and is due to come by on April 13, 2029. It is unlikely to hit the Earth on that pass, but it will return again in 2036. If Apophis passes through a 600-m keyhole on its 2029 pass, it is expected to hit the Earth in 2036. causing great damage. There are plans to deflect Apophis when it comes by in 2029. For example, we could hit it with a 10- to 150-kg impactor accelerated by a solar sail. The impactor is launched from the Earth to start orbiting the Sun in the same direction as the Earth and Apophis. The idea is to use a solar sail to accelerate the impactor so that it reverses direction and collides head-on with Apophis at 8090 km/s and thereby keeps Apophis out of the keyhole. Consider the momentum in the impactors orbit (Fig. P34.75) when the solar sail makes an angle of = 60 with the tangent to its orbit. Current solar sails may be about 40 m on a side, but the hope is to construct some that are about 160 m on a side. Estimate the impactors tangential acceleration when it is about 1 AU from the Sun. Keep in mind that the sail is neither a perfect absorber nor a perfect reflector, and a heavier impactor would presumably be equipped with a larger sail. Dont be surprised by what may seem like a very small acceleration. FIGURE P34.75
A nonconducting hard rubber circular disk of radius R is painted with a uniform surface charge density tr. It is rotated about its axis with angular speed . (a) Find the magnetic field produced at a point on the axis a distance h meters from the center of the disk, (b) Find the numerical value of magnitude of the magnetic field when =1C/m2 , R = 20 cm, h = 2 cm, and magnetic field of Earth, which is about 1/2 Gauss. =400rad/sec , and compare it with the magnitude of
Check Your Understanding Could a purely electric field propagate as a wave through a vacuum without a magnetic field? Justify your answer.
A nonmechanical water meter could utilize the Hall effect by applying a magnetic field across a metal pipe and measuring the Hall voltage produced. What is the average fluid velocity in a 3.00-cm-diameter pipe, if a 0.500-T field across it creates a 60.0-mV Hall voltage?
An AM radio transmitter broadcasts 50.0 kW of power uniformly in all directions. (a) Assuming all of the radio waves that strike the ground are completely absorbed, and that there is no absorption by the atmosphere or other objects, what Is the intensity 30.0 km away? (Hint: Half the power will be spread over the area of a hemisphere.) (b) What is the maximum electric field strength at this distance?