Answered: Explain one of the reasons why pregnant…

Science

Physics

Explain one of the reasons why pregnant women often suffer from back strain late in their pregnancy.

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter9: Statics And Torque

Section: Chapter Questions

Problem 19CQ: Explain one of the reasons why pregnant women often suffer from back strain late in their pregnancy.

See similar textbooks

Related questions

Q: A 75-kg man stands on his toes by exerting an upward force through the Achilles tendon, as shown.…

A: According to the first condition of equilibrium, net force on system is zero and also with the…

Q: Determine the force P with which Dr. Ellestad has to push to tip over the 73 lb mini refrigerator.…

Q: If the maximum force the biceps muscle can exert is 1000 N, can we pick up an object that weighs…

A: To pick up an object, the bicep must exert a torque which is given as, τ=r⊥×F

Q: The center of gravity of a 50g meter stick is at 51 cm and the stick is supported at 70 cm. Where…

A: Given data: Mass of meter stick (m) = 50 g = 0.050 kg Mass of object (mb) = 80 g = 0.080 kg…

Q: Explain why the forces in our joints are several times larger than the forces we exert on the…

A: Limbs are third class levers, with the mechanical advantage less than one. The applied force…

Q: The upper leg muscle (quadriceps) exerts a force of 1200 N, which is carried by a tendon over the…

A: Using the free body diagram, the net forces acting along the horizontal and the vertical direction…

Q: (6) Explain why forces in muscles and joints are largest when their load is a long distance from the…

A: Explain why forces in muscle is largest when the load is long distance.

Q: A pair of forces when applied to a body decreases its length and increases its cross-sectional area…

A: 1. When two forces act on an object, the total force of the object either decreases or increases…

Q: 7. The horizontal stick of length, L, shown in the figure is uniform and weighs 200 N. Calculate the…

Q: To pull with a force F=172 N on the scale as shown, what should the tension in your biceps muscle…

A: The free-body diagram of the system is shown below.

Q: Achilles tendon- - Tibia Ankle joint K4.6*-12.5 ст ст

A: Given,Mass of the person, m = 75 kghis tendon is, 25 cm = 0.25 m longcross sectional area, A = 78…

Q: A typical jar that has been tightened to a reasonable degree requires 2.0 N⋅mN⋅m to open. f you grab…

Q: Suppose the humerus is reduced uniformly in size by a factor of two. This means that both the length…

A: Here, the amount of the stretch is inferred as the amount of the stress developed in the humerus for…

Q: Tensile and compressive forces are called as they act at right angles to the cross-section of the…

A: Direct forces are the force which act at right angles to the cross-section of the body, and force…

Q: The heels on a pair of women's shoes have a radius of .5cm at the bottom. If 30% of the weight of a…

Q: Problem 2: The upper leg muscle (quadriceps) exerts a force of FQ = 1100 N, which is ied by a tendon…

A: Given data as per question force FQ = 1100N

Q: The upper leg muscle (quadriceps) exerts a force of 1250 N, which is carried by a tendon over the…

A: considering the first condition of equilibrium,

Q: Why are the forces exerted on the outside world by the limbs of our bodies usually much smaller than…

Q: 7) Let P= 20 kN. What is the tension in the cable? (Hint: If you want to know the internal force you…

A: in this question we drew FBD and get equilibrium equation at different point.

Q: Even when the head is held erect, as in the figure below, its center of mass is not directly over…

A: Given that:W=48Nr1=4.8 cm=0.048 mr2=2.9 cm=0.029 m

Q: Unlike most of the other muscles in our bodies, the masseter muscle in the jaw, as illustrated in as…

Q: Q5/ A man stands out at the end of the diving board, which is supported by two springs A and B, each…

A: Given: mass of man m =40 kg distance between two spring = 1m distance between spring B and man = 3…

Q: 5. A spider builds its web in a window frame that is lying on the ground. It is supported by four…

Q: What is the lever arm of bicep's tension? 4cm 17.5cm 35cm How much force is supported by the bicep's…

A: The lever arm on the bicep tension is the distance from point of rotation. And the force applied by…

Q: The upper leg muscle (quadriceps) exerts a force of FQ = 1080 N, which is carried by a tendon over…

A: Given data: FQ=1080N

Q: 4. Determine the mas that must be supported at A, and the angle ø of the connecting cable in order…

Q: Q.5) Two weights C = 2000 N and D = 1000 N are located on a horizontal beam AB as shown in 4 m…

A: Given : Weight of C = 2000 N Weight of D = 1000 N If considering reaction at A as RA and reaction at…

Q: 7. The system as shown is in equilibrium. Determine the force exerted by cable АВ. 45° B 30° hoo lb

A: As weight of 100 lb i.e. 45.36 kg hangs down, there must be some tension experienced by both AB and…

Q: Is the body ever in equilibrium?

A: Body is never in equilibrium. Equilibrium is the state of balance. When a body or a system is in…

Q: Dynamic climbing ropes are designed to be quite pliant, allowing a falling climber to slow down over…

A: The Young's Modulus is given by Y=StressStrain=FAStrain

Q: FD For the glenohumeral joint shown above, there are two muscle force: F, (deltoid) and Fs…

A: Given:- FD=400 N at the angle of 10 ° with the vertical Fs=200 N at the angle of 25° with the…

Q: A cook holds a 2.33-kg carton of milk at arm's length (see the figure below). What force FB must be…

A: The expression for the force exerted by the biceps muscle is,…

Q: A person supports himself on the ball of one foot. The normal force N=724 N pushes up on the ball of…

Q: Both parts please

A: The free body diagram of the system is given as

Q: A guitar string is fixed at both ends. If you tighten it to increase its tension

Q: As you increase the force that you apply while pulling on arope, which of the following is NOT…

A: The relation for the stress is, σ=FA When the force is increased, the stress on the rope increases.…

Q: ss, having studied physics, he attaches one end of a stout rope to the vehide and the other end to…

Q: Each bone in the chain of bones forming your spine is separated from its neighbors by disks of…

Q: 5. IThe arm in figure below weighs 39.3 N. The force of gravity acting on the arm acts through point…

Q: In the force table, these have the same magnitude but directly opposite in direction.…

A: An equilibrant force is a force which brings a body into mechanical equilibrium.

Q: Calculate the force the biceps muscle must exert to hold the forearm and its load as shown in…

A: The toque due to weights are clockwise relative to the pivot, while the torque created by the biceps…

Q: Question 1-a, Numerical: The next figure shows an 80.0 kg cat burglar at static equilibrium. Assume…

Q: To pull with a force F=160 N on the scale as shown, what should the tension in your biceps muscle…

Q: Tensile force tends to cut the body in two. (true or false?)

A: If equal and opposite forces are applied to a body they tend to elongate it, such type of force is…

Q: 1. A 10 000-N shark is supported by a cable attached to a 4.00-m rod that can pivot at the base. 2.…

Q: Suppose you are standing on the floor doing your daily exercises. For one exercise, you lift your…

A: The force excerted by the deltoid muscle, F 210 at an angle of (theta)o above the horizontal on the…

Concept explainers

Torque

Torque is the rotational equivalent of linear force in physics and mechanics. Based on the course of study, it is also known as the moment of force, rotational force, or turning effect.

Question

Explain one of the reasons why pregnant women often suffer from back strain late in their pregnancy.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Explain why pregnant women often suffer from back strain late in their pregnancy.
Unlike most of the other muscles in our bodies, the masseter muscle in the jaw, as illustrated in Figure 9.44, is attached relatively far from the joint, enabling large forces to be exerted by the back teeth. (a) Using the information in the figure, calculate the force exerted by the lower teeth on the bullet. (b) Calculate the force on the joint.
Explain why the forces in our joints are several times larger than the forces we on the outside with our limbs. Can these fortes be even greater than muscle forces?
Why are the forces exerted on the outside world by the limbs of our bodies usually much smaller than the forces exerted by muscles inside the body?
Two muscles in the back of the leg pull on the Achilles tendon as shown in Figure 9.37. What total force do they exert? Figure 9.37 The Achilles tendon of the posterior leg serves to attach plantaris, gastrocnemius, and soleus muscles to calcaneus bone.
If the maximum force the biceps muscle can exert is 1000 N, can we pick up an object that weighs 1000 N? Explain your answer.
Swimmers and athletes during competition need to go through certain postures at the beginning of the race. Consider the balance of the person and why start-offs are so important for races.
An old carpenter's trick to keep nails from bending when they are pounded into hard materials is to grip the center of the nail firmly with pliers, Why does this help?
Explain why the forces in our joints are several times larger than the forces we exert on the outside world with our limbs. Can these forces be even greater than muscle forces (see previous Question)?
We analyzed the biceps muscle example with the angle between forearm and upper arm set at 90°. Using the same numbers as in Example 9.4, find the force exerted by the biceps muscle when the angle is 120° and the forearm is in a downward position.
A father lifts his child as shown in Figure 9.43. What force should the upper leg muscle exert to lift the child at a constant speed?
As an oil well is drilled, each new section of drill pipe supports its own weight and that of the pipe and drill bit beneath it. Calculate the stretch in a new 6.00 m length of steel pipe that supports 3.00 km of pipe having a mass of 20.0 kg/m and a 100-kg drill bit. The pipe is equivalent in stiffness to a solid cylinder 5.00 cm in diameter.