Problem 3.Find:1. Z, which maximizes average1H12cos5E(ACAJpower transfer to the load.Maximum average power2.transferred to the load6 cos (5t +7))

Both sources have the same frequency of ω=5 rad/s. Converting the circuit parameters into phasor…

Answered: Find: 1. Z, which maximizes average 1H…

Find: 1. Z, which maximizes average 1H 12cos5E(F (AJ power transfer to the load. Maximum average power 2n 2. transferred to the load 6 cos(5t +)[]

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.22P: The real power delivered by a source to two impedances, Z1=4+j5 and Z2=10 connected in parallel, is...

See similar textbooks

Related questions

Q: FN.Q3 – In the RLC circuit, vs(t) = 330.Sin(628t) Volt, R = 470 , C = 220µF and L = 65 mH. Determine…

A: RLC series circuit, If the voltage Vs is given, Find the RMS value of the source voltage power…

Q: O At the value of K where the system is marginally stable, what are the pole locations? 15j, -6 15j,…

Q: R1 1000 V1 L1 100mH 12Vpk 1kHz 0° Find the inductor's reactance XL, impedance Z, the circuit's…

Q: A 270-V rms 80-Hz supply serves a load that is 12 kW, 17 KVAR (capacitive), and 25 KVAR (inductive).…

Q: For the circuit shown below, the average power delivered to the -j5 ohms capacitor is.VAR 10 Ω -j5 Q…

A: Given

Q: Question: (a) Find the input impedance. Zin. of the circuit shown below by using the concept of…

A: The solution can be achieved as follows.

Q: What is the equation of the current in B in the function of sin given that Two electric devices A…

Q: A sinusoidal alternating current of 5 amps is flowing through a resistance of 450. Calculate the…

Q: 15 Q 10 j ng () 10Z10° Awgk/rms

Q: An ac generator provides emf to a resistive load in a remote factory over a two-cable transmission…

A: (a) Note- There is silly mistake in the (a) part of the Question, Question should be what is the…

Q: Q14: Choose the correct answer: i. In order to maintain the frequency of the power system at its…

A: The solution is given below

Q: - An electrical motor is modelled as 5117j ohm. Then a 300pF capacior is conneeted în parallel. If…

Q: A coil, with 100 mH of inductance and 10 Q of resistance, has been connected to an AC power supply…

Q: An AC voltage source of 100V and 50HZ is supplying a coil that has an inductance of 180 mH in series…

Q: A load connected to a 120 Vrm source is drawing 1,600 VA at 0.6 power factor lag. a) What is the…

Q: A SERIES RC CIRCUIT TAKES A CURRENT WHOSE EQUATION Is 2 sin (754t+40) AMPERE. WHEN CONNECTED TO A…

Q: . A coil is to be wound with Q-factor of 8. A lamp rated 120 V, 480 W is connected in series with…

A: First calculate resistance of the bulb and using voltage division rule find the voltage across lamp…

Q: + V1 10Vrms J50Hz 0° V1 = 10 /0° R1 100 Ω L1 160mH C1 :320μF

Q: An AC voltage source of 100V and 50HZ is supplying a coil that has an inductance of 100 mH in series…

A: Due to guidelines we can solve one complete question at a time if you want another question 's…

Q: The maximum values of the alternating voltage and current are 400 V and 20 A respectively in a…

Q: For the circuit shown below, detemine the voltage of the -j10 2 capacitive reactance.

A: The circuit is as shown below :

Q: 1.For one AC Wheatstone bridge at balance, given that ZA= 100 2, ZB=200 2, Zc-150 Q Zp is a ceil…

Q: Power factor 90 to 100% 88 to <90% 85 to <88% 80 to <85% 75 to < 80% 70 to < 75% 65 to < 70% 60 to <…

A: In this question we need to find effective impedance , average current and surcharge of the given…

Q: Exercise#2: We have a load with an impedance given by Z = 30+j 40 Q. The voltage across this load is…

Q: Consider the network depicted in the following figure, and determine the equivalent impedance seen…

Q: Circuit Diagram V1 C1 220 Vrms 10uF 60 Hz 0° Computed Values Compute the expected power factor of…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Draw the power triangle associated with the source, 300230° Vrms. illustrate the apparent, active,…

A: We need to draw the power triangle and calculate the power factor for the given circuit.

Q: Derive the voltage waveform as v(z, 1) = |V cos(@t - B: +6+)e a: + |Vcos(@t + B: +0)ez 2.9 Where We…

Q: ure inductance of L = 144 mH 118 V, 50 Hz supply. The cure ctor is given by

Q: The voltage across a load is v(t) = 60 cos(wt – 10°) V and the current through the element in the…

A: (a) The complex/total/apparent power is given by the expression as shown below: S=VR.M.SI*R.M.S…

Q: , reactive and apparent power consumed by the lo

A: The given load is an RL load that means the power factor of the load is lagging in nature means the…

Q: For the circuit shown, what is the average power, Pay, delivered by the voltage source? (Assume the…

Q: Suppose that the current, i, through a resistor is described by the function i(t) = (60 – t)? + (60…

Q: (a) If the time domain expression for the source is i, = 0.04 cos(1250t) amps, find the phasor…

A: In this question we will find phasor expression of Io and equivalent impedance seen by the source...

Q: A 240-Vrms 50-Hz supply serves a load that is 10 kW (resistive), 15 kVAR apacitive), and 22 KVAR…

A: In this question we will find power , current etc... Note:. As per our guidelines, I am supposed to…

Q: Q.23: For the following electric circuit, find Z and Y (1200+j850)2 (1500+j900)2 parameters? Also,…

Q: HW # 7.1 Vp = 50 sin(@t), R1 = 1kN , If the firing angle is 30°, draw %3D Vp=Vm sinot R Vo the…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts…

Q: 5. (Post Test 2 material) For the following circuit with v, (t) = 10 cos (1000t + 5°), determine %3D…

A: Active Power(P): The power which is deployed and absorbed by the electric circuit to do some useful…

Q: A coil, with 100 mH Of Inductanče and resistance, has been CO UP 01 Da ower supply Vs(t)= 200…

Q: R1 1000 V1 L1 12Vpk 1kHz 0° 100MH Find the inductor's reactance XL, impedance Z, the circuit's…

Q: Draw the triangle power the associated with source, Clearly VB = 300Z30° Vrms. illustrate the…

A: According to the question we have to find value of power factor and state wether it is lagging or…

Q: Derive the relationship for maximum power Eb = v/2

A: Motor- The motor is an electric machine energy conversion device that converts given mechanical…

Q: The voltage across it v (t) = 10 . The equivalent of a circuit with cos (2000 . t + 30°) V If the…

Q: A coil, with 100 mH of inductance and 10 Q of resistance, has been connected to an C power supply…

Q: 11.48 Determine the complex power for the following cases: (a) P = 269 W, Q = 150 VAR (capacitive)…

Q: 6. A single-phase AC/AC voltage controller is shown in Fig. 10, inductive load, R=6n, x, = 82,…

A: Figure shows two thyristor connected with a resistance and inductor having its own value. Delay…

Q: 4. For the circuit shown in Fig. Q4: (i) (ii) € (vi) compute the value of C in ohm. compute the…

A: Since you have posted the questions with multiple subpart so we are supposed to answer 3 subpart.

Q: Determine the size of capacitor in uf necessary to increase the power factor to 0.90 if the load has…

A: (a) Given data, SL=200 KVA, VL=480 V, cosϕ1=0.70, Rline=0.03 Ω, f = 60 Hz Active power is given by,…

Q: 4Ω. 3Ω

A: Given

Question

Problem 3.
Find:
1. Z, which maximizes average
1H
12cos5E(A
CAJ
power transfer to the load.
Maximum average power
2.
transferred to the load
6 cos (5t +7))

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2: Solution (1)

VIEW

Step 3: Solution (2)

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A source whose voltage is ? (?) = 50√2 cos (?? + 30 °) ? supplies a load of impedance ? = (4 + ?3) Ω. We want to know: a) the active, reactive and apparent power consumed by the load. b) the power of a capacitor that must be installed in parallel with the load to raise its power factor to 0.97 delayed.
The 9 Ω resistor in the circuit is replaced with a variable impedance Zo. Assume Zo is adjusted for maximum average power transfer to Zo. 1. a) What is the maximum average power that can be delivered toZo?2. b) What is the average power developed by the ideal voltage sourcewhen maximum average power is delivered to Zo?3. c) Choose single components from Appendix H to form animpedance that dissipates average power closest to the value in part(a). Assume the source frequency is 60 Hz.
For the frequency-domain circuit , calculate: 1. a) the rms magnitude of Vo;2. b) the average power dissipated in the 9 Ω resistor;3. c) the percentage of the average power generated by the idealvoltage source that is delivered to the 9 Ω load resistor.
Exercise 11) Transform the circuit in phasor domain representation2) Determine the value of total impedance, ZT3) Determine the value of total current, IT4) Determine the value of voltage across resistor and capacitor5) Convert in rms values.
A circuit branch is found to have an equivalent impedance of Z=120−j45Ω. It is given that this impedance is a series combination of a 120Ω resistor and another passive component. If the circuit has a sinusoidal voltage source whose frequency is 120 Hz. What is the value of the component in series with the 120Ω resistor? (Note: Express the value assuming a metric scaling of μ(10-6). Provide your answer in decimal form, up to 3 decimal places.)
The device is represented in the frequency domain bya Norton equivalent. When a resistor having an impedance of 5 kΩ isconnected across the device, the value of V0 is (5–j15) V. When acapacitor having an impedance of −j3 kΩ is connected across the device,the value of I0 is (4.5–j6) mA. Find the Norton current IN and theNorton impedance ZN
Suppose the circuit shown represents a residential distribution circuit in which the impedances of the service conductors are negligible and Vg1=Vg2=120 0° V (rms). The three loads in the circuit are L1 (a new refrigerator, a coffee maker, and a microwave oven); L2 (2 incandescent lamps, a humidifier, and a ceiling fan); and L3 (a clothes washer and a clothes dryer). Assume that all of these appliances are in operation at the same time. The service conductors are protected with 20 A circuit breakers. Will the service to this residence beinterrupted? Why or why not?
Evaluate the following twiddle factor: W48
A load impedance, Zo = 10 + j 3 ohm, is connected to a source with line resistance equal to 3 ohm, as shown in the figure. Determine the average powers delivered to the load and absorbed by the line. The average powers delivered to the load and absorbed by the line are ________ and ____________ , respectively.
five infinite-impedance volunteers,calibrated to read rms values,are connected as shown below. let R= 200, L=0.400H,C=6.0 Mf, and V=30.0 v. what's the reading of the voltmeter's V1,V2,V3,V4 and V5 if W= 200 rad/s
Consider an ac network with an ideal transformer (with turns ratio of n:1) shown below where ZL=(1+j0) is the load impedance and Zs=(7−j24). Ideal transformer turns ratio n is chosen so that the average power delivered to the load is maximized. Under this scenario, the average power delivered to the load is given by
If the values of real power and reactive power is specified for a bus, then it is called as PQ bus. Select one: True False