Answered: Find the number of moles of water that…

Find the number of moles of water that can be formed if you have 194 mol of hydrogen gas and 92 mol of oxygen gas. Express your answer with the appropriate units.

Introductory Chemistry: An Active Learning Approach

6th Edition

ISBN:9781305079250

Author:Mark S. Cracolice, Ed Peters

Publisher:Mark S. Cracolice, Ed Peters

Chapter7: Chemical Formula Relationships

Section: Chapter Questions

Problem 14E: Give the name and value of the number associated with the mole.

See similar textbooks

Related questions

Q: A. Predict the pressure of nitrogen gas at T =-98 K and v=0.00375 m³/kg on the basis of (a) the van…

Q: (nm) 1. Draw a picture of a wave with a wavelength of 200nm on the measure below. Be sure to take…

Q: Question 3 Consider the following reaction at equilibrium. What will happen if FeS2 is added to the…

A: Equilibrium is established when rate of forward reaction becomes equal to the rate of backward…

Q: Which of the following is a true/correct statement? a. Bromide ion's activity coefficient is…

A: If the ionic (I) strength of a solution increases, the activity coefficient (γ) of an ion decreases…

Q: You have 17.14 lb of CO2 in a 47.26 ft3 fire extinguisher tank at 50degC. Assuming that the ideal…

Q: Using the Nernst Equation, determine if the reaction in question 10 is spontaneous at 20 °C with…

A: For a reaction to be spontaneous, the value of cell potential (Ecell) should be negative. And the…

Q: Compound A has a partition coefficient (Kp) of 3.5. If you start with a solution of 150 mg of…

A: Mass of compound = 150 mg Kp of compound for ether : water = 3.5 volume of water = 1 mL i.e. 1000 uL…

Q: Consider the following equilibrium process: PC15 (8) = PC13(g) + Cl₂(g) AH° = 92.5 kJ/mol Predict…

A: Given in following question a reaction

Q: What is the molar concentration of CaCl that makes an isotonic solution for RBCs?

A: The tendency of solvent molecules to pass from a higher concentrated solution to a lower…

Q: R(s) = As/(K+s) for positive constants A and K. (b) Show that the reaction rate attains one-half…

A: Given Equation is R(s) = As / (K + s) Now we have to prove that the reaction rate attains one-half…

Q: Running an HPLC assay using a column heated to approximately 60 °C can have what benefits over…

A: As the temperature increases, the viscosity decreases and the column backpressure will decrease The…

Q: Some measurements of the initial rate of a certain reaction are given in the table below. [N₂] [H₂]…

Q: the average shot piece is a cylinder with a diameter of 7.5 mm, a height of 2.0 mm, and a mass of…

A: Given data :

Q: Describe the electron configuration of an atom using principal energy level, sublevels, orbitals,…

A: Here we have to discuss about electronic configuration of an atom using principal energy…

Q: Before you begin a day trip, you inflate the tires on your automobile to a recommended pressure of…

Q: 1. Explain the hydroboration and oxidation reaction by showing an example of 1-Methyl cyclohexene.…

A: Here we are required to draw the mechanism for the hydroboration oxidation reaction of 1 methyl…

Q: When 1-hexyne reacts with excess HBr, what is the main product? Br Br Br

Q: 1. Ammonium Nitrate is an unstable explosive that also happens to be highly soluble in water. It is…

Q: What is the main product of the reaction below? II. III CH3 ОН + CH OH IV. CH3 H₂O H* CH3 OH V. HO ?…

Q: Which of the following cell components are found ONLY in eukaryotes, not in all cells? elect all…

A: We have given four cell components and we have asked which cell components are found only in…

Q: A piece of a newly synthesized material of mass 25.0 g at 80.00°C is placed in a calorimeter…

A: Dear student since you have posted multiple questions we will solve the first question for you if…

Q: What is the density of N2 at 119.8 degF and 714.9 mmHg in pounds per cubic foot? MW: N:14

Q: 6) Balance the chemical equation: _CHO+_0→ C0+__H,O

A: Balanced chemical equation, Balanced chemical equation is the reaction in which number of atoms of…

Q: A diprotic acid (H₂A) has pKa values of 4.20 (pKal) and 8.40 (pKa2). Which of the equalities is true…

A: Given: The pKa1 for H2A = 4.20 The pKa2 for H2A = 8.40 We have to find the predominant species at…

Q: B. Calculate the pressure of vapor at a temperature of 400°C and a density of 20 kg/m^3 using (a)…

A: Given : Temperature = 400oC = 400+ 273 =673k Density = 20kg/m3 Gas constant = 0.5 KJ kg K

Q: Which pKa value best represents the indicated hydrogen? time H 20 15 none of these 25 30

Q: Consider the following equilibrium process at 686°C: CO₂(g) + H₂(g) = CO(g) + H₂O(g) The equilibrium…

Q: In a 0.080 M NH3 solution, what percent of the NH is present as NH?

Q: what are the methods used to reduce the incidence of acid deposition and photochemical smog; e.g.,…

A: Several methods are now adapted to reduce the incidence of acid deposition and photochemical smog…

Q: The K₂ of a weak monoprotic acid is 1.51 x 10-5. What is the pH of a 0.0914 M solution of this acid?…

A: PH is a negative logarithm of [H]+ ion concentration.

Q: The molecule 2,5-dibromohex-3-ene contains three stereogenic sites: a double bond that can be cis-…

A: The structure of 2,5-dibromohex-3-ene along with the stereogenic center is shown below:

Q: Chemistry B Mit-The G 1.0 ng cergage.com/taohjeves from 9781306657871Aide18001440108-ash12 CHIM-WM.…

A: Given -> Mole of N2 = 0.0367 mole Mole of H2 = 0.0540 mole Volume= 1 L Equilibrium…

Q: Questions 4 through 7 refer to the following experiment: 0.500 g of Ca metal is added to 50.0 mL of…

A: The balanced chemical equation is: Ca(s) + 2H+(aq) → Ca2+(aq) + H2(g) Mass of Ca(s) taken = 0.500…

Q: .and Solution are composed of and the solute is solution is saturated when We know that we have a…

A: The blanks in the above paragraph has to be filled.

Q: <Homework #4 Exercise 8.66 MISSED THIS? Watch KCV 8.5, IWE 8.5; Read Section 8.6. You can click on…

Q: Identify the species represented by each curve in the fractional composition diagram of a…

Q: Explain the types of heterogeneous catalysis mechanisms presented by the polyoxometalates?

A: Heterogeneous catalyst: Heterogeneous catalysis refers to a catalytic process when the reactants and…

Q: unit 3 practice problem Dalton Atomic Theory 1 2 3 4 5

Q: Reproduce the space-filling diagram of HCI (above) and label it to distinguish between the covalent…

A: Covalent radius refers to mean distance between nuclei of the bonded atoms of homonuclear molecule.…

Q: What is the most probable identity of the element X wb symbol is shown below?

Q: lease help with measuring the amount I need to create the buffer. You may be asked to create a 10…

A: Phosphoric acid(H3PO4) is a triprotic with pka values of 2.16, 7.20, and 12.32. Since 7.5 is…

Q: Perform Dixon's Q-test for the following data points. Make a conclusion to reject or retain the…

A: Here the questionable value is the highest value, which is 1.9765 (Sample No-6) because it has the…

Q: Airbags are present in all new cars being produced today. When a collision occurs, a sensor sends an…

Q: Calculate the charge of an ion that contains 32 protons, 32 neutrons, and 30 electrons. OA. -2 B. 0…

A: In an atom three fundamental particles are present. Positively charged particle proton and neutral…

Q: Q1: A. 6 kg of steel, specific heat capacity 500 J\Kg K, is heated from 59°F to 212°F C. How much…

A: Mass of steel (m) = 6 kg Specific heat capacity (C) = 500 J Kg-1 K-1 Initial temperature (T1) =…

Q: Use the periodic table to identify the elements with the following electron configurations.…

Q: A. Predict the pressure of nitrogen gas at T =-98 K and v=0.00375 m³/kg on the basis of (a) the van…

Q: D Question 2 Define Le Chatelier's Principle. A) When a chemical system at equilibrium is disturbed,…

A: Answer-2 Le chatalier's principle used in chemical equilibrium.

Q: In Part B of the experiment, we will determine the enthalpy, AH, for the reaction by plotting In (k)…

A: Answer: These are the questions based on fundamental understanding of straight line equation and…

Q: 41. What diene and dienophile should be used to synthesize the compound below? A -CO₂CH3

A: Diels-Alder reaction: The Diels–Alder reaction is a pericyclic reaction (cycloaddition) between a…

Concept explainers

Mole Concept

Mole concept is a method to determine the amount of any substance that consists of some elemental particles using a grouping unit called ‘mole’. The mole concept enables one to handle the large amount of small elementary particles. The mole concept can be used in many calculations related to mole calculation, molar amount, mole ratio, and so on, which are significant in chemistry.

Question

Find the number of moles of water that can be formed if you have 194 mol of hydrogen gas and 92 mol of oxygen gas.
Express your answer with the appropriate units.
► View Available Hint(s)
HA
Value
Submit
Units
www
Hey
?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1 Given data

VIEW

Number of moles of water:

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

Give good hand written explanation of this question ASAP What is the unit of molar mass? What unit is it equivalent to?
Aluminum metal reacts with iron (II) sulfate to produce aluminum sulfate and iron metal. How many formula units of aluminum sulfate can be produced from 367.9g of iron (II) sulfate? put the entire number from your calculator in and e+(exponent). (For instance, 4.5x10^25 would be 4.5e+25)
Calculate the molar mass of CaC2H3O2. (Include correct units and round to the nearest whole number)
For a sample consisting of 258.49 × 1023 molecules of methane, CH4, calculate
Give the name and value of the number associated with the mole.
Calculate the ratio of moles of H2O to moles of anhydrous KAl(SO4)2. Show all work including units. Note: Report the ratio to the closest whole number. Moles of H2O= 0.052 mol Moles of KAl(SO4)2= 0.008 mol
Acetylene (C2H2) gas is often used in welding torches because of the very high heat produced when it reacts with oxygen (O2) gas, producing carbon dioxide gas and water vapor. Calculate the moles of oxygen needed to produce 1.30 mol of water. Answer with unit symbol and 3 sig
Assuming gasoline to be pure octane, C8H18 (actually, it is a mixture of many substances), an automobile getting 22.7 miles per gallon would consume 5.10x10^23 molecules per mile. Calculate the mass of this amount of fuel. Mass = g Please provide only typed answer solution no handwritten solution needed allowed
3. Now let's suppose it's your turn to be the professor. You want to write a question for your students using theoretical data. Suppose you want their "unknown liquid" to be toluene (molar mass = 92.1 g/mol). Using the data in the table below, what should the "mass of flask + unknown condensed liquid" be so that they can correctly identify toluene as their unknown? Mass of flask: 77.485 g Mass of flask + unknown condensed liquid: ????? Temperature of water bath: 100 °C Pressure of gas in our system: 0.997 atm Volume of gas in our system: 255 mL Group of answer choices: A) 78.250 B) 0.765 C) 1.04 g D) 78.525 g
Choose the letter/s that applies: Suppose we have 2 substances (chloroform and aspirin), in computing the molecular mass of the 2 cited substances, which is/are common to the 2 of them: a. similarity of the molar mass b. similarity of molecular mass c. similarity of the number of molecules of the 2 substances d. similarity of the number of mole
The mass percent of oxygen in CaO is?Is this correct answer 28.5%?
An instrument uses potassium bromide as one of the compounds in the analysis of noble gases of a planet. Potassium bromide has a specific gravity of 2.38 and a molecular weight of 119 grams per mole [gmol]. Assume the spacecraft has a liquid sample of potassium bromide onboard that fills a 1.35-gallon [gal] container. What is the amount of the potassium bromide sample in the container, in units of moles [mol]?