Find the rms value of the voltage waveform shown below. If the voltage is applied to a 9-Q resistor, calculate the average power absorbed by the resistor. V(t) -1 Cycle- 4 6 4 8. -2 -10

Q: Given the unity feedback system: R(s)+ E(s) 2s +8 Y(s) s+4 The system type is The steady state error…

A: Given data,

Q: The load in the circuit shown absorbs 50 kVA of complex power at power factar pf = 0.83 lagging when…

A: In this question we will find power factor at source with given data..

Q: A 15 mH is connected in series with another coil. The total inductance in series addition and series…

A:

Q: An electrodynamometer-type wattmeter has a current coil with a resistance of 0.1 Q and a pressure…

A: Given Data (a) V = 250 V I = 12 A pf = 1 (b) V = 25 V I = 12 A pf = 0.4

Q: 3. Given the potential field, V = x²y + xy³ + xz?, and a point P(-3, 0, 6). a) The potential field…

A:

Q: o+15 V 250k 2.2k 22k C 1815 A. an increase in current gain causes an increase in а. Ic b. VCE c. IB…

A:

Q: A Triac control of a three-phase, 30 kW, 400 V, 50 Hz, six-pole, star- connected squirrel-cage…

A:

Q: What is the frequency of rotor current of a 50 Hz induction motor operating at 2% slip?

A: Given an induction motor has, Operating slip, s = 2 % = 0.02 Motor frequency, f = 50 Hz

Q: A 460V, 1250rpm, 30hp DC shunt motor, operating at rated conditions is to be dynamically braked by…

A: In this question,   We need to draw the complete schematic of the motor in the braking.

Q: What is the ratio of starting torque and maximum torque of a 3 phase, 50 Hz, 4 pole induction motor…

A: Ratio of Tst to TmaxTstTmax=2 SmaxSmax2 +1

Q: o +15 V 250k 2.2k 22k C 1815 If the base current is 10 µA and the collector voltage is 10 V, the…

A:

Q: (2) The signal from a sensor is conditioned with an anti-aliasing filter with a cut-off frequency of…

A: Given data, A signal is conditioned with anti-aliasing filter. Cutoff frequency, f=1000 Hz

Q: 9. Find t R 62 12 V 24V

A: In this question we need to find a current I2

Q: Refer to the figure below where packet Pis forwarded to Network2. R1 R2 MTU-4500 MTU-1500 Network1…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Full the following blank (1100 0001 0111 0110)BCD (5321) +(1000 1010 0111)BCD7421=( ) 8 O 121015 O…

A: [1100   0001   0111   0110] BCD (5321) The above term in decimal is equals to (8165)10  And, [1100…

Q: An impedance Z(s) is subjected to an input, as shown in the following figure. As a result, the…

A:

Q: Problem [12] Find the voltage on the capacitors under de conditions. 10 2 50 2 20Ω + 70 2 V2 C2 60 V

A: In this question we need to find a voltage across capacitor

Q: 6-Define transmission parameters 7- Why ABCD parameters are also called as transmission parameters?…

A: As per the guidelines given, We can only provide the solution of the one question in multiple type…

Q: Find the entropy for five messages with equal probabilities 1 11.61 2.322 0.464 O

A: For equal probability mesaage,pk=1M (M= Number of message)Entropy H=log2M

Q: 1. In the following model of a physiological system, find the equation in S domain relating between…

A:

Q: roblem 3 nd the characteristic equation and its roots for the circuit shown. 10 10 μF Vs 1 mF

A:

Q: 10 V 20 V 3Ω -4 V Please find Select one: O a. 2 O b. -2 O .4 O d. -3 O e. 3

A:

Q: 2. Full Wave Bridge Rectifier a. Determine V. and the required PIV rating of each diode for the…

A: We need to find out output for full wave rectifier

Q: abre em t-0 Rbat 20 Chave N.F. L 0,5 H Vbat 24 V V 0,02 F R the

A:

Q: The following circuit has the following values:R = 40 Ω, L = 2,5 μH and C = 4nF. a)Assuming that…

A: We use Laplace transform to solve this question

Q: The power input to a 415 V, 50 Hz, 6 pole 3-phase induction motor running at 975 rpm is 40 kW. The…

A:

Q: 3- For the circuit shown below, apply the superposition theory to calculate theoretically the…

A:

Q: What value of input resistance is needed in the given circuit to produce the given output voltage ?…

A: We need to find out input resistance for given circuit

Q: 16 V Rp2 2.7 kN Ipss =9 mA Vp=-8 V %3D I MO Rs

A: MOSFET is a metal oxide field effect transistor, it belongs to the family of FET, it is a…

Q: What value of input resistance is needed in the given circuit to produce the given output voltage ?…

A: Given circuit,

Q: Problem 3 Find the characteristic equation and its roots for the circuit shown. 10 20 10 µF Vs 1 mF

A:

Q: 3- If we replace the 1KN resistor with 2KN resistor, what-is ife value of the current passed through…

A: For calculate current in 2 kohm resistance  current is caculated by  nodal analysis at node A while…

Q: Ql: A) A 30, 3 wires T.L system work by 380 KV between lines to supply a load with lagging power…

A: Since you have asked multiple questions in a single request, we will be answering only the 1st…

Q: The figure shows the excitation curve (including residual voltage) of a 170 kW, 250 V DC shunt…

A: Given curve is for 850 rpm  rated current. Nrated =850

Q: Q18. What will be the operating power factor of a 3-phase induction motor, whose ratings are 230 V,…

A: In this question we need to find a operating power factor of a 3 phase induction motor

Q: z-transform of the sequence : y(n)=2.5u(n)-1.5u(n

A: In this question, we will find z transform of given sequence...

Q: For the circuit shown below, the initial conditions are zero, Vdc is a voltage source continuous and…

A: As per the guidelines of bartleyby I need to answer first three subparts only so kindly repost other…

Q: 2- Using the Fourier series, what are the harmonics of the output wave and V of the PWM inverter and…

A: PWM refers to pulse width modulation, This technique of digital modulation for communication systems…

Q: 3.2 Find the Inverse Laplace transform f(t) if given the Laplace Transform function 1 F(s) = s(s+1)…

A: Inverse laplace of 1s=u(t)Inverse laplace of 1s2=t u(t)Inverse laplace of 1s+a=e-at u(t)

Q: The circuit shown below operates in steady state for t < 0, while the switch remains closed. At t =…

A: Circuit for t&lt;0 Circuit for t &gt; = 0

Q: ーズくx<0 4 1 1 4) f(x)= |TーX cos(x) +cosßx)+cos(5x)+. 25 Ans. 0<x<T

A: Since you have asked multiple questions in a single request, we will be answering only the 1st…

Q: 4. Complete the timing diagram for the gated SR latch based on the Table 4. Assume that the input…

A: In this question,   We need to determine the timing diagram of output of the SR flip flop. the given…

Q: 10 V 6V Find i Select one: O a. 0.333 A O b. 0.666 A O c. -2.666 A O d. -0.333 A O e. -0.666 A

A: Given,

Q: Let εR = 6, μR = 8, and σ = 0. If Jd = 25sin(1.04 x 105t - 5x) az μA/m2, find E(t=1.5, x = 2.1).

A: In this question,   We need to determine the E(t=1.5, x = 2.1). If εr = 6, μr = 8, and σ = 0. If Jd…

Q: RTD is a temperature coefficient device.

A: RTD stands for - Resistance Temperature Detector which is a device used to measure the change in…

Q: 2420°v A 520°A I 1 j20 j12 I2 -jlQ d b ell I3 -ji07 5/30°A I 4 I5 le

A:

Q: Q1/ In Sampling Theory solve the signal is = 3cos2000nt+5sin1500rt-10cos1400nt. %3D 1. Find Nyquest…

A: As per the guidelines of Bartley we supposed to answer first three subpart only

Q: Question 2: In the following schematic Fig. 2, apply KVL to the two loops and find ig when Vị 12 V…

A: Given circuit, Where, Vs=12 V

Q: A 55 hp, 440 V, 400 rpm DC shunt motor draws 107 A when operating at rated conditions. The motor has…

A:

Q: *2. Using superposition, determine the current I, for each network of Fig. 18.110. R IL 30 E = 10 V…

A: In this question,   We need to determine the current IL  using the super position theorems?

Digital Integrated Circuit Design

Digital IC design is a procedural interaction that involves converting determinations and highlights into computerized blocks, which are then further transformed into basic circuits. A significant number of the imperatives related with advanced IC plan come from the foundry cycle and innovative restrictions.