For a 4-pole dc armature with 28 slots and 8 coil-sides per slot, find the winding pitches and the commutator pitch for a wave winding. What is the distance between brushes in terms of commutator segments

Q: The input-output pair shown as below is given for a stable LTI system: x[n] = 8[n+ 1] + 28[n] + 8[n…

A:

Q: A 3-phase, 11kV wye-connected synchronous alternator has a synchronous reactance of 8 ohms per phase…

A:

Q: Fig. 1. Then, find the current through R. for values of 102 and 302, and find the value of R, for…

A: Given,

Q: Figure shows a chopper. The device S1 is the main switching device. S2 is the auxiliary commutation…

A: Given- Load current- Io=20 A, voltage V=200 V, Capacitance C=2μF, L=200 mH, To Find- The peak…

Q: Determine,if it exists,a state feedback gain K such that the closed loop poles are located at −5 and…

A:

Q: Find v₁ and v₂ in the circuit using nodal analysis. V1 1092 5 VI 292 www 6 A 592 Show complete…

A:

Q: In the following circuit, Vs = 35. What is the voltage across R3? —— Vs R1 ΣΚΩ R2 ·1ΚΩ R3 www 1ΚΩ

A:

Q: QUESTION 9 Determine the impedance and phase angle for the circuit below. 18 Vrms f=2 kHz ( C₁ 0.1…

A:

Q: Vin 1 uF 80 k Ohm 80k 20k 20 k Ohm 3k 3 k 0hm 1 k Ohm Vo 5 kOhm V

A:

Q: Go, (s) = K ts+1 parameters

A:

Q: For the system in the given figure the characteristic equation is R(S) K(s+1) S + 3 s(s+2) C(s)

A: Solution !!

Q: Design a colpitts oscillator to oscillate at 100 KHZ, use L=o.lm H and the gain must be not exceed…

A:

Q: Find the amplitude and frequency of the following waves: 2.1. 15 sin 377t 2.2. 104 sin 754t

A: Given : 2.1 15 sin 377t

Q: 10) The secondary side of a Delta-Wye transformer is shown below, with the line-to-line 208 V…

A:

Q: If R1= 1 Ohm R2= 2 Ohm. Suppose R1 and R2 are connected SERIES. Then what is Equivalent (a)10 Ohms…

A:

Q: A coil has 480 turns and flux in it changes from 0.24 m Wb to 1.2 m Wb in 0.24 second. Calculate the…

A:

Q: Q6) Determine the current drawn from the source in the given circuit in Fig. 6. V₁ 14V 292 R₂ 1202…

A:

Q: 14. A 110-V household circuit that contains an 1800-W microwave, a 1000-W toaster, and an 800-W…

A:

Q: 1. Write the differential equation of the following function. s³+4s²+25+2 s²+2s²+1 1. write the…

A:

Q: 2. Two dc shunt generators each having an armature resistance of 0.02 ohms and a field resistance of…

A:

Q: 8.42 The voltage across an impedance Zis 100/15° and the current through Z is 202-45° A. The active…

A: Given, Voltage across impedance, V=100∠15° V. Current through impedance, I=20∠-45° A.

Q: Calculate the reactance of a coil of inductance 0.32 H when it is connected to a 50 Hz supply. A…

A: This is a basic problem of inductance. The solution is given in the next step

Q: 26. What does a radio wave consist of? Answer:

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: How to generate 480V three phase 400Hz ac from 230V three phase 60Hz ac source? (Please specify the…

A:

Q: Q4) Find the Norton equivalent circuit for the portions of the networks of Fig. 4 external to branch…

A: The given circuit is shown below Find Northern equivalent circuit and power dissipated through 100…

Q: In a basic block diagram, where is summing point usually located? Near the reference input Near the…

A: The summing point is located after the reference input and before the controller transfer function.…

Q: Microprocessors and microcontrollers are two independent types of electrical equipment. What…

A:

Q: Calculate the voltage between points A and B in the circuit above, given the following values: V2 =…

A:

Q: Solve the following. Show complete solution, complete equation, resistor combination and circuit…

A: We need to find out the value of voltage for given circuit , we will apply kvl to find out voltage .

Q: 18V- 9Ω www. 8Ω Μ 12Ω 18Ω 11Ω www 5Ω ΖΩΙ ΜΕ ΠΩ 3Ω Μ ΠΩ ΕΣΤΩ 5Ω

A:

Q: 3.a Determine the output voltage waveform of the circuit. Vie in +10 V OV -10 V 10kΩ Σ Vour Indicate…

A:

Q: Q1/ For a LTI system, drive the frequency response, if you know that the input is: r(t) = M cos(wt +…

A: Frequency response  Control engineers can study and create control systems in the frequency domain…

Q: Solve for VGs of an EMOSFET if VG = 6.44 V, VGSTH=3V, IDON=5.8mA, VGSOFF=5.7V, and Vs=1.22V.

A: Given: VG=6.44 Volts, VTh=3 V, IDon=5.8 mA, VGSoff=5.7 V and VS=1.22 V.

Q: nodal analysis

A: It is given that:

Q: In the circuit shown, the power factor is: -j8 || O 6Ω ww 3 12 3.12 j2

A: Given data, Circuit diagram is given as,

Q: A 12 V battery is connected across a load having a resistance of 40 Ω.Determine the current flowing…

A:

Q: 10. = 10000 2, RD = 680 02, RE = 2200 2, and RF = 100 Q. Assume that L = 10 mH, C = 2.2 μF, RB…

A: The required parameters can be calculated by using the nodal analysis and ohms law. The given…

Q: Show that 1 [hp] ≅ 0.75 [kW].

A:

Q: Explain step 2

A:

Q: a.) A certain voltage doubler has 20 Vrms on its input. What is the output voltage? Express your…

A: We need to find out the output voltage for a doubler circuit .

Q: 1. Explain the operation of clippers circuit. 2. List at least 3 applications of waveshaping…

A: 1) Clipper circuit: Electronic circuits known as clipper circuits eliminate a piece of an AC signal…

Q: P2.39. Use the current-division principle to calcu- late the value of i3 in Figure P2.39. 30 mA R₁ =…

A:

Q: Use the current divider rule to calculate the theoretical currents I, ID , and IE . (RECONSTRUCT THE…

A:

Q: * A 213V 60Hz supply drives a load with an impedance of 28<45°ohms. What is the real power in watts?…

A:

Q: (b) Two conducting spherical shells have radii a=3 cm and b = 6 cm. The interior is a perfect…

A: In this question,  We need to determine the capacitance C of the spherical shells.  a and b are…

Q: How you will read this graph? How much is the inrush current

A: Inrush Current:- The current that is absorbed by a transformer during transformer energization is…

Q: A delta connected balanced 3-phase supply has a line to line voltage of 181 V and supply a line…

A:

Q: Consider a system having a linearly polarized transmitting antenna. The electric field of an…

A: The normalized transmitted field vector is projected onto the normalized receiving antenna…

Q: Q13) Calculate the current I, in the following circuit 100mA I + Vs R 177/ 1 50mA 2 TZ I 3 D

A: Given data, Circuit diagram is given as,

Q: A 169V 60Hz supply drives a load with an impedance of 27<45°ohms. What is the apparent power in VA?…

A:

Winding and Constructions

Alternating Current (AC) winding is generally of the 3-phase type due to the inherent advantages of the 3-phase machine. Armature coils must be connected to the yield balance (equivalent in magnitude and 2/3 of the series phase difference of the rod) 3-phase electromotive forces (emf). The armature should be divided into step-bands to start with slots around the perimeter.In the construction of AC machines, the frame is used as an external protective shield to protect it from environmental conditions. The frame also serves as the outer perimeter, allowing the interior to be easily placed. The static state section of the devices is the stator winding attached stator.