Answered: For a germanium diode, calculate the…

For a germanium diode, calculate the current at room temperature if the forward voltage, V = 0.3 V and the reverse saturat current I, = 100 nA. (A) 10.8 PA B) 34.24 UA C) 11.79 MA

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter1: Atomic Structure

Section: Chapter Questions

Problem 6RQ: How many valence electrons are generally contained in materials used for insulators?

See similar textbooks

Related questions

Q: For all problems, solve for the following a. Vgs b. ld c. Zin d. Zout e. Av 20 V 6.2 ΚΩ HH V₁0 1 ΜΩ…

A: For the above given depletion n type MOSFET we need to calculate DC as well as AC parameters.

Q: An induction motor is an example of O stepper motor O asynchronous machine O DC machine O…

A: From given list of motors, Stepper motor comes under special purpose machine. DC motor and DC…

Q: When the switch is opened at t=0, obtain the 1K ohm resistor voltage for t> 0 in the circuit shown…

Q: 6. A 5,000-kVA, 3-phase transformer, 6.6/33-kV, NY, has a no-load loss of 15 kW and a full-load loss…

Q: A d.c. generator running at 25 rev/s generates an e.m.f. of 150 V. Determine the percent- age…

Q: Calculate the resistance of wire Given data - Length = 150 m Cross sectional area = 0.2 mm²…

A: given length , cross sectional area , resistivity of a wire and asked to find the resistance.

Q: Design ADC using VTC (Voltage to Time Converter) with clock generator fe-32Hz and the slope of…

A: Given data, Slope K=0.025 Maximum Analog Input VA=20V Frequency fc=32Hz

Q: Q.9 Find the transfer function given below: G₁ X(s)- H G₂ Y(s) X(s) Y(s) of the system -Y(s)

Q: 2.51 Determine and sketch the impulse response of the following systems for n = : 0, 1,...,9. x(n)…

A: Given data, n=0,1,2,3...........9

Q: Solve for V2 if Ra = 24 ohms, Rb = 26 ohms and V = 24 volts. (Give the numeric value only, and use 2…

A: Given circuit, Where, Ra=24 ΩRb=26 ΩV=24 volts

Q: 5. The output voltage, vo, developed by the circuit of Fig. 3 for R = 330kn, is R 33 ΚΩ V₁=+0.2 V-…

A: To find the output voltage Vo , developed by the given opamp circuit

Q: 1. For RC transient circuit, when capacitor voltage equal source voltage? a.93.6ms b. 63.9ms c.…

Q: For a given transfer function H(z)= (z+1)/(Z-0.2) the impulse response h(n) is Oh(n)=-1.25…

A: To find the impulse response of the given transfer function H(z)

Q: What is the function of the circuit in given figure?

A: According to the question, we need to explain the function of the circuit shown below

Q: Q1. Find the voltage across each resistor ww 20 ΚΩ 10 ΚΩ 10 V 20 V 30 ΚΩ m

A: Given circuit:

Q: Q2\ Find the current value for the resistance (4 ohm) using mesh (loop) method or nodal method. All…

A: given here a electrical circuit and asked to determine the current in resistor 4 ohms

Q: = Given the open loop transfer function G(s) such that the output settling time T, = 2. R(s)+…

Q: How long does it take C to charge to 2.3 V in the below figure? C = 4.4 nF, and R = 1.9 kQ. The…

A: Given, C=4.4 nFR=1.9 kΩV=2.3 VV0=15 V

Q: ● A buck converter is supplied from a 50V battery source. Given L=400uH, C=100uF, R=20 Ohm, f-20KHz…

A: Types of Basic DC-DC Converter Buck Converter Boost converter Buck-Boost converter

Q: 28. A circuit when connected to 200 V, 50 Hz mains takes a current of 10 A, leading the voltage by…

A: given a circuit when connected to 200V ,50 Hz main takes a current of 10 A , leading the voltage by…

Q: 1. For op-amp in the figure 1 below, the value of the current (₂ is 10 kn ww 1 kn www -0% IV 1/4 4…

A: Given circuit,

Q: a) For the Current Locus shown Draw the equivalent electric circuit? Find the value of each element…

Q: 2. Current is defined as the rate of charge flow. If a charge of 0.0065) colombs passes a given…

Q: 20. In an inductive series circuit, a voltage of 10V at 25 Hz produces 100 mA while the same voltage…

A: In this question, We need to determine the values of the resistance R and inductance L? We know…

Q: 7.2 A 30 HP AC motor operates at full load, and draws 25 kW. What is the efficiency of that motor?

A: Given here A 30 HP ac motor operates at full load , draws 25kW here we have to find the efficiency…

Q: Find the polarization of dielectric material with dielectric constant 2.8 and electric flux density…

A: Given data : Dielectric constant εr=2.8 Electric flux density D=3×10-8cm2

Q: 192 1124 292 5) 492 ure 16.18 For Example 16.8. Fig. 16.18. Solution: METHOD But Hence, By current…

Q: A 3-phase 60 Hz I.M. has a rated speed = 1650 R.P.M., its speed at slip = -0.15 is equal to:

A: In this question, We need to determine the speed at the slip = -0. 15 We know Synchronous speed N=…

Q: ohm per phase. Calculate the synchronizing power per mechanical degree displacement

A: The synchronous generator converts mechanical energy into electrical energy. It works on the…

Q: A 500 VA, 115 V/230 V, 50 Hz single-phase transformer has 360 turns on the secondary. Calculate: a)…

A: Given, A single phase transformer has S=500 VAV1V2=115230f=50 HzN2=360 turns

Q: 1012 W 1.5 A 1512 15 u w m w R 11 R=6.602 C

Q: Q3// Drive fault current for single line to ground fault- asymmetrical faults.

Q: 4. Using the identical op-amp at problem 3, with the same parameters, v = 10mV, R₁ = R₁ = 2kf, and…

A: Given here a op amp based circuit and asked to find the output voltage.

Q: What is the importance of modulation and demodulation in FM? thanks

Q: By using mesh equations, find the current in 22 resistor in figure below. Es Ez 2V T Ry 22 lov ے سے…

A: This question comes under electrical circuit theory . It is based on the concept of mesh analysis in…

Q: 12 Ω w w 8 Ω a 10V 6Ω b What is the Thevenin resistance external to the resistor R? 15.4 Q 3.4 Ω Ο…

A: We need to find out thevenin equivalent resistance

Q: = Given the open loop transfer function G(s) such that the output settling time T, = 2. R (s) +…

Q: * F.Find the values of R and Vs in fig R ww 332 TA In R=2.1 Vs 12v R=202 Vs 12v R=2.20 Vs=11v O…

Q: F = 2 ( 0 ₁ 1 ₂ 3 ₂ 4 ₂ 8,9,15) 2 16 to 1 Mux

Q: A. explain method of locating reactors-bus bar reactors.

A: Note- As per given in the question, solving the first question, if required post other question as…

Q: Q2/ chose A or B A-The I-V characteristics of a light bulb are provided in Fig. (2) If the rated…

A: The questions are based on basics of electrical circuits and the use of OHMS LAW.

Q: 20. In an inductive series circuit, a voltage of 10V at 25 Hz produces 100 mA while the same voltage…

Q: A single-phase fully-controlled bridge converter supplies power to a highly-inductive load with…

A: The output dc voltage is given as: Vdc=2VmπcosαVm=2402Vdc=2×2402πcosαVdc=216.076cosα V (a) The…

Q: CHAPTER 16 Applications of Laplace Transforms Solution: Figure 16.12(b) represents the entire…

Q: Consider an audio signal that is represented by the sum of three sinusoids: s(t) = 3[sin(1000.pi.t)]…

A: Given, An audio signal represented by sum of three sinusoids st=3sin 1000πt+4sin 2000πt+4sin 4000πt

Q: PAN is abbreviation of: O Private Area Network. O Personal Area Network. OPublic Area Network. O No…

A: We need to select correct option

Q: Consider a signal whose bandwidth is 4.5 MHz. If this signal is converted into PCM with 1024…

A: Given: A signal with bandwidth, B.W. = 45 MHz Quantization level, Q = 1024 Signal is sampled at a…

Q: Determine the resistance and conductance of 20m of copper wire 2mm in diameter. S=8^-10*1.72=…

A: Given : Length of wire=20m , diameter=2mm or radius =1mm or 1x10^-3 m resistivity=1.72 x 10^-8 ohm…

Q: ohm per phase. Calculate the synchronizing power per mechanical degree displacement

A: Synchronous machine works on the faraday's laws of electromagnetism. It is a doubly fed machine. The…

Q: If the current running in the secondary winding of a transformer is 6 A, and the transformer has a…

A: Given, Current running in the secondary winding, Isecondary=6 A Transformer turns ration,…

Question

For a germanium diode, calculate the current at room temperature if the forward voltage, V = 0.3 V and the reverse saturation
current I, = 100 n.A.
(A) 10.8 PA
(B) 34.24 UA
11.79 mA
(D) none

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

How is a solid-state diode tested? Explain.
How many valence electrons are generally contained in materials used for insulators?
Find the value of dc and ac resistance of a Germanium junction diode if the temperature is 25 degree Celcius, Reverse Saturation Current is 20 microAmperes and applied voltage of 0.1V. a.) rDC= 75.6 ohms, rAC=11.2 ohms b.) rDC= 120.7 ohms, rAC= 28.4 ohms c.) rDC= 95.1 ohms, rAC=12.3 ohms d.) rDC= 109.2 ohms, rAC=26.3 ohms
4670V = VsR = 200kΩ C = 0.1μF Consider the circuit and parameters illustrated above. If a derating factor of 12% is sugested then calculate, 12) the maximum reverse voltage rating of the diodes; 13) the string efficiency of this arrangement; 14) the maximum difference in leakage current of the diodes; 15) the maximum difference in stored charge of the diodes.
3. What are the main applications of using diodes in commercial power supplies such as laptop power supply? Please provide an original response, thank
Draw the V-I characteristic curve of a Ge based Zener diode with Zener breakdown voltage (?z=5 ?). Indicate three different regions of the curve. Subject: Electronic devices
In the given system; Va, Vb, Vc effective value is 220V, Ly=300 mH and Ry=22 Ohms.It was observed that the yuk current is continuous when the tristorier is triggered for alpha=65 degrees; and D1the average value of the diode current was calculated as ID1 avg = 1.703A.Accordingly, calculate the average value of the current flowing through T3. IT3_ avg=?
(a) Calculate the current at t = 0+ in the circuit shown. (b) Calculate IF, IR, and the storage time expected when the diode is switched off if τT = 8 ns.
A photo-diode which has an input of a change in light intensity, the output form isSelect one: a. Heat b. Voltage c. Current d. Magnetic fielde. Resistancef. Displacementg. Capacitance
Q: A single-phase, full-wave diode bridge is used to supply power to aresistive load of value R = 75 Ω. If the supply voltage is sinusoidal,Vs = 400 sin ωt, Calculate: 1) the average and rms values of the load current. (IL rms), (Idc) 2)the ripple factor (RF)for the load current wave operation.
For a specially designing on junction diode, the value of the forward current is 35 mA at a forward voltage of 3 V. If the eta of the material of the diode is 1.5, then estimate the reverse saturation current.
The diode current in a p-n junction is modeled exponentially (given below.) When the p-n junction is polarized with 0.7V and 0.75V, the currents flowing through the diode are again measured on the basis of 1.36 mA and 7.20 mA. Accordingly, what is the ideality factor? (Note: Take the thermal voltage as mV)