For each reaction between two aqueous solutions described below, use your solubility table to decide if the reaction actually occurs. If the reaction occurs, right the name of the precipitant formed. If the reaction does not occur, write NR (no reaction in the blank) a. aqueous sodium chloride with aqueous calcium nitrate b. aqueous sodium phosphate with aqueous barium fluoride C. aqueous potassium carbonate with aqueous calcium chloride d. aqueous lithium bromide with aqueous magnesium sulfate

For each reaction between two aqueous solutions described below, use your solubility table to decide if the reaction actually occurs. If the reaction occurs, right the name of the precipitant formed. If the reaction does not occur, write NR (no reaction in the blank) a. aqueous sodium chloride with aqueous calcium nitrate b. aqueous sodium phosphate with aqueous barium fluoride C. aqueous potassium carbonate with aqueous calcium chloride d. aqueous lithium bromide with aqueous magnesium sulfate

Introductory Chemistry: A Foundation

9th Edition

ISBN:9781337399425

Author:Steven S. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Donald J. DeCoste

Chapter7: Reactions In Aqueous Solutions

Section: Chapter Questions

Problem 73AP

See similar textbooks

Similar questions

One method for determining the purity of aspirin (C9H8O4) is to hydrolyze it with NaOH solution and then to titrate the remaining NaOH. The reaction of aspirin with NaOH is as follows: A sample of aspirin with a mass of 1.427 g was boiled in 50.00 mL of 0.500 M NaOH. After the solution was cooled, it took 31.92 mL of 0.289 M HCl to titrate the excess NaOH. Calculate the purity of the aspirin. What indicator should be used for this titration? Why?
42. a. Fill in the following table as if it is a well plate and you are mixing two aqueous compounds at a time to see if a precipitate forms. If a precipitate is expected to form, indicate that by writing the correct formula for the precipitate in the corresponding box in the table. If no precipitate is expected to form, write “NO” in the box. CaCI2 Pb(NO3)2 (NH4)3PO4 Na2CO3 AgNO3 K2SO4 b. How do you prepare 300.0 mL of a 0.250 M CaCl2 solution using an available 2(X) M solution? Support your answer with calculations, but also make sure you describe how to prepare the solution.
Suppose 50.0 mL of 0.250 M CoCl2 solution is added to 25.0 mL of 0.350 M NiCl2 solution. Calculate the concentration, in moles per liter, of each of the ions present after mixing. Assume that the volumes are additive.
The Behavior of Substances in Water Part 1: a Ammonia, NH3, is a weak electrolyte. It forms ions in solution by reacting with water molecules to form the ammonium ion and hydroxide ion. Write the balanced chemical reaction for this process, including state symbols. b From everyday experience you are probably aware that table sugar (sucrose), C12H22O11, is soluble in water. When sucrose dissolves in water, it doesnt form ions through any reaction with water. It just dissolves without forming ions, so it is a nonelectrolyte. Write the chemical equation for the dissolving of sucrose in water. c Both NH3 and C12H22O11 are soluble molecular compounds, yet they behave differently in aqueous solution. Briefly explain why one is a weak electrolyte and the other is a nonelectrolyte. d Hydrochloric acid, HCl, is a molecular compound that is a strong electrolyte. Write the chemical reaction of HCl with water. e Compare the ammonia reaction with that of hydrochloric acid. Why are both of these substances considered electrolytes? f Explain why HCl is a strong electrolyte and ammonia is a weak electrolyte. g Classify each of the following substances as either ionic or molecular. KCl NH3 CO2 MgBr2 HCl Ca(OH)2 PbS HC2H3O2 h For those compounds above that you classified as ionic, use the solubility rules to determine which are soluble. i The majority of ionic substances are solids at room temperature. Describe what you would observe if you placed a soluble ionic compound and an insoluble ionic compound in separate beakers of water. j Write the chemical equation(s), including state symbols, for what happens when each soluble ionic compound that you identified above is placed in water. Are these substances reacting with water when they are added to water? k How would you classify the soluble ionic compounds: strong electrolyte, weak electrolyte, or nonelectrolyte? Explain your answer. l Sodium chloride, NaCl, is a strong electrolyte, as is hydroiodic acid, HI. Write the chemical equations for what happens when these substances are added to water. m Are NaCl and HI strong electrolytes because they have similar behavior in aqueous solution? If not, describe, using words and equations, the different chemical process that takes place in each case. Part 2: You have two hypothetical molecular compounds, AX and AY. AX is a strong electrolyte and AY is a weak electrolyte. The compounds undergo the following chemical reactions when added to water. AX(aq)+H2O(l)AH2O+(aq)+X(aq)AY(aq)+H2O(l)AH2O+(aq)+Y(aq) a Explain how the relative amounts of AX(aq) and AY(aq) would compare if you had a beaker of water with AX and a beaker of water with AY. b How would the relative amounts of X(aq) and Y(aq) in the two beakers compare? Be sure to explain your answer.
An aqueous sample is known to contain either Ag+ or Mg2+ ions. Treatment of the sample with NaOH produces a precipitate, but treatment with KBr does not. Use the solubility rules (see Table 4.1) to determine which cation is present. TABLE 4.1 Solubility Rules for Ionic Compounds in Water
An aqueous sample is known to contain either Mg2+ or Ba2+ ions. Treatment of the sample with Na2CO3 produces a precipitate, but treatment with ammonium sulfate does not. Use the solubility rules (see Table 4.1) to determine which cation is present.
Using the general solubility rules given in Table 6-1. name three reagents that would form precipitates with each of the following ions in aqueous solution. Write the net ionic equation for each of your suggestions. a. chloride ion b. calcium ion c. iron(III) ion d. sulfate ion e. mercury(I) ion, Hg22+ f. silver ion
Consider an experiment in which two burets, Y and Z, are simultaneously draining into a beaker that initially contained 275.0 mL of 0.300 M HCl. Buret Y contains 0.150 M NaOH and buret Z contains 0.250 M KOH. The stoichiometric point in the titration is reached 60.65 minutes after Y and Z were started simultaneously. The total volume in the beaker at the stoichiometric point is 655 mL. Calculate the flow rates of burets Y and Z. Assume the flow rates remain constant during the experiment.
onsider the mixing of aqueous solutions of lead(II) nitrate and sodium iodide to form a solid. . Name the possible products, and determine the formulas of these possible products. . What is the precipitate? How do you know? . Must the subscript for an ion in a reactant stay the same as the subscript of that ion in a product? Explain your answer.