For many purposes we can treat propane (C, Hg) as an ideal gas at temperatures above its boiling point of -42. °C. Suppose the temperature of a sample of propane gas is raised from -20.0 °C to 21.0 °C, and at the same time the pressure is changed. If the initial pressure was 1.5 atm and the volume increased by 35.0%, what is the final pressure? Round your answer to 2 significant digits. atm

For many purposes we can treat propane (C, Hg) as an ideal gas at temperatures above its boiling point of -42. °C. Suppose the temperature of a sample of propane gas is raised from -20.0 °C to 21.0 °C, and at the same time the pressure is changed. If the initial pressure was 1.5 atm and the volume increased by 35.0%, what is the final pressure? Round your answer to 2 significant digits. atm

Chemistry

9th Edition

ISBN:9781133611097

Author:Steven S. Zumdahl

Publisher:Steven S. Zumdahl

Chapter5: Gases

Section: Chapter Questions

Problem 61E: An ideal gas is contained in a cylinder with a volume of 5.0 102 mL at a temperature of 30.C and a...

See similar textbooks

Similar questions

A typical barometric pressure in Redding. California, is about 750 mm Hg. Calculate this pressure in atm and kPa.
In the Mthode Champenoise, grape juice is fermented in a wine bottle to produce sparkling wine. The reaction is C6H12O6(aq)2C2H5OH(aq)+2CO2(g) Fermentation of 750. mL grape juice (density = 1.0 g/cm3) is allowed to take place in a bottle with a total volume of 825 mL until 12% by volume is ethanol (C2H5OH). Assuming that the CO2 is insoluble in H2O (actually, a wrong assumption), what would be the pressure of CO2 inside the wine bottle at 25C? (The density of ethanol is 0.79 g/cm3.)
A cylinder of compressed gas is labeled Composition (mole %): 4.5% H2S, 3.0% CO2, balance N2. The pressure gauge attached to the cylinder reads 46 atm. Calculate the partial pressure of each gas, in atmospheres, in the cylinder.
You have a gas, one of the three known phosphorus-fluorine compounds (PF3, PF3, and P2F4). To find out which, you have decided to measure its molar mass. (a) First, yon determine that the density of the gas is 5.60 g/L at a pressure of 0.971 atm and a temperature of 18.2 C. Calculate the molar mass and identify the compound. (b) To check the results from part (a), you decide to measure the molar mass based on the relative rales of effusion of the unknown gas and CO2. You find that CO2 effuses at a rate of 0.050 mol/min, whereas the unknown phosphorus fluoride effuses at a rate of 0.028 mol/min. Calculate the molar mass of the unknown gas based on these results.
Most mixtures of hydrogen gas with oxygen gas are explosive. However, a mixture that contains less than 3.0 % O2 is not. If enough O2 is added to a cylinder of H2 at 33.2 atm to bring the total pressure to 3-13 atm, is the mixture explosive?