Question

For Non-flow Work fow systems with pv=const (Select All correct statements below):

Work is directly proportional to pressure

Work is directly proportional to volume.

work can be written w=p1v2ln(v2/v1)

work can be written as p2v2-p1v1)/(1-n)

Expert Answer

Want to see the step-by-step answer?

Check out a sample Q&A here.

Want to see this answer and more?

Experts are waiting 24/7 to provide step-by-step solutions in as fast as 30 minutes!*

*Response times may vary by subject and question complexity. Median response time is 34 minutes for paid subscribers and may be longer for promotional offers.
Tagged in
Engineering
Mechanical Engineering

Related Mechanical Engineering Q&A

Find answers to questions asked by students like you.

Q: Required information NOTE: This is a multi-part question. Once an answer is submitted, you will be u...

A: Refrigerant is R-134aEvaporator pressure P1 = P4 = 180 kPaCondenser pressure P2 = P3 = 1400 kPaMass ...

Q: Point A of the circular disk is at the angular position 0 0 at time t 0. The disk has angular veloci...

A: Draw the free-body diagram of the circular disk. 

Q: Current Attempt in Progress The system is released from rest in the configuration shown at time t 0....

A: Draw the free body diagram of the system.

Q: A spring-loaded piston–cylinder device contains a mixture of gases whose pressure fractions are 25 p...

A: Given Information:Pressure fraction of Neon fNe=0.25Pressure fraction of Oxygen fO2=0.50Pressure fra...

Q: QUESTION 8 On a Mollier diagram show all the stagnation and static points required to represent the ...

A: Given Information :Inlet velocity of the diffuser is V1 = 375 m/sStagnation pressure at the inlet P0...

Q: C. Consider a typical ranch-style house with brick walls and single pane windows as found in Atlanta...

A: Note:  Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the questio...

Q: At the given instant the top, B, of the ladder has and acceleration of 2.2 ft/s2 and a velocity of 4...

A: Obtain the angular velocity of the ladder. 

Q: Mechanical Engineering Question

A: Draw the velocity diagram for the link AB. 

Q: 3.0 m/s relative to the bar as shown. The distances are L = 2.97 m and d 0.82 m The small collar A i...

A: Given:Speed, u = 3.0m/sLength, L = 2.97md = 0.82mangular velocity = 1.34rad/sec

Q: QUESTION 5 At the inlet to an axial diffuser the velocity of the approaching air is 420 m/s, the sta...

A: Part (i):Given:

Q: Air is compressed steadily by a reversible compressor from an inlet state of 100kPa and 300K to an e...

A: (a)First we have to find the compressor work pressure with isentropic compression with k=1.4 

Q: When the slave cylinder is located outside the bell housing, which part operates the throw-out beari...

A: Basically there are two types of slave cylinders1)External slave cylinder2)concentric slave cylinder

Q: Air enters a compressor operating at steady state at 1.05 bar, 300 K, with a volumetric flow rate of...

A: Given data:

Q: In figure below, water enters at point A and leaves at point C. The process is steady state. The atm...

A: Draw the free body diagram for the fluid and the pipe at joint A as:

Q: A refrigerator that operates on the ideal vapor-compression cycle with refrigerant-134a is to mainta...

A: In order to obtain the heat transfer at a reasonable rate, a temperature difference of 5 deg C to 10...

Q: A piston-cylinder device initially contains 0.8 m^3 of saturated water vapor at 275 kPa. At this sta...

A: The initial volume of piston-cylinder device = 0.8 m3Initial pressure of water vapor = 275 kPaPressu...

Q: 2.56 In Fig. P2.56 pipe A contains gasoline (SG = 0.7), pipe B contains oil (SG = 0.9), and the mano...

A: Write the expression of pressure at the interface between gasoline and mercury on the left column. 

Q: Required information NOTE: This is a multi-part question. Once an answer is submitted, you will be u...

A: Refer “saturated water-temperature table”, and find out the pressure at a temperature of 17 degree C...

Q: a httpssession masteringengineering.com/myct/itemViewhoftset next8iassignmertProblem/D-8226925 ← → 自...

A: The mass of the particle m = 8.5 kgThe force is to be calculated at instant t = 2s

Q: A 50kg copper block initially at 180 degrees C is dropped into an isolated tank containing 90 L of w...

A: first we have to consider the total change in internsl energy of he system as shown belowhere one of...

Q: Compute the planar density value for (1,-1,1) plane of BCC iron (Fe). Zfe=26Rfe=0.126nmAfe=55.845g/m...

A: Planar density for a certain plane in a unit cell is expressed as:

Q: Air enters the compressor of a gas-turbine plant at ambient conditions of 100 kPa and 30°C with a lo...

A: Given Information:For air compressor 

Q: Refrigerant R-134a enters an adiabatic compressor as saturated vapor at 100kPa at a rate of 0.5kg/s ...

A: Obtain the properties of Refrigerant R-134a from “Saturated Refrigerant R-134a: Pressure table”, cor...

Q: A body has a mass of 18 kg falls freely from rest. After falling 235 m, what will its velocity be ju...

A: Given information:mass of the body=18kgAfter falling height =235mThen find the velocity before impac...

Q: At the instant under consideration, the rod of the hydraulic cylinder is extending at the rate vA 3....

A: Draw the schematic diagram.

Q: The mean weight of five complete computer stations is 167.2 pounds. The weights of four of the compu...

A: The mean of given data set (also, referred as the average) of given numerical values is calculated i...

Q: A large piece of biological tissue has to be kept at a temperature as low as possible without freezi...

A: Given Information:Freezing temperature of water Tw=273 KMolecular weight of water Mw= 18Latent heat ...

Q: A two-stage compression refrigeration system operates with refrigerant-134a between the pressure lim...

A: Show the T-s diagram for compression refrigeration cycle as in Figure (1).

Q: An FCC iron-carbon alloy initially containing 0.10 wt% C is carburized at an elevated temperature an...

A: We can find the  diffusion co-efficient for FCC iron alloy as follows:

Q: Here are these questions if I could get help with themIf a spherical storage tank holds 40,000 gallo...

A: There are four questions given in the image but we are entitled to solve only one question at a time...

Q: Consider an ice-producing plant that operates on the ideal vapor-compression refrigeration cycle and...

A: Assume an ideal vapor-compression cycle.In an ideal vapor compression cycle, the refrigerant enters ...

Q: I have attached a figure of an inclined manometer problem. I know I am supposed to use Lsine(α)=H. B...

A: Obtain the value of L when the water is compressed by a distance h and the liquid in the pipe is rai...

Q: 8-90 Water at 15°C is to be pumped from a reser- voir (ZA tion (z=9 m) through two 25-m-long plastic...

A: Apply mechanical energy conservation at points A and B an obtain the expression for head loss due to...

Q: Refrigerant 134a enters the condenser of a residential heat pump at 900 kPa and 40 degrees C at a ra...

A: Assumption:Pump operate in steady stateKinetic and potential energies are neglected. Solution:Draw t...

Q: The mass fractions of a mixture of gases are 10 percent nitrogen, 3 percent helium, 55 percent metha...

A: Assume the mass of the mixture as 100 grams.Given mass of Nitrogen is 10% of mixture which equals 10...

Q: A heat exchanger is used to cool an air flow from 900 to 400 K, with both states at 1 MPa. The coola...

A: Given information:Properties of air:Temperature of air at inlet =900 KTemperatue of air at outlet =4...

Q: Paul has a coupon at the guitar store for 15% off any purchase of $100 or more. He wants to buy a us...

A: Given information:Paul has a coupon at guitar store for 15% off any purchase of $100 or more.He want...

Q: Find the temperature of the following using the ideal gas law:(a) water, P=10KPa, v=30m^3/kg(b) wate...

A: According to question we have to use ideal gas law, but the parameters are given for water. we canno...

Q: The shaft of the wheel unit rolls without slipping and ao 8 ft/sec2 to the left, respectively, deter...

A: Given:

Q: If a ball has a volume of .52 cubic feet, what is the bouyant force on it if it is pushed under wate...

A: Write the expression of buoyant force. 

Q: Find a and b so that the ordered data set has a mean of 24 and a median of 38.15, 32, 25, 28, 37, a,...

A: The mean of given data set (also, referred as the average) of given numerical values is calculated i...

Q: QUESTION 7 multi-stage axial flow turbine, and the pressure drop Air is expanded in a very small. As...

A: Write the basic equation of thermodynamics with ds = 0. 

Q: The flywheel is rotating with an angular velocity wo 1.97 rad/s at time t 0 when a torque is applied...

A: Given:Omega is angular velocity.Alpha is angular acceleration.

Q: A piston-cylinder device initially contains 0.15 kg of air initially at 2 MPa and 350℃. The air firs...

A: Question is to find the boundary work for each process and net work of the cycle.The cyclic process ...

Q: The spool has mass, m, and a radius of gyration kG. An inextensible cord is attached to the wall at ...

A: consider the given diagram

Q: A piston-cylinder device contains 5kg of steam at 100 degrees C with a quality of 40%. The steam und...

A: Draw the process in the T-s diagram as shown in the Figure (1).

Q: In figure below, the force F is applied normal to the gate at point B to keep it closed. The gate hi...

A: Refer to the figure given below to understand the steps following step1:

Q: The wheel consists of a 5.0-kg rim of radius r 260 mm with hub and spokes of negligible mass. The wh...

A: Show the diagram showing a wheel mounted on a yoke rolling on a circular surface. 

Q: In the figure below, the level of the water in the reservoir is controlled with a weightless gate, w...

A: The radius of the weightless gate of quarter of a circle cross section: r = 0.5 mThe gate is hinged ...

Q: The barometric pressure is 30.0 in of mercury. Calculate the atmospheric pressure in psia.

A: Write the relation between the height of the mercury column of a barometer and the corresponding pre...