For problems 1 through 3 below, the initial state of 1 mole of an ideal gas is P₁ = 3 atm, V₁ = 1 liter, and U₁ = 456 J, and its final state is P2 = 2 atm, V₂ = 3 liters, and U₂ = 912 J. 1. The gas is allowed to expand at constant pressure to a volume of 3 liters. It is then cooled at constant volume until its pressure is 2 atm. a) Show this process on a PV diagram, and calculate the work done by the gas. b) Find the heat added during this process.

For problems 1 through 3 below, the initial state of 1 mole of an ideal gas is P₁ = 3 atm, V₁ = 1 liter, and U₁ = 456 J, and its final state is P2 = 2 atm, V₂ = 3 liters, and U₂ = 912 J. 1. The gas is allowed to expand at constant pressure to a volume of 3 liters. It is then cooled at constant volume until its pressure is 2 atm. a) Show this process on a PV diagram, and calculate the work done by the gas. b) Find the heat added during this process.

Chemistry: Principles and Reactions

8th Edition

ISBN:9781305079373

Author:William L. Masterton, Cecile N. Hurley

Publisher:William L. Masterton, Cecile N. Hurley

Chapter8: Thermochemistry

Section: Chapter Questions

Problem 72QAP: On complete combustion at constant pressure, a 1.00-L sample of a gaseous mixture at 0C and 1.00 atm...

See similar textbooks

Similar questions

On complete combustion at constant pressure, a 1.00-L sample of a gaseous mixture at 0C and 1.00 atm (STP) evolves 75.65 kJ of heat. If the gas is a mixture of ethane (C2H6) and propane (C3H8), what is the mole fraction of ethane in the mixture?
At the critical point for carbon dioxide, the substance is very far from being an ideal gas. Prove this statement by calculating the density of an ideal gas in g/cm3 at the conditions of the critical point and comparing it with the experimental value. Compute the experimental value from the fact that a mole of CO2 at its critical point occupies 94 cm3.
What is the change in internal energy when a gas contracts from 377mL to 119mLundera pressure of 1550 torr, whileat the same time being cooled by removing 124.0J ofheat energy?
Which of the following quantities can be taken to be independent of temperature? independent of pressure? (a) H for a reaction (b) S for a reaction (c) G for a reaction (d) S for a substance
Use the two appropriate values of R to determine a conversion between L. atm and J.
A refrigerator contains approximately 17cubic feet, or about 480 liters, of air. Assuming it acts as an ideal gas with a molar CV of 12.47 J/mol.K, what is the change in U in cooling the air from normal room temperature 22C to refrigerator temperature 4C? Assume an initial pressure of 1.00 atm.
ammonia (considered to be an ideal gas) initially at 25 C and 1 bar pressure is heated at constant pressure until the volume tripled. Calculate the q per mole, w per mole, delta H, delta U, and delta S, given that CP=25.895 + 32.999 x 10-3 T – 30.46 x 10-7 (T)2 ? (J/K mol)
1 mol of an ideal gas at 25 ° C and 10 atmospheres (Cp = 3.5 R), adiabatically and reversibly 5 What will be the final volume and temperature when it expands into the atmosphere?
The value of pV is plotted against p for two gases, an ideal gas and a non-ideal gas, where p is the pressure and V is the volume of the gas. Which of the following gases shows the greatest deviation from ideality? ammonia, ethene, methane or nitrogen
‼️Illustrate the problem ONLY: A rubberized, cubic chamber was filled with butane gas and was expanded from 3.0L to 4.5L at a pressure of 2.7atm and it absorbed 230J of heat from the surroundings. What is the change in the energy of the system? Express your answer in L atm. Assuming that the internal energy of this system is all kinetic energy and that the cube contains one mole of butane gas, what is the velocity of a single butane molecule covering a distance between the opposite corners of the expanded cube (express in m)? How long would it take to cover that distance (express in sec, use SI prefixes instead of scientific notation)? How much power can be generated by all the molecules in this cube after 1 hour? Express your answer in W. (Use the v obtained from 2b then recompute total KE) ‼️Illustrate the problem ONLY
Calculate ΔStotal (for the system) when the state of 0.8 mol diatomic perfect gas molecules, for which Cp,m = 7/2R, is changed from 25°C and 1.50 atm to 135°C and 7.00 atm.Express answer in J/K.
An ideal gas confined to a container with a massless piston at the top. A massless wire is attacted to the piston. When an external pressure of 2.00 atm is applied to the wire, the gas compresses from 4.90 to 2.45L. When the external pressure is increased to 2.50 atm, the gas futher compresses from 2.45 to 1.96L In a seperate experiment with the same initial conditions of 2.50 atm was applied to the ideal gas, decreasing its volume from 4.90 to 1.96L in one step. If the final temperture was the same for both processes, what is the difference between q for the two step pocess and q for the one process in joules?