Please solve this problem 3. For RC circuit, adjusted for maximum power delivery condition, the following data areavailable:R=250N, C=25mF and supply voltage = 75V. Calculate charging current and frequencyof discharge when the circuit is closed.

Answered: Image /qna-images/answer/24c8a65d-21ea-4faa-82ff-c1066a7b275b.jpg

For RC circuit, adjusted for maximum power delivery condition, the following data are available: R=2502, C=25mF and supply voltage = 75V. Calculate charging current and frequency of discharge when the circuit is closed. %3D

For RC circuit, adjusted for maximum power delivery condition, the following data are available: R=2502, C=25mF and supply voltage = 75V. Calculate charging current and frequency of discharge when the circuit is closed. %3D

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter8: Basic Electric Motors

Section: Chapter Questions

Problem 37RQ: Which of the following capacitors could be used to replace a 35-microfarad, 370-volt running...

See similar textbooks

Related questions

Q: A resistor of 42 ohm is connected in series with a capacitor of 50 micro farad. If a supply of 240…

A: Given data, Series connected RC circuit, R=42 ΩC=50 μFV=240 Vf=60 Hz

Q: A 240 kV, 3-phase, 50 Hz, 400 km transmission line has a capacitance to earth of 0.04 µF/km per…

A: We have a 3-phase transmission line having, Line voltage (V) = 240 KV = 240 * 103 V frequency (f) =…

Q: Find the impedance theoretically of a wire if it carries the frequency 10 kHz have a voltage is 8v,…

Q: Calculate the equivalent capacitance across a and b given the following A = 28 F, B = 14 F, C = 25…

Q: entals of Electrical Engineering 2020/2021 Dr. Yaseen H. Tahir : (example 15-3, page 388, David) (H.…

A: Given:

Q: Schering bridge is one of the very important and useful bridge for measuring a small capacitance.…

A: In this question we need to verify the given statement is true or false.

Q: 3.) A voltage v = 120 sin (275t + %3D Tt/2) is applied to a capacitor rated 68 µF. Find the r.m.s.…

A: To find the RMS value of current through capacitor

Q: QUESTION 57 Short Problem: Given a parallel RLC circuit comprised of the following element:…

A: First we will find out the total current then we will find out the total apparent power then we will…

Q: Calculate the current (Ic) taken by a 20 µF capacitor when connected to a 240V, 60Hz supply. lc =…

A: Given, Capacitance, C=20 μF Source voltage, Vs=240 V Frequency, f = 60 Hz

Q: Short Problem: Given a series circuit comprised of the following element: 56.51-ohm resistor,…

Q: b) We want to replace three materials with just one material such that the equivalent capacitance…

A: We need to find out total capacitance and and voltage across capacitor .

Q: Design an Ayrton shunt by indirect method to provide an ammeter with current ranges 1 A, 5 A, and 15…

A: We need to find out the shunt resistor for given instrument .

Q: A 17.7-uF capacitor, C, an unknown inductor, L, and a 100-2 resistor are all connected in series…

A: Explanation:

Q: Practical Side Choose the right answer of the following: 1- As pressure decreases, the disruptive…

Q: Given a parallel RLC circuit comprised of the following element: 76.19-ohm resistor, ideal inductor…

A: True power is nothing but power consumed by resistor Given by P = Vrms2/R

Q: C2 C1 4 uF 1 uF C3 3 uF A- -B C4 2 uF C5 2 uF

Q: A 12-Volt battery charges the four capacitors shown in Figure 5.12.1. C, Figure 5.12.1 Let C = 1 µF,…

A: If capacitors C1 and C2 are in series equivalent capacitor is C1×C2C1+C2 If capacitors C1 and C2 are…

Q: Assuming the dielectric of each capacitor is air and the network is connected to Vab = 30V supply,…

Q: A1 MF capacitance is to be constructed from rolled-up sheets of aluminum foil separated by a layer…

A: The capacitor stores the charge in the form of voltage. The current can be exponential decaying or…

Q: In the circuit given below; A) Equivalent capacity, B) Total load, C) The load per capacitor, D) The…

A: Let us mark the nodes in the circuit.

Q: . Which of the following conditions limit the alysis of quiscent point (Q-point)? A. The circuit…

A: Quiescent point or Q- point- When a line is drawn joining the saturation and cut off points, such a…

Q: Given a series circuit comprised of the following element: 82.89-ohm resistor, practical inductor…

A: In this question we will find impedance angle in degree...

Q: Given a parallel RLC circuit comprised of the following element: 63.92-ohm resistor, ideal inductor…

Q: 1. An inductor has an inductance of 0.65 henry and is connected to a 277 volt, 60 Hz line. How much…

Q: A series resistance-capacitance (RC) circuit is connected to a 230 Volt, 60 cycle source. If the…

Q: A capacitor is rated 100 kVAR, 380 V, 50 Hz. Find its rating at 60 Hz, 220 V

A: As per Bartleby guidelines for more than one question asked only first is to be answered please…

Q: A capacitance is rated 100 kVar, 380 volts, 50 hz. What will its rating be at 60 Hz 220 V?

A: This question belongs to circuit theory . It is based on the concept of calculation of rating of…

Q: refer to attached schematic diagram: The discharging time constant is 40 V 10 s 10 ms 1 ms O 18…

Q: 2/2 pts For a triac circuit shown in figure 5, determine the firing angle if the triac will turn on…

A: The solution is given below

Q: A resistor of 250Q, is connected in series with a 1.5 H inductor, cross a 100 V, 50 Hz supply.…

A: To solve above problem, one should have basic idea about working of AC circuits. Above given circuit…

Q: A 12-Volt battery charges the four capacitors shown in Figure 5.12.1. C Figure 5.12.1 Let C = 1 µF,…

A: Given circuit is - Given that switch is open. Given values are - C1=1μFC2=2μFC3=3μFC4=4μF

Q: In the circuit given below; K) Equivalent capacity, L) Total load, M) The load per capacitor, N) The…

Q: Assuming the dielectric of each capacitor is air and the network is connected to Vab = 30V supply,…

Q: A coil of resistance 5 ohms and inductance 120 mH in series with a 100 μF capacitor, is connected to…

Q: A coil of inductance 2 Henrys and a resistance of 10 ohms is connected with an emf, E=200sin20t…

A: Find current at t = 0.05 sec for the given RL circuit ?

Q: Question 1: The circuit below shows a reactor being disconnected from its supply. During the process…

A: In the circuit reactor being disconnected from its supply, Given, L1=15mH L2=352mH C=3.2nF Assuming…

Q: Three capacitors whose capacitances are in the order (4 μF, 8 µμF, 12 µF, are connected in parallel,…

A: In this question, We need to determine the amount of the charge Q? If three capacitance C1, C2 and…

Q: D) Two capacitors A and B having capacitances of 20 uF and 12 uF respectively, are each connected…

A: The charge stores in capacitor in the dielectric with which the capacitor. The charge stored is…

Q: Given a parallel RLC circuit comprised of the following element: 58.48-ohm resistor, ideal inductor…

A: In this question, Find the active power in the circuit Power P= V2 /R Watt

Q: Data: e1=11e0, e2=11e0, e3=5e0, €4=6€0 and e5=7e0 Calculate: a) E,D, and P in all media; b) The…

A: capacitance= (permitivity)(Area)/(distance between plates) TOTAL ENERGY STORED = 0.5* CAPACITANCE *…

Q: voltage v = 120 sin 377t V is applied across a pure capacitance of 100μF, Determine a) the…

Q: 12. A capacitor is charged 0.23 watt- second of energy at a voltage of 48 V. What is its…

Q: DIRECTIONS: List down the common defects of a component. Write your answer on the space provided.…

A: 1) common defects of resistor are a) Open circuit if resistor overheated b) increase of resistance…

Q: Given a parallel RLC circuit comprised of the following element: 62.96-ohm resistor, ideal inductor…

A: Given:R=62.96ΩXL=+j56.13ΩXC=+j16.99Ω

Q: Given a parallel RLC circuit comprised of the following element: 86.4-ohm resistor, ideal inductor…

A: Given Data: R = 86.4 ohm XL = 36.64 ohm XC = 15.6 ohm V = 100 cis 0 V

Q: Given a parallel RLC circuit comprised of the following element: 63.01-ohm resistor, ideal inductor…

Q: (b) Determine the inductance value, L when the number of coil's turns, Na is 120. Given that the…

Question

Please solve this problem

3. For RC circuit, adjusted for maximum power delivery condition, the following data are
available:
R=250N, C=25mF and supply voltage = 75V. Calculate charging current and frequency
of discharge when the circuit is closed.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A three-conductor, three-phase cable has 2 mi of length and is being used at 34.5 kV, three phase, and 60 Hz. The capacitance between a pair of conductors on a single phase is measured to be 2 µF/mi. Calculate the charging current of the cable.
Which of the following capacitors could be used to replace a 35-microfarad, 370-volt running capacitor? a. 35 microfarad, 330 volt b. 35 microfarad, 390 volt c. 30 microfarad, 440 volt d. 40 microfarad, 370 volt
A rogue technician working on a live 480 VAC service panel drops a wrench resulting in phase to phase short. Calculate the resulting current if the Thévenin equivalent resistance is 10 mΩ and the wrench has a resistance 30 mΩ.
Design an Ayrton shunt by indirect method to provide an ammeter with current ranges 1A, 5A, and 10A, if PMMC meter have internal resistance of 50Ω and full scale deflection current of 1mA ?
Explore the challenges and benefits of implementing power electronics-based grid solutions like STATCOM (Static Synchronous Compensator) for voltage control and stability.
It is desired to run a bank of ten 100-W, 10-V lamps in parallel from a 230-V, 50-Hz supply byinserting a choke coil in series with the bank of lamps. If the choke coil has a power factor of 0.2, findits resistance, reactance and inductance.
A choke coil of resistance 8 ohm and inductance 0.15 H is connected in series with a capacitor of capacitance 125 ?? across a 230-V, 50- Hz supply. Calculate: (a) the inductive reactance, (b) capacitive reactance, (c) impedance, (d) current, (e) voltage across the coil and the capacitor, respectively. (f) phase difference between the current and the supply voltage.
A 3 phase, 50Hz, Two bus, single transmission line power system consisting of line series resistance of 10, line series inductance of 25 mili Henry and shunt line charging capacitance of 50 micro Farads. Base values are 110kV, 100MVA. Form the bus admittance matrix in per unit.
Enumerate five step-by-step procedures of Norton’s theorem method in application to electric circuit problem solution or analysis.
The following parameters are used in an EDM process, the supply voltage is 150V. The resistance and capacitance in the circuit are 50 Ohms and 15 microfarads respectively. The tool is made of brass and kerosene is used as the dielectric. A hole diameter of 20 mm is to be cut into a plate of thickness of 3mm. If the discharge takes place at maximum power conditions. The value of constant K4=0.18, calculate the MRR, and machining time.
A 3 phase, 50Hz, 66kV overhead line conductors are placed in a horizontal planes 2m apart. The conductor diameter is 1.25 cm. If the line length is 100 km. Calculate i) capacitance/phase ii) charging current/phase assuming complete transposition of the line.
vertical configuration problems architectural implications provide an actual example image