For the circuit in the figure, at t = 0 the switch S isclosed with the capacitor uncharged. If C = 55 µF, ɛ =80V, and R = 4 kN, what is the charge (in mC) on thecapacitor when the current in the circuit is = 3.5 mA?SR+Select one:O A. 5.67ОВ. 4.15OC. 5.17O D. 3.63E. 2.48

For the circuit in the figure, at t = 0 the switch S is closed with the capacitor uncharged. If C = 55 µF, e = 80V, and R = 4 kN, what is the charge (in mC) on the capacitor when the current in the circuit is = 3.5 mA? %3D

For the circuit in the figure, at t = 0 the switch S is closed with the capacitor uncharged. If C = 55 µF, e = 80V, and R = 4 kN, what is the charge (in mC) on the capacitor when the current in the circuit is = 3.5 mA? %3D

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter29: Direct Current (dc) Circuits

Section: Chapter Questions

Problem 60PQ: Figure P29.60 shows a simple RC circuit with a 2.50-F capacitor, a 3.50-M resistor, a 9.00-V emf,...

See similar textbooks

Related questions

Q: Ex.1 A 100-loop square coil of wire, with side L=5 cm. and total resistance R=100 Ohm is positioned…

A: n= 100 L= 0.05m R= 100 ohm B= 0.6 T t= 0.1s

Q: 7. (a) In the figure, R = 10.00 N, C = 6.66 µF, and L = 52.0 mH, and the ideal battery has emf =…

Q: A dielectric of permittivity 3.3x10-11 F/m completely fills the volume between two capacitor plates.…

A: ID =ε dφ/dt ID is the displacement current Epsilon is the dielectric permittivity rate of change…

Q: The distance between two lines, infinitely long, thin wires parallel to each other equals ? = 10…

Q: Figure shows a circuit with an area of ? = 0.060[m2] containing a ? = 1.0[Ω] resistor and a ? =…

Q: Three identical capacitors are connected in delta to a 408 V, 50Hz, 3-phase supply. If the line…

Q: A 10 cm × 10 cm square loop with 1 N internal resistance is on the same plane with a straight wire…

A: We know that magnetic field due to a long current carrying wire is given by: B = u0*I/(2*pi*d) In…

Q: n electric circuit with a battery of electromotive force 10 V has electric resistance of 5 ohm and…

A: Given that, The emf of the battery, E = 10 V Resistance, R = 5 ohms The inductance of the inductor,…

Q: A solenoid has a radius of 3.5 cm, 160 turns and a length of 1.2 m. Take the solenoid to have…

Q: A closed loop conductor that forms a circle with a radius of 0.2 m is located in a changing magnetic…

A: Given : Radius (r) = 0.2 m So, Area (A) = πr2 A = 3.14 * (0.2)2 A = 0.1256 m2 Maximum E.M.F. Induced…

Q: "A single loop of wire of area 0.1 m2 is placed perpendicular to a magnetic field of intensity 2 T,…

Q: Evaluate the induced electric field E(Q) at the pointQ due to a slowly time-varying current i(t) in…

Q: Shown in the figure below is a rectangle of wire immersed in a magnetic field. The rectangle has…

A: Given : l=2 m w=2 m R=7.02 ohm B(t)=5t3+2t4

Q: Q1. An infinite current sheet lies in the z = 0 plane with current l=i ŷ, as shown in Fig. given…

A: Scenario - A magnetic field will be generated due to infinite current sheet that lies along y- axis…

Q: A vertically oriented square loop of copper wire falls from rest in a region in which the field B is…

A: SOlution: given that magnetic field B side of loop is s and wire ediamter d and density of copper…

Q: A perfect conductor 2m long is moved at a speed of 36km/h through a magnetic field having a flux…

Q: The electric current flowing in a resistor is given by I = 20 sin(100t) where I is in Amperes and t…

Q: An ac source supplies a 210.0 amp current to a long straight conductor. The magnetic field is…

A: Given: Current, I = 210 A Magnetic field, B = 120 μT = 120 x 10-6 T The formula for the magnetic…

Q: cting material with resistance 0.0100 Ω/m and radius a=40.0cm. The coil is attached to a C=10.00μFC…

A: Given:- circular coil with N1=5000 turns is made of a conducting material with resistance 0.0100 Ω/m…

Q: A dielectric of permittivity 3.2x10-11 F/m completely fills the volume between two capacitor plates.…

Q: i,A garden is rectangular being 22 m wide and 45 m long. How long is a line drawn from one corner to…

Q: The drawing shows a straight wire carrying a current I. Above the wire is a rectangular loop that…

A: The figure is shown with the direction of Current . To find = What is the direction of induced…

Q: Consider the RL circuit in the figure with R=10.00 Ω, L1=1.80 H, L2=3.90 H, and V=5.0 V. At time…

Q: A 240V three phase power system supplies two loads in parallel: Load 1: measured line current 30A,…

Q: A vertically oriented square loop of copper wire falls from rest in a region in which the field B is…

A: For the given wire of some material, having length L and cross-section area A, its resistance R is…

Q: (Figure 1) shows a 11-cm-diameter loop in three different magnetic fields. The loop's resistance is…

Q: A 0.160-A current is charging a capacitor that has circular plates 14.2 cm in radius. The plate…

Q: 3) Figure shows a RL circuit and a conducting rod. RL circuit has ɛ = 40 V, R = 5 2, and the time…

A: Battery voltage= 40 V Resistance= 5 ohm Time constant = 1 s Length and value of r is unknown.

Q: in the figure below, a square loop with 10 turns that is 10.0 cm on a side has a magnetic field…

Q: current increasing at its fastest rate? b. At what angle, or angles is the voltage / current…

A: Q .1 .a solution ..... for calculating rate of fastest increase for a sinusoidal voltage or current…

Q: The drawing shows a straight wire carrying a current I. Above the wire is a rectangular loop that…

Q: An ac electrical generator is made by turning a flat coil in a uniform constant magnetic field of…

Q: 3) A square loop circuit (with a 30.0 V battery, resistance of 6.00 ohms and side length of 2.00 m)…

A: Given data: e.m.f of the battery, ε=30.0 V

Q: Q 2. In the fra, shown below. Resolve the fore l00lb into faio Components one abng AB and the other…

Q: 20 cm х| 20 сm ww 10 Ω a X X X X X X X X

A: Area of loop = 20cm×20cm = 0.2m×0.2m Resistance (R)= 10 ohm Magnetic field…

Q: 3) Figure shows a RL circuit and a conducting rod. RL circuit has ɛ = 35 V, R = 7 2, and the time…

Q: In the following circuit E =10 V, R=5 N and C=4 µF. The capacitor is initially uncharged. The switch…

Q: A rectangular circuit containing a resistance R is pulled at a constant velocity v → away from a…

A: Write the expression for induced EMF in the circuit in the terms of rate of change of flux. The…

Q: (Figure 1) shows a circuit with an area of 0.070 m? containing a R = 1.0 2 resistor and a C = 230 µF…

Q: 3613 In the eircuit shown in the figure, the switch S has been at position a for a long time, and…

Q: In the figure, a wire loop formed from 0.1 cm radius copper wire with side lengths of 20 cm x 80 cm.…

A: When an electrical conductor is placed into a magnetic field, emf is produced in it due to its…

Q: A 36.0 cm diameter loop of wire is initially oriented perpendicular to a 1.8 T magnetic field. The…

A: Given that, Diameter = 36.0 cm Magnetic field = 1.8 T Time = 0.40 s

Q: A thin metal bar of 50.0 cm and a mass of 750 g rests on two metal supports. These supports are…

Question

For the circuit in the figure, at t = 0 the switch S is
closed with the capacitor uncharged. If C = 55 µF, ɛ =
80V, and R = 4 kN, what is the charge (in mC) on the
capacitor when the current in the circuit is = 3.5 mA?
S
R
+
Select one:
O A. 5.67
ОВ. 4.15
OC. 5.17
O D. 3.63
E. 2.48

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

in the circuit shown in the figure, the S switch is closed at t=0 and the capasitors, which are completely empty, begin to fill. Here E=30V, C=3 uF and R=40 ohm. A) what is the time constant of the circuit, T, in the units of microseconds? B)when t=T, what is the total charge, in units of microcoulomb?
Find the steady-state current in the RLC-circuit in Fig. 61 for the given data. Show the details of your work. R= 40,L=05H,C =0.1F,E =S500sin2rV c Bit) = Ky aim oot Fig. 61. RLC-circulit
How do you solve this question? The first question's answer is c) 3.0 T but I can't seem to get the right answer if I attempt use the equation emf = (BA)/t. Is t 1.25, 5, or something else?
A wire 2 m long moves perpendicular through a 0.08 T field at a speed of 7 m/s. What EMF is induced? Knowing Ohm's law and that the wire has a resistance of 0.50 ohms, what current flows?
The capacitor in the circuit shown below is initially uncharged. The switch is closed at t = 0 s. ΔVbattery = 60 V, C = 2.0 F, and R = 3.0 Ω. What is the current in the circuit at t = 5.2 s, in Ampere?
To get the maximum current, the connection should be in parallel. If you create a parallel connection with 30V DC source and three resistors with R1 = 50Ω, R2 = 75Ω, and R3 = 100Ω, how do you calculate for the total current (IT) and the current flowing in each resistor (I1, I2, I3), and the total voltage (VT) and the voltage across each resistor (V1, V2, V3)? How do you also determine the power dissipated by each resistor (P1, P2, P3) and by the whole circuit (PT)??
The switch shown has been in position a for a long time. It is changed to position b at t = 0 s. What are the charge Q on the capacitor and the current I through the resistor (a) immediately after the switch is changed? (b) At t = 50 ms? (c) At t = 200 μs?
What is the energy density at the center of a circular loop of wire carrying a 26.0 A current if the radius of the loop is 20.0 cm ? How many turns of wire would be required to make a 110 mH inductance out of a 28.0 cm -long air-filled coil with a diameter of 5.0 cm ?
In the circuit below, the switch has been in the open position for a long time. At t=0, the switch is turned on. If the current at time t=3.3 ms reaches half of its maximum value, L=68 mH, and ℰ=17 V, find:the time constant τ= ms,the resistance R= Ω,the maximum value of the current, Imax= A.If the switch is open again, after what time, the current will reach the half of its value?t1/2= ms.
Consider the RL circuit in the figure with R=10.00 Ω, L1=1.80 H, L2=3.90 H, and V=5.0 V. At time t=0, the switch is closed to connect the circuit to a constant emf. How long (in seconds) does it take for the current to reach a value of Imax/2.71828 of its maximum value, where Imax is the maximum current through the circuit?
When an electric current is maintained in an electrolytic cell of slightly acidic water and 1 mole of water is electrolyzed in to hydrogen and oxygen, two faradays of charge are transferred through a source of emf (E). The energy change of the system is +286500 J and 50,000 J of heat is absorbed. Calculate the emf (E) ? Given 1 Faraday = 96500 C/mol.?
I already tried 0.08*60*600 = 2880 W and it stated that it was incorrect. I'm not sure why.