From the following identify a true statement regarding the adjustment of drive belt tension. a. Less than 8 mm should be the correct a deflection for each belt which is under tension b. More than 6 mm should be the correct a deflection for each belt which is under tension c. More than 8 mm should be the correct a deflection for each belt which is under tension. d. More than 6 mm and less than 8 mm should be the correct a deflection for each belt which is under tension.

From the following identify a true statement regarding the adjustment of drive belt tension. a. Less than 8 mm should be the correct a deflection for each belt which is under tension b. More than 6 mm should be the correct a deflection for each belt which is under tension c. More than 8 mm should be the correct a deflection for each belt which is under tension. d. More than 6 mm and less than 8 mm should be the correct a deflection for each belt which is under tension.

Automotive Technology: A Systems Approach (MindTap Course List)

6th Edition

ISBN:9781133612315

Author:Jack Erjavec, Rob Thompson

Publisher:Jack Erjavec, Rob Thompson

Chapter43: Automatic Transmission And Transaxle Service

Section: Chapter Questions

Problem 6RQ: Which of the following is the most likely cause for a shudder during the engagement of a lock-up...

See similar textbooks

Similar questions

Which of the following is the most likely cause for a shudder during the engagement of a lock-up torque converter? a. A bad converter b. Worn or damaged CV or U-joints c. A worn front planetary gearset d. Loose flexplate
Which of following mechanical drives working due to friction? a)Flat belt drives b)Chain drives c)Timing belt drives d)Worm gear drives e)Spur gear drives
Choose the correct device pair from the following which is a common example for lower pair and self-closed pair. a. Roller and rings of bearing. b. Cam and follower. c. Gear mesh with another gear. d. Nut and bolt.
The minimum life of the bearing is the life which 90% of the bearings will reach or exceed before fatigue failure. Select one: True False
30. Which of the following is NOT a spring type used in pressure plate assemblies?A. Belleville B. CoilC. Diaphragm D. Torsional
The oscillating link in four bar chain mechanism is known as a. crank. b. frame. c. follower. d. connecting rod.
How do you select a shaft for small sprocket in your chain drive?
choose true or false :1. The chain drive transmits more power as compared to belt drive.
What are two reasons for using an air spring?
All of the following are functions of the flywheel, except it ____ . a. provides a mounting place for the clutch assembly b. smooths out cylinder firing pulsations c. has marks used to set the valve timing d. meshes with the starter drive gear
True or False? Many armature bearings are held in the case by a retainer, whereas bushings are typically pressed out and into their bore.
While discussing the different types of pressure plates: Technician A says that coil spring types are commonly used because they have strong springs. Technician B says that Belleville-type pressure plates are not commonly used because they require excessive space in the bell housing. Who is correct? a. Technician A only b. Technician B only c. Both A and B d. Neither A nor B