Gaseous mixture: 0.943 g air (0.006846 mol O2 and 0.025754 mol N2) 0.0641 g gas (5.05 x 10^-4 mol isooctane and 1.39 x 10^-4 mol ethanol) In “the intake stroke”, the air/C8H18 gaseous mixture in Question 3 is transferred into the cylinder, where the piston reaches the bottom of the cylinder. Assume the gas mixture an ideal gas behavior, the temperature of cylinder is 212 oF, and the total pressure of gas mixture is 1.00 atm, Calculate moles of C8H18, O2 and the total moles of air/fuel mixture?

Gaseous mixture: 0.943 g air (0.006846 mol O2 and 0.025754 mol N2) 0.0641 g gas (5.05 x 10^-4 mol isooctane and 1.39 x 10^-4 mol ethanol) In “the intake stroke”, the air/C8H18 gaseous mixture in Question 3 is transferred into the cylinder, where the piston reaches the bottom of the cylinder. Assume the gas mixture an ideal gas behavior, the temperature of cylinder is 212 oF, and the total pressure of gas mixture is 1.00 atm, Calculate moles of C8H18, O2 and the total moles of air/fuel mixture?

Introduction to General, Organic and Biochemistry

11th Edition

ISBN:9781285869759

Author:Frederick A. Bettelheim, William H. Brown, Mary K. Campbell, Shawn O. Farrell, Omar Torres

Publisher:Frederick A. Bettelheim, William H. Brown, Mary K. Campbell, Shawn O. Farrell, Omar Torres

Chapter5: Gases, Liquids, And Solids

Section: Chapter Questions

Problem 5.32P

See similar textbooks

Similar questions

To evaluate the use of renewable resources, an experiment was carried out with rice hulls. After pyrolysis, the product gas analyzed 6.4% CO2, 0.1% O2, 39% CO, 51.8% H2, 0.6% CH4, and 2.1% N2. It entered a combustion chamber at 90 °F and a pressure of 35.0 in. Hg and was burned with 40% excess air (dry) at 70 °F and an atmospheric pressure of 29.4 in. Hg; 10% of the CO remains. a. How many cubic feet of air were supplied per cubic foot of entering gas? b. How many cubic feet of product gas were produced per cubic foot of entering gas if the exit gas was at 29.4 in. Hg and 400 °F?
Urea (H2NCONH2) is used extensively as a nitrogen source in fertilizers. It is produced commercially from the reaction of ammonia and carbon dioxide: 2NH3(g)+CO2(g)----heat----> H2NCONH2(s) + H2O(g) Ammonia gas at 223°C and 90 atm flows into a reactor at a rate of 500 L/min. Carbon dioxide at 223°C and 45 atm flows into the reactor at a rate of 600 L/min. What mass of Urea is produced per minute by this reaction assuming 100% yield.
A gaseous fuel has the following composition of volume: H2 = 24%; CH4 = 30%; C2H6 = 11%; C2H4 = 4.5%; C4H8 = 2.5%; CO = 6%; CO2 = 8%; O2 = 2%; and N2 = 12% Calculate (a) air to fuel ratio and (b) volume of dry products of combustion using 40% excess air.
The label has come off a cylinder of gas in your laboratory. You know only that one species of gas is contained in the cylinder, but you do not know whether it is hydrogen, oxygen, or nitrogen. To find out, you evacuate a 5-liter flask, seal it and weigh it, then let gas from the cylinder flow into it until the gauge pressure equals 1.00 atm. The flask is reweighed, and the mass of the added gas is found to be 13.0 g. Room temperature is 27°C, and barometric pressure is 1.00 atm. What is the gas?
One type of gas mixture used in anesthesiologyis a 50%/50% mixture (by volume) of nitrous oxide (N2O) and oxygen(O2), which can be premixed and kept in a cylinder for later use.Because these two gases don’t react chemically at or below 2000 psi, attypical room temperatures they form a homogeneous single gas phase,which can be considered an ideal gas. If the temperature drops below-6C, however, N2O may begin to condense out of the gas phase. Thenany gas removed from the cylinder will initially be nearly pure O2; asthe cylinder empties, the proportion of O2 will decrease until the gascoming from the cylinder is nearly pure N2O. In a hospital, pure oxygen may be delivered at 50 psi (gaugepressure) and then mixed with N2O. What volume of oxygen at 20Cand 50 psi (gauge pressure) should be mixed with 1.7 kg of N2O toget a 50%/50% mixture by volume at 20C? (a) 0.21 m3; (b) 0.27 m3;(c) 1.9 m3; (d) 100 m3
One type of gas mixture used in anesthesiologyis a 50%/50% mixture (by volume) of nitrous oxide (N2O) and oxygen(O2), which can be premixed and kept in a cylinder for later use.Because these two gases don’t react chemically at or below 2000 psi, attypical room temperatures they form a homogeneous single gas phase,which can be considered an ideal gas. If the temperature drops below-6C, however, N2O may begin to condense out of the gas phase. Thenany gas removed from the cylinder will initially be nearly pure O2; asthe cylinder empties, the proportion of O2 will decrease until the gascoming from the cylinder is nearly pure N2O. In another test, the valve of a 500 L cylinder full of the gas mixture at 2000 psi (gauge pressure) is opened wide so that the gas rushes out of the cylinder very rapidly. Why might some N2O condense during this process? (a) This is an isochoric process in which the pressure decreases, so the temperature also decreases. (b) Because of the rapid expansion, heat is…
1) Mass of flask, aluminum foil, and rubber band 68.45g 2) Temp. Of boiling, water 98.20 0C 3) Barometric pressure 755 mmHg 4) Volume of flask (volume of vapor occupies flask) 152 ml 5) Mass of flask, aluminum foil, rubber band, and condensed vapor 68.60g 6) Mass of condensed vapor is (5)-(1) Find Molecular weight of unknown ______ g / mol Calculation PV = (m/M)RT) è M = (mRT) / PV = ? Unknown liquid- Based on Molecular weight determine which unknown below has this molecular weight: Methanol, Ethanol, Isopropanol, Propanol. UNKNOW IS : __________________________
What is the Molecular weight of a certain volatile liquid which is placed in 225 g flask which has total capacity volume of 251.07 ml where after the liquid was heated to 94.5 oC, the gas volatilized and the weight of the flask measured 227.08g.? Round you answer in one decimal place
The density of NO2 IN A 4.50L tank at 760torr and 25.0c I'd blank g/l
Gypsum (plaster of Paris : CaSO,. 2H,0) is produced by the reaction of calcium carbonate and sulfuric acid. A certain lime stone analyzes: CaCO, 96.89 %; MgCO, 1.41 %; inerts 1.70 %. For 5 metric tons of limestone reacted completely, determine: a. kg of anhydrous gypsum (CaSO,) produced. b. kg of sulfuric acid solution (98 wt%) required.
Is it necessary to know [E]T to determine (a) KM, (b) Vmax, or (c) kcat?
Oxyacetylene torches rely on a precise mixture of fuel (C2H2(g)) to oxygen to optimize the welding process.Calculate the volume of O2(g) required to react completely with 15.1 L of acetylene. Assume both substances are at SATP. Hint: Balance the combustion reaction first.Do not show your work in the space provided.Record only your final answer with the correct number of significant digits and the proper units.