Given: A uniform slender rod is at rest upon a frictionless horizontal surface when a force (F) is applied in the direction shown. Assume that the rod has mass m and length L. L Horizontal Plane Given that F- 74lb, L- 7.1ft, mg- 4.6lh, and - 73deg What is the component of acceleration of the mass at point G in the i direction? Answer: Check What is the component of acceleration of the mass at point G in the j direction? Answer: Check What is the component of angular acceleration of the mass in the k direction? (remember your signs)

Given: A uniform slender rod is at rest upon a frictionless horizontal surface when a force (F) is applied in the direction shown. Assume that the rod has mass m and length L. L Horizontal Plane Given that F- 74lb, L- 7.1ft, mg- 4.6lh, and - 73deg What is the component of acceleration of the mass at point G in the i direction? Answer: Check What is the component of acceleration of the mass at point G in the j direction? Answer: Check What is the component of angular acceleration of the mass in the k direction? (remember your signs)

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Please answer this NEATLY, COMPLETELY, and CORRECTLY for an UPVOTE. The wooden block (mass m = 0.5358 kg) is released from rest at A by a compressed spring (compressed length 0.6 m, undeformed length 1 m, spring constant k = 150 N/m). The block is allowed to slide through the rough horizontal surface (A to B), then along the smooth circular ramp (B to C, central angle θ = 47.2°, until the block is released after point C. Calculate the speed of the block at points B and C. Also, what is the magnitude of the normal force exerted to the block just before the block leaves the ramp? Neglect the geometry of the block. NOTE: Use Work-Energy Method to solve for the speeds; use Force-Mass-Acceleration (FMA) Method to compute for the normal force.
Blocks A and B shown in the figure have masses of 5 kg and 10 kg respectively.If the pulley is treated as a 3 kg solid disk with a 15 cm radius, determine the acceleration of the block A. Disregard the rope mass and any slip on the pulley.Consider that the moment of inertia of the pulley is given by Ip = (1/2)mr² in which m is the mass of the pulley and r is of radius the pulley.
A small 0.18 kg metal ball is tied to a very light (essentially massless) string that is 0.60 m long. The string is attached to the ceiling so as to form a pendulum. The pendulum is set into motion by releasing it from rest at an angle of 50 degrees with the vertical. I solved that the speed of the ball when it reaches the bottom of the arc is 2.0 m/s and the tension of the string is 3.0 N What is the centripetal acceleration of the ball at this point?
A weight with mass mw=150 g is tied to a piece of thread wrapped around a spool, which is suspended in such a way that it can rotate freely. When the weight is released, it accelerates toward the floor as the thread unwinds. Assume that the spool can be treated as a uniform solid cylinder of radius R=4.00 cm and mass Ms=200 g. Find the magnitude ?a of the acceleration of the weight as it descends. Assume the thread has negligible mass and does not slip or stretch as it unwinds. Use ?=9.81 m/s2. Find the tension T in the thread.
A solid cylinder (r= 4cm) goes down a ramp at a declination of 20°. The longitude of the ramp is 75 cm and 20 cm high. On average, the cylinder takes 1.25 s to go down the ramp. Without specifying the value of the mass determineWhat is the acceleration of the center of mass?What is the angular acceleration of the object?What is the moment of inertia of the object?What is the value of the radius of gyration?
A plank with a mass M = 6.00 kg rests on top of two identical, solid, cylindrical rollers that have R = 5.00 cm and m = 2.00 kg. The plank is pulled by a constant horizontal force Fs of magnitude 6.00 N applied to the end of the plank and perpendicular to the axes of the cylinders (which are parallel). The cylinders roll without slipping on a flat surface. There is also no slipping between the cylinders and the plank. a. Find the initial acceleration of the plank at the moment the rollers are equidistant from the ends of the plank. b. Find the acceleration of the rollers at this moment. c. What friction forces are acting at this moment?
a=22mist 16w/ Figure Q) “The mass of ahuckey puck 0.80Kg slides on horizontal, frictionless surface of an ice rink. If two hockey sticks srike the puck simulaneously, exerting the acceleration of the puck shown n figure 2. Determine both the magnitude and the direction of the puck’s forces?
Mason is is trying to keep a door open using a door stopper. That door is solid, and it has a mass of 18.3kg. The door closer is connected 26.2cm away from the hinge, and pulls with a force of 123N. The door stopper provides a static friction force of 13.2N, and a kinetic friction force off 11.8N. Find the angular acceleration (as a vector) of the door.
A hanging mass, M1 = 0.5 kg, is attached by a light string that runs over a frictionless pulley to a mass M2 = 1.5 kg that is initially at rest on a frictionless ramp. The ramp is at an angle of θ = 30.0° above the horizontal and the pulley is at the top of the ramp. Find the magnitude and direction of the acceleration of M1. a. 4.905 m/s2 , upward c. 4.905 m/s2 , upward b. 4.805 m/s2 , downward d. 4.805 m/s2 , downward
Q2: An automobile with mass of 700 Kg goes around a 500 m-radius curve at a constant speed of SO Km/h. if the road is not banked, what frictional force must the road exert on the ties so that they will ‘maintain motion along the curve?
A drum of mass Ma and radius a rotates freely withinitial angular velocity ωa0. A second drum with mass Mb and radiusb > a is mounted on the same axis and is at rest, although it is free torotate. A thin layer of sand with mass Ms is distributed on the innersurface of the smaller drum. At t = 0, small holes in the inner drumare opened. The sand starts to fly out at a constant rate λ = dm/dtand sticks to the outer drum. (a) Explain, in detail, why the angularvelocity of the inner drum will remain constant. (b) Determine theangular velocity of the outer drum ωb(t). Ignore the transit time ofthe sand
Dancers experience large forces associatedwith the jumps they make. For example, when a dancer landsafter a vertical jump, the force exerted on the head by the neck mustexceed the head’s weight by enough to cause the head to slow down andcome to rest. The head is about 9.4% of a typical person’s mass. Videoanalysis of a 65 kg dancer landing after a vertical jump shows that herhead decelerates from 4.0 m>s to rest in a time of 0.20 s. Compared with the force her neck exerts on her head during the landing, the force her head exerts on her neck is (a) the same; (b) greater; (c) smaller; (d) greater during the first half of the landing and smaller during the second half of the landing.