I need the answer for a-c 1. Given:Atomic no. 51, mass no. 122Predict the followinga. Electron configuration using the long spdf.b. Electron configuration using the abbreviated spdf h. no. of sublevelsc. Electron configuration using the orbital diagramd. No. of protons.e. No. of electrons.f. No. of neutronsg. main energy leveli, no. of occupied orbitalsJ. no. of unpaired electronsK. nature

Atomic no. of the element is 51. Mass no. 122

Given: Atomic no. 51, mass no. 122 Predict the following a. Electron configuration using the long spdf. b. Electron configuration using the abbreviated spdf c. Electron configuration using the orbital diagram

Given: Atomic no. 51, mass no. 122 Predict the following a. Electron configuration using the long spdf. b. Electron configuration using the abbreviated spdf c. Electron configuration using the orbital diagram

Chemistry: The Molecular Science

5th Edition

ISBN:9781285199047

Author:John W. Moore, Conrad L. Stanitski

Publisher:John W. Moore, Conrad L. Stanitski

Chapter5: Electron Configurations And The Periodic Table

Section: Chapter Questions

Problem 113QRT

See similar textbooks

Related questions

Q: Question attached

A: Whenever a solute is dissolved in a solvent, it will cause a change in the boiling point and freezin...

Q: P3C.7 The compound 1,3,5-trichloro-2,4,6-trifluorobenzene is an intermediate in the conversion of he...

A: An intermediate compound whose thermodynamic properties is measured with the help of following table...

Q: A sheet of steel with 100cm2 area has nitrogen(N2) atmospheres on both sides and is permitted to ach...

A: Explanation: According to Ficks first law of diffusion, Flow rate is directly proportional to concen...

Q: Membrane separation process has been extensively applied in various fields including petrochemical i...

A: Membrane separation process is a method of separating the mixture of components by making them flow ...

Q: Use the Clapeyron equation to estimate the slope of the solid-liquid phase boundary of water on a pr...

A: Given: The enthalpy of the fusion,∆Hf = 6.008 KJ/mol Temperature of the fusion, Tf = 273.15 K Densit...

Q: Water is pumped from the river through a 40-mm-diameter hose having a length of 3 m . The friction f...

Q: Describe, with the aid of diagrams, the concentration profiles for equimolar-diffusion and diffusion...

A: Diffusion through a stationary phase Consider the diffusion in an Arnold diffusion cell. The narrow...

Q: A 1200 L vessel contains 85 gmol of nitrogen. The vessel can withstand 25 kPa above atmospheric pres...

A: Given, Volume of Vessel V = 1200 L = 1200 × 10-3 m3 Mass of Nitrogen m = 85 gmol Maximum Pressure o...

Q: Analysis of a hydrolysis reaction occurring in a dilute aqueous solutionof sucrose shows that 80 gra...

A: Concentration of sucrose after 10 h = 80 g Initial concentrations of sucrose solution = 100 g

Q: An aluminum beam wasbrought from the outside cold into a machine shop where the temperature was held...

A: Given: The temperature at the machine stop i.e. surrounding temperature is Ts = 65oF At time t = 0, ...

Q: Assume that a sample of air at 25oC and containing S02 gos at a concentration equal to the AAQS is r...

A: Given data: Initial temperature of air sample = 25 0C Final temperature of air sample = 150 0C The u...

Q: 2) For 30 kg of seeds contains 27% oil, the amount of solution is (a) 0 kg (b) 27 kg (c) 8.1 kg

A: Given data: --> 30 kg of seeds --> seeds contain 27% oil Find the amount of solution

Q: The standard reaction enthalpy of Zn(s) + H2O(g) → ZnO(s) + H2(g) is approximately constant at +224 ...

A: Given data: Standard enthalpy of reaction between temperature of 920 K to 1280 K = 224 kJ/mol Standa...

Q: A 20-cm diameter copper ball is to be heated from 110°C to an average temperature of 170°C in 90 min...

A: Given that, Diameter of the sphere D = 20 cm = 0.2 m Initial temperature T1 = 110oC Final temperatur...

Q: Refrigerant-134a enters an adiabatic compressor as saturated vapor at −24°C and leaves at 0.8 MPa an...

Q: Explain why you dont need to know the volume of the mixture to calculate the equilibrium constant k.

A: Equilibrium constant often termed as KC or Keq is used to determine equilibrium composition of the c...

Q: Its use allows lower kiln temperatures in Portland cement manufacturing Hydrates rapidly,Most Portla...

A: (A) Cement consists of Tricalcium silicate (3CaO.SiO2) [C3S],Dicalcium silicate (2CaO.SiO2) [C2S],Tr...

Q: 1. Isothermal process is the best for production of maximum work for all working fluids. False True ...

A: (1) work done for the process can be explained by the area under the curve of Pressure-Volume diagra...

Q: A). Determine the critical length of duct Lmax where the flow becomes choked. Express your answer to...

A: Given: Room temperature is 24°C Absolute pressure is 101 kPa Duct diameter is 200 mm (0.2 m) Absolut...

Q: What are the six types of typical tower packings?

A: Packing inside the bed increases mass transfer rate by providing contact area. Packing amplify the p...

Q: what would happen if the three volunteers of Chernobyl did not drain the pool underneath the reactor...

A: Introduction The Chernobyl disaster was a nuclear accident that occurred in April 1986, at the No. ...

Q: Calculate the polydispersity index of a polymer than consisting of following molecular weights of ch...

A: Given data: Molecular weight and chain number of a polymer is given.

Q: In the ‘gas saturation method’ for the measurement of vapour pressure, a volume V of gas at temperat...

A: Given There is gas saturation method’ Volume -V Temperature -T Pressure -P Mass m For part d) M...

Q: Q2: Liquor solution containing 15 percent solids is concentrated to 55 percent solids in a double ef...

Q: Prism gas permeation

A: Prism gas permeation process or separation by gas permeation is a membrane based system. Fluids or v...

Q: In industrial process engineering, mixing is a unit operation that makes a heterogeneous mixture int...

A: Mixing : Mixing is a unit operation in which two or more components are treated in such a way to mak...

Q: In the lower troposphere, ozone is one of the components of photochemical smog. It is generated in a...

A: Given data: Value of rate constant k1 = 6 × 10–3 s–1 Value of rate constant k2 = 1 × 106 L/mol.s Con...

Q: the number of theoretical stages needed

A: In mass transfer, an extraction process is carried out to separate the solute particles and solvent ...

Q: In crystallization mechanism

A: Crystallization is a process in which mass transfer of a solute from the liquid solution to be form ...

Q: A system goes from state 1 to state 2 and back to state 1.Without further information, can you concl...

A: We are only given that a system goes from state 1 to state 2 and then back to state 1. We are asked ...

Q: pressre-composition diagram

A: Vapor - Liquid Equilibrium is the graphical representation of distribution of molecules between vap...

Q: The refractive index of CH2I2 is 1.732 for 656 nm light. Its mass density at 20 °C is 3.32 g cm−3. C...

A: Given: The refractive index of CH2I2 is η = 1.732 The molecular weight of CH2I2 is M.W. = 267.84 The...

Q: At the summit of Kilimanjaro, the highest mountain in Africa with an elevation of 5,895 m, the parti...

A: The partial pressure of the oxygen at the elevation of 5895 m, PO2=78.5 mmHg Write the expression fo...

Q: Why LDPE is used in plastic bags and insulation ?

A: Low density polyethylene (LDPE) is widely used as plastics bags, bin bags and as insulation materia...

Q: A piston cylinder device contains 500 g saturated water vapor at 125 kPa. The process is such that P...

A: Given: PV2.394=constant Amount of water is 500 g (0.5 kg) P1 is 125 kPa P2 is 300 kPa Assume initial...

Q: 3. Two mixtures are mixed in a mixing unit. First mixture containing 50 wt% benzene and 50 wt% tolue...

Q: 4. The structure of caffeine is given below: CH3 H3C. CH ČH3 a. What is the molecular formula and mo...

Q: The rate of the elementary reaction Ar + O2 → Ar + 0 + O has been studied as a function of temperatu...

A: (a) The activation energy for the given data is to be calculated.

Q: a) A compressed liquid feed stream containing an equimolar mixture of n-butane and isobutene flows i...

A: Given data: Flash pressure = 1 bar Mixture is equimolar.

Q: You are asked to design a steel tank in which CO2 will be stored at 300 K. The tank is 30 ms and is ...

Q: What is Pasteurization

A: Pasteurization is the partial sterilization of a product to make it safe for consumption and improve...

Q: Also, what is the pressure at A? Express your answer to three significant figures and include the ap...

A: Given: Water temperature is 20 °C Diameter of pipe is 50 mm (0.05 m) Mass flow rate is 5.88 kg/s Le...

Q: A hot solution containing 1000 kg of MgSO, and water having a concentration of 30 wt % MgSO, is cool...

Q: 6) 1.6 kg /s of sand-salt mixture containing 62.5% sand is leached in a counter current unit, the am...

Q: A 300-mm-diameter pipe transports nitrogen at M = 0.85. The absolute pressure is 160 kPa and the tem...

Q: One hundred kmol/h of liquid alcohols containing, by moles, 40% methanol (M), 35% ethanol (E), 15% i...

A: By figure (Given) Find The flow rates in kmol/h of each component in form of a table Purity of the...

Q: What is Langmuir isotherm?

A: The definition of Langmuir isotherm is to be mentioned.

Q: Solid ammonium chloride dissociates according to NH4Cl(s) → NH3(g) + HCl(g). The dissociation vapour...

Q: 6.154 Water at 20°C flows through the orifice in the figure, which is monitored by a mercury manomet...

A: An orifice meter is a device that is used to measure the flow rate of a fluid, either liquid or gas....

Q: 7. You are asked to design a steel tank in which CO, will be stored at 300 K. The tank is 30 m and i...

Question

I need the answer for a-c

1. Given:
Atomic no. 51, mass no. 122
Predict the following
a. Electron configuration using the long spdf.
b. Electron configuration using the abbreviated spdf h. no. of sublevels
c. Electron configuration using the orbital diagram
d. No. of protons.
e. No. of electrons.
f. No. of neutrons
g. main energy level
i, no. of occupied orbitals
J. no. of unpaired electrons
K. nature

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

What evidence do we have that energy levels in an atom are quantized? State and explain the evidence.
Suppose that the spin quantum number could have the values 12,0 and 12 . Assuming that the rules governing the values of the other quantum numbers and the order of filling sublevels were unchanged, (a) what would be the electron capacity of an s sublevel? a p sublevel? a d sublevel? (b) how many electrons could fit in the n=3 level? (c) what would be the electron configuration of the element with atomic number 8? 17?
Scientists use emission spectra to confirm the presence of an element in materials of unknown composition. Why is this possible?
Your text describes the probability map for an s orbital using an analogy to the earth’s atmosphere. Explain this analogy.
Explain in your own words what is meant by (a) the Pauli exclusion principle. (b) Hund's rule. (c) a line in an atomic spectrum. (d) the principal quantum number.
How does probability fit into the description of the atom?
The Heisenberg uncertainty principle can be expressed in the form Eth4 where E represents energy and t represents time. Show that the units for this form are the same as the units for the form used in this chapter: x(mv)h4
Give the symbol of the element of lowest atomic number whose ground state has (a) a completed f subshell. (b) twenty p electrons. (c) two 4d electrons. (d) five 5p electrons.
Consider the transition from the energy levels n=2 to n=5. (a) What is the wavelength associated with this transition? (b) In what spectral region does the transition occur? (c) Is energy absorbed?